Sharif Digital Repository

Over 200 million motorcycles in use worldwide account for a substantial portion of global mobile source total hydrocarbons (THC) and carbon monoxide (CO) emissions. In Tehran, capital of Iran, ultrarich inefficient combustion in gasoline-fueled motorcycles results in significantly high CO and THC emissions. Motorcycle catalysts can reduce CO and C3H6(as a representative hydrocarbon) emission factors by 60-80%. In the present work, CO and propylene oxidation over a commercial Pt-Pd-based wiremesh catalyst is studied in a flow reactor setup under simulated conditions relevant to 125 cc four-stroke gasoline carburetor motorcycles. Steady-state individual and co-oxidation tests for CO and... 

Urban transportation is one of the leading causes of air pollution in big cities. In-use emissions of vehicles are higher than the emission control certification levels. The current study uses a roadside remote sensing emission monitoring campaign to investigate (a) fraction of high emitters in the light-duty vehicle (LDV) fleet and their contributions to the total emissions, (b) emission inspection (I/M) programs' effectiveness, and (c) alternate fuel (natural gas) encouragement policy. LDVs consist of passenger or freight transport vehicles with four wheels equivalent to classes M1 and N1 of European union vehicle classifications. The motivation is to assess the current emission inspection... 

In the present study the fuel spray of a gasoline direct injected engine with multi-hole injector is simulated. Simulation inputs data, injection flow rate and spray cone angle are obtained from previous experimental studies. Log-normal distribution with different standard deviation is used for initial droplet size as the primary break-up model in order to reach the agreement between experimental and calculated spray tip penetration. As the first step, only one plume of spray injected into a quiescent air environment is simulated and validated by varying break-up model and standard deviation. Then, with coefficient obtained from the single jet simulation all six spray jets are simulated... 

Land use regression (LUR) has not been applied thus far to ambient alkylbenzenes in highly polluted megacities. We advanced LUR models for benzene, toluene, ethylbenzene, p-xylene, m-xylene, o-xylene (BTEX), and total BTEX using measurement based estimates of annual means at 179 sites in Tehran megacity, Iran. Overall, 520 predictors were evaluated, such as The Weather Research and Forecasting Model meteorology predictions, emission inventory, and several new others. The final models with R2 values ranging from 0.64 for p-xylene to 0.70 for benzene were mainly driven by traffic-related variables but the proximity to sewage treatment plants was present in all models indicating a major local... 

Homogeneous charge compression ignition engines require a smart control system to regulate the input quantities of the engine in various operational conditions. Achieving an optimum combustion needs an appropriate system response for different engine loads and speeds according to the power acquired from the engine, as well as the amounts of emissions present in the exhaust. Therefore, performing a set of experimental tests together with numerical simulations in a wide range of conditions facilitates calibration of the input parameters of the engine. In this study, the effects of the thermodynamic parameters and the thermokinetic parameters on the engine output in the preliminary design stage... 

Common rail diesel engines with electronic fuel injection can accurately meter the fuel injection quantity with more accurate fuel injection control capability. In this work a common rail fuel injection system of a single cylinder diesel engine has been proposed and the important parameters like injection pressure, energizing time and high pressure pipes diameter and length are designed such that to be compatible with the engine basic design in case of pressure waves and injected mass variations. A one-dimensional approach has been used to model the injector using AMESim code in which Adiabatic models have been used to model injector system. Injected mass quantity has been calculated for... 

Unfortunately, energy demands and destruction of the environment from uncontrolled manipulation of fossil fuels have increased. Climate change concerns have resulted in the rapid use of new, alternative combustion technologies. In this study, reactivity controlled compression ignition (RCCI) combustion, which can simply be exploited in internal combustion (IC) engines, is investigated. To introduce and identify extra insightful information, an exergy-based study was conducted to classify various irreversibility and loss sources. Multidimensional models were combined with the primary kinetics mechanism to investigate RCCI combustion, incorporating the second law of thermodynamics. The... 

Missing or incomplete data in short or long intervals is a common problem in measuring air pollution. Severe issues may arise when dealing with missing data for time-series prediction schemes or mean analysis. This study aimed to develop a new regression imputation framework to impute missing values in the hourly air quality data set of Tehran and enhance the applicability of Tehran Air Pollution Forecasting System (TAPFS). The proposed framework was designed based on three types of features including measurements of other stations, WRF and CAMx physical models. In this framework, elastic net and neuro-fuzzy networks were efficiently combined in a two-layer structure. The framework was... 

Predicting the way diseases spread in different societies has been thus far documented as one of the most important tools for control strategies and policy-making during a pandemic. This study is to propose a network autoregressive (NAR) model to forecast the number of total currently infected cases with coronavirus disease 2019 (COVID-19) in Iran until the end of December 2021 in view of the disease interactions within the neighboring countries in the region. For this purpose, the COVID-19 data were initially collected for seven regional nations, including Iran, Turkey, Iraq, Azerbaijan, Armenia, Afghanistan, and Pakistan. Thenceforth, a network was established over these countries, and the... 

A probabilistic method is proposed in this study to predict the spreading profile of the coronavirus disease 2019 (COVID-19) in the United State (US) via time-variant reliability analysis. To this end, an extended susceptible-exposed-infected-vaccinated-recovered (SEIVR) epidemic model is first established deterministically, considering the quarantine and vaccination effects, and then applied to the available COVID-19 data from US. Afterwards, the prediction results are described as a time-series of the number of people infected, recovered, and dead. Upon introducing the extended SEIVR model into a limit-state function and defining the model parameters including transmission, recovery, and... 

