Sharif Digital Repository

Surface and submerged fermentation methods were used to produce citric acid by Aspergillus niger using chemically defined media or cane molasses. Fermentation process parameters were optimized in pilot scale tower and tray fermenters. Fermentation was running from 10 - 20 days with pH controlled at 3 - 6.5. Citric acid concentrations varied from 60 - 100 g/L depending on the strain used, the substrate, the fermentation system and the general conditions under which fermentation took place (initial sugar concentration, aeration rate, inoculum size, pH and temperature). Some essential criteria such as lower process sensitivity to short interruptions or breakdowns in aeration, expenses for... 

The aim of this research work was to decolorize anaerobically digested (UASB) and aerobically treated distillery wastewater of a process for ethanol production. An Aspergillus species isolated from the soil was used for decolorization. A sequential Plackett-Burman design in three stages was used for optimization of decolorization conditions. Both maximum decolorization and COD reduction under optimized conditions were obtained as 84%. By implementing the optimum values in a pilot scale of an activated sludge system a continuous process for decolorization was conducted. The decolorization efficiency of this system with 48 h retention time was about 75% in a limited period of 4 days. For... 

The objective of this research work was to obtain a microorganism capable of decolorizing treated distillery wastewater (TDW). 21 isolated and procured microorganisms were screened for their percentage decolorization. The screening strategy was performed using three different culture media in two main steps. The primary screening was carried out in two stages. In the first stage 10 microorganisms had a lower than 25% decolorization of TDW (with 25% TDW concentration). In the second stage 8 microorganisms had more than a 48% decolorization of TDW. In the secondary screening all 3 different culture media, the effect of TDW concentration, pH and nitrogen source were studied. A fungus identified... 

This study was focused on the heavy metal (Ni, Co, Mo, V, Mn, Fe, W and Zn) tolerance of fungi strains Aspergillus niger, Aspergillus foetidus and Penicillium simplicissimum. Aspergillus niger was exposed to a mixture of Mo, V and Mn at a mass ratio of 1:2:6 as approximately present in the spent refinery processing catalyst. This study highlights the adaptation of fungi strains to Tungsten and Vanadium to high concentration. The effect of different metals and metal concentration on different strains of fungi was evaluated. Results showed that Ni was one of the most toxic metals for strains of Aspergillus and Penicillium. Aspergillus foetidus was the least tolerant, in particular for Ni, Co... 

The kinetics of bioleaching of Mo, Ni, and Al from spent hydrocracking catalyst, using Aspergillus niger was studied. The four most effective bioleaching variables were selected in accordance with the Plackett-Burman design and were further optimized via central composite design (CCD). The optimal values of the variables for maximum multi-metal bioleaching were as follows: particle size 150-212. μm, sucrose 93.8. g/L, pulp density 3%. w/v, and pH 7. The maximum metal recoveries corresponding to these conditions were 99.5 ± 0.4% Mo, 45.8 ± 1.2% Ni, and 13.9 ± 0.1% Al. The relatively low Ni extraction was attributed to the precipitation of Ni in the presence of oxalic acid. Under the optimal... 

In this study, the properties of poly (vinyl alcohol)(PVA) films incorporated with Zataria multiflora essential oil (ZMO) as a potential antioxidant/antibacterial material was investigated. PVA films were prepared from PVA solutions (2% w/v) containing different concentrations of ZMO. Water solubility, moisture absorption, water swelling, and water vapor permeability for pure PVA films were 57 ± 1.1, 99 ± 3.2%, 337 ± 8%, and 0.453 ± 0.015 g mm/m2 h, respectively. Incorporation of ZMO into PVA films caused a significant decrease in water swelling and moisture absorption and increase in solubility and water vapor permeability. Tensile strength, elastic modulus, and elongation at break for pure... 

In this investigation, bioleaching of vanadium from uranium ore residue of the leaching stage was studied by Aspergillus niger in a two-step process at 30 °C and 150 rpm. The first step was initiated by growth of fungi in the absence of mine waste. Using response surface methodology, three factors were surveyed for fungal growth: initial pH, sucrose concentration and spore population. Also concentrations of oxalic, citric, and gluconic acids were measured as response in this step. During 30 days, maximum productions of these acids were 3265, 11578, and 7988 mg/l, respectively. Initial pH and sucrose concentration were significant factors for oxalic and citric acid production; however, for... 

Fungal delignification can be considered as a feasible process to pre-treat lignocellulosic biomass in biofuel production, if its performance is improved in terms of efficiency thorough a few modifications. In this study, Trichoderma viride was utilized to investigate the effect of wet-milling, addition of surfactant (Tween 80) and optimization of operating factors such as temperature, biomass to liquid medium ratio and glucose concentration on biodelignification of rice straw. Next, the enzymatic hydrolysis of pretreated biomass was studied at various pretreatment times. Results revealed that the wet milling and addition of surfactant increases the lignin removal about 15% and 11%,... 

There is a substantial volume of mobile phone waste every year. Due to the disadvantages of traditional methods, it is necessary to look for biological processes that are more eco-friendly and economical to recover metals from e-waste. Fungi provide large amounts of organic acids and dissolve metals but using sucrose in the medium is not economical. In this paper, the main objective is to find a suitable alternative carbon substrate instead of sucrose for fungi bioleaching of Ni and Cu in printed circuit boards (PCBs) of mobile phones using Penicillium simplicissimum. Four kinds of carbon sources (including sucrose, cheese whey, sugar, and sugar cane molasses) were selected. Also, pH and... 