Fine particulate matter cause profound adverse health effects in Iran. Road traffic is one of the main sources of particulate matter (PM) in urban areas, and has a large contribution in PM2.5 and organic carbon concentration, in Tehran, Iran. The composition of fine PM vehicle emission is poorly known, so this paper aims to determine the mixed fleet source profile by using the analysed data from the two internal stations and the emission factor for PM light-duty vehicles emission. Tunnels are ideal media for extraction vehicle source profile and emission factor, due to vehicles are the only source of pollutant in the urban tunnels. In this study, PM samples were collected simultaneously in... 

This paper experimentally investigates the influence of hydrogen enrichment on the combustion and emission characteristics of a diesel HCCI engine using a modified Cooperative Fuel Research (CFR) engine. Three fuels, n-heptane and two middle distillates with cetane numbers of 46.6 and 36.6, are studied. The results show that hydrogen enrichment retards the combustion phasing and reduces the combustion duration of a diesel HCCI engine. Besides, hydrogen enrichment increases the power output and fuel conversion efficiency, and improves the combustion stability. However, hydrogen enrichment may narrow the operational compression ratio range and increase the knocking tendency. Both the overall... 

Frequent air pollution episodes have been reported for Tehran, Iran, mainly because of critically high levels of fine particulate matter (PM2.5). The composition and sources of these particles are poorly known, so this study aims to identify the major components and heavy metals in PM2.5along with their seasonal trends and associated sources. 24-hour PM2.5samples were collected at a main residential station every 6 days for a full year from February 2014 to February 2015. The samples were analyzed for ions, organic carbon (including water-soluble and insoluble portions), elemental carbon (EC), and all detectable elements. The dominant mass components, which were determined by means of... 

The spatiotemporal variability of ambient volatile organic compounds (VOCs) in Tehran, Iran, is not well understood. Here we present the design, methods, and results of the Tehran Study of Exposure Prediction for Environmental Health Research (Tehran SEPEHR) on ambient concentrations of benzene, toluene, ethylbenzene, p-xylene, m-xylene, o-xylene (BTEX), and total BTEX. To date, this is the largest study of its kind in a low- and middle-income country and one of the largest globally. We measured BTEX concentrations at five reference sites and 174 distributed sites identified by a cluster analytic method. Samples were taken over 25 consecutive 2-weeks at five reference sites (to be used for... 

Various aspects of land use regression (LUR) models for volatile organic compounds (VOCs) were systematically reviewed. Sixteen studies were identified published between 2002 and 2017. Of these, six were conducted in Canada, five in the USA, two in Spain, and one each in Germany, Italy, and Iran. They were developed for 14 different individual VOCs or groupings: benzene; toluene; ethylbenzene; m-xylene; p-xylene; (m/p)-xylene; o-xylene; total BTEX; 1,3-butadiene; formaldehyde; n-hexane; total hydro carbons; styrene; and acrolein. The models were based on measurements ranging from 22 sites in El Paso (USA) to 179 sites in Tehran (Iran). Only four studies in Rome (Italy), Sabadell (Spain),... 

Reactivity controlled compression ignition has been introduced to implement controllable, clean, and high thermal efficiency without undermining the advantages of premixed combustion. However, simultaneous auto-ignition introduced by reactivity controlled combustion challenges the combustion under higher load operations. This experimental study incorporates a dual phase heat release concept with the purpose of improving the performance of reactivity controlled compression ignition engine. Different ratios of ethanol/diethyl-ether blends (from 0% to 40% diethyl ether and 70% premixed ratio) were applied to a light duty diesel engine at various combustion timings and engine loads. The diesel... 

Currently PM2.5 is a major air pollution concern in Tehran, Iran due to frequent high levels and possible adverse impacts. In this study, which is the first of its kind to take place in Tehran, composition and sources of PM2.5 and carbonaceous aerosol were determined, and their seasonal trends were studied. In this regard, fine PM samples were collected every six days at a residential station for one year and the chemical constituents including organic marker species, metals, and ions were analyzed by chemical analysis. The source apportionment was performed using organic molecular marker-based CMB receptor modeling. Carbonaceous compounds were the major contributors to fine particulate mass... 

Reactivity Controlled Compression Ignition can be extended over a wide spectrum of fuels and is anticipated as a promising strategy in meeting current and future emission regulations. In this study, the effect of n-butanol addition on combustion characteristics and emissions in a reactivity controlled engine was investigated experimentally. Different ratios of butanol-diesel blends at different settings of EGR and premixed ratios were applied to a light duty diesel engine. The butanol-diesel blends were directly injected into the combustion chamber while gasoline was injected at the intake port. Combustion phasing was maintained at 2.7 °CA for all of test points by adjusting fuel injection... 

Each year, considerable levels of dust particles coming from arid regions of the earth contribute to the atmosphere. Because dust has serious environmental and human health effects, predictions of dust concentrations and their contribution to PM surface concentrations are essential for atmospheric research and the implementation of air quality programs and rules. This study aims to assess dust contributions to PM2.5 in Tehran in order to provide guidance for air quality management systems as well as validate the updated Dust Regional Atmospheric Model version 2 (BSC-DREAM8b) and the NMMB/BSC-Dust model using chemical speciation of ground-based measurements of PM2.5. Accurate and reliable... 

Very few land use regression (LUR) models have been developed for megacities in low- and middle-income countries, but such models are needed to facilitate epidemiologic research on air pollution. We developed annual and seasonal LUR models for ambient oxides of nitrogen (NO, NO2, and NOX) in the Middle Eastern city of Tehran, Iran, using 2010 data from 23 fixed monitoring stations. A novel systematic algorithm was developed for spatial modeling. The R 2 values for the LUR models ranged from 0.69 to 0.78 for NO, 0.64 to 0.75 for NO 2, and 0.61 to 0.79 for NOx. The most predictive variables were: distance to the traffic access control zone; distance to primary schools; green space; official...