Mobile phones are known as the most widely used electronic instruments, and an enormous number of discarded mobile phones are generated. The present work used a pure culture of Penicillium simplicissimum in a bubble column bioreactor to extract Cu and Ni from mobile phone printed circuit boards (MPPCBs) waste. Molasses was used as an efficient carbon source to enhance bioleaching efficiency and increase the cost benefits. The adaptation phase was done at Erlenmeyer flasks to reach 40 g/L of MPPCBs powder. The most significant parameters, including the mass of MPPCBs powder, aeration, molasses concentration, and their interaction, were optimized in order to leach the maximum possible Cu and... 

Arbuscular mycorrhizal (AM) fungi are non-specific symbionts developing mutual and beneficial symbiosis with most terrestrial plants. Because of the obligatory nature of the symbiosis, the presence of the host plant during the onset and proceeding of symbiosis is necessary. However, AM fungal spores are able to germinate in the absence of the host plant. The fungi detect the presence of the host plant through some signal communications. Among the signal molecules, which can affect mycorrhizal symbiosis are plant hormones, which may positively or adversely affect the symbiosis. In this review article, some of the most recent findings regarding the signaling effects of plant hormones, on... 

The ability of Paraconiothyrium variabile, a laccase producing ascomycete recently isolated from soil, was studied to eliminate chlorophenol derivatives in submerged culture medium. Among the tested compounds, ρ-chlorophenol (ρ-CP) and pentachlorophenol (PCP) were found to have minimum and maximum toxic effects, respectively, on the growth of the microorganism and at the same time high and low bioelimination percentages. The fungal strain was able to remove 86% of ρ-CP (with initial concentration of 40mgl -1) and 56% of 2,4-dichlorophenol (2,4-DCP; with same concentration as ρ-CP) after 9 days of incubation while no elimination was observed in the presence of 2,4,6-trichlorophenol... 

Adaptation of Penicillium simplicissimum with different heavy metals present in a spent hydrocracking catalyst, as well as one-step, two-step, and spent medium bioleaching of the spent catalyst by the adapted fungus, was examined in batch cultures. Adaptation experiments with the single metal ions Ni, Mo, Fe, and W showed that the fungus could tolerate up to 1500. mg/L Ni, 8000. mg/L Mo, 3000. mg/L Fe, and 8000. mg/L W. In the presence of multi-metals, the fungus was able to tolerate up to 300. mg/L Ni, 200. mg/L Mo, 150. mg/L Fe and 2500. mg/L W. A total of 3% (w/v) spent catalyst generally gave the maximum extraction yields in the two-step bioleaching process (100% of W, 100% of Fe, 92.7%... 

Statistically based experimental designs were applied to screen and optimize the bioleaching of spent hydrocracking catalyst by Penicillium simplicissimum. Eleven factors were examined for their significance on bioleaching using a Plackett-Burman factorial design. Four significant variables (pulp density, sucrose, NaNO3, and yeast extract concentrations) were selected for the optimization studies. The combined effect of these variables on metal bioleaching was studied using a central composite design (CCD). Second-order polynomials were established to identify the relationship between the recovery percent of the metals and the four significant variables. The optimal values of the variables... 

Laccase production by indigenous fungus, Phanerochaete chrysosporium, requires solving optimal problems to determine the maximum production of the enzyme within a definite time period and conditions specified in the solid-state fermentation process. For this purpose, parallel to response surface methodology, an analytical approach has been proposed based on the advanced concepts of Poisson geometry and Lie groups, which lead to a system of the Hamiltonian equations. Despite the dating of the Hamiltonian approach to solving biological problems, the novelty of this paper is based on the expression of a Hamiltonian system in notions of Poisson geometry, Lie algebras and symmetry groups and... 

Sulfur quantum dots (SQDs) were fabricated using a facile hydrothermal method and used for the preparation of functional food packaging film and compared the properties with other sulfur-based fillers like elemental sulfur (ES) and sulfur nanoparticles (SNP). The SQDs have an average size of 5.3 nm and were very stable in aqueous suspension. Unlike other sulfur-based fillers, the SQD showed high antioxidant, antibacterial and antifungal activity, but no cytotoxicity was found for L929 mouse fibroblasts even after long-term exposure of 48 h. When sulfur-based fillers were added to the alginate film, SQD was more evenly dispersed in the polymer matrix than SNP and ES. The addition of SQD to... 

Introduction: In recent years, the use of cost-effective, multifunctional, environmentally friendly and simple prepared nanomaterials/nanoparticles have been emerged considerably. In this manner, different synthesizing methods were reported and optimized, but there is still lack of a comprehensive method with multifunctional properties. Materials and Methods: In this study, we aim to synthesis the copper oxide nanoparticles using Achillea millefolium leaf extracts for the first time. Catalytic activity was investigated by in situ azide alkyne cycloaddition click and also A3 coupling reaction, and optimized in terms of temperature, solvent, and time of the reaction. Furthermore, the...