Sharif Digital Repository

Because of the complex nature of carbonate reservoirs, the required conditions for effective Low Salinity Water Flooding (LSWF) in these reservoirs need further and in depth investigation. In the present study, three calcite cores, i.e. Cal-1, Cal-2, and IL, with the same chemical composition are subjected to tertiary low salinity water flooding (LSWF), while the crude oil and composition of flooding brine kept the same. The experimental results show significant difference in the amount of enhanced oil recovery, as IL had the most additional oil recovery (20.8 % of IOIP), followed by Cal-2 (10.5 % of IOIP) and Cal-1 (3.9 % of IOIP). The results of contact angle, zeta potential, and effluent... 

One of the acceptable assumptions in engineering practice is vertical propagation of earthquake waves. When the source of earthquake is located very deep in the ground, this assumption is valid, but for sources located in shallow ground, it loses its viability. In this study, linear seismic analysis of a system of concrete dam-massed foundation-reservoir is performed under inclined earthquake excitation. Both P- and SV-type earthquakes are considered for the purpose of the seismic analysis. To consider the effects of inhomogeneous waves for the case of SV wave propagation, post-critical angles are also considered in the analysis. To investigate the effects of earthquake frequency content on... 

Public concern over environmental issues such as ecosystem degradation is high. However, restoring coupled human-natural systems requires integration across many science, technology, engineering, management, and governance topics that are presently fragmented. Here, we synthesized 544 peer-reviewed articles published through September 2020 on the desiccation and nascent recovery of Lake Urmia in northwest Iran. We answered nine questions of scientific and popular interest about causes, impacts, stabilization, recovery, and next steps. We find: (1) Expansion of irrigated agriculture, dam construction, and mismanagement impacted the lake more than temperature increases and precipitation... 

Controlling evaporation plays an essential role in arid and semi-arid water resources systems where it accounts for a considerable amount of reservoirs outflow. In this study, we have evaluated evaporation reduction efficiency of different kinds of self-assembled nano-thickness films. The films consist of six different combinations of stearyl and cetyl alcohols with additives such as jojoba oil, stearic acid, and calcium hydroxide. The study lasted from July to August and utilized two pairs of class A evaporation pans: one pair was semi-floating on Chitgar lake water surface while the other one was located on the shore. The experimental results showed that a monolayer containing 3:1 stearyl... 

One of the possible fluid-fluid interactions during water-flooding in oil reservoirs, that is still debated, is the effect of injected brine salinity on asphaltene destabilization. If asphaltene precipitation is induced by salinity changes in the oil reservoirs and surface facilities, this could have a massive impact on the economy of a low salinity water-flooding project. Therefore, this study aims to investigate the effect of brine salinity on the amount of asphaltene precipitation and the governing destabilization mechanisms. Direct asphaltene precipitation measurements, along with the analyses of optical microscopy images and ion chromatography (IC), indicate that the asphaltene... 

In this paper, different injectivity scenarios were experimentally investigated in a coreflooding system to observe the efficiency of each method in laboratory conditions. Surfactant flooding, CO2 injection, carbonated water injection (CWI), active carbonated water injection (ACWI), after water flooding were investigated through the coreflooding system. First, it is necessary to optimize the surfactant concentration and then use it in ACWI injection. To do this, linear alkylbenzene sulfonic acid (LABSA) was used as a cationic surfactant at different concentrations. It was observed that 0.6 PV concentration of LABSA had an optimum result as increasing the surfactant concentration would not be... 

Seismic modeling of massive structures requires special caution, as wave propagation effects significantly affect the responses. This becomes more crucial when the path-dependent behavior of the material is considered. The coexistence of these conditions renders numerical earthquake analysis of concrete dams challenging. Herein, a finite element model for a comprehensive nonlinear seismic simulation of concrete gravity dams, including realistic soil-structure interactions, is introduced. A semi-infinite medium is formulated based on the domain reduction method in conjunction with standard viscous boundaries. Accurate representation of radiation damping in a half-space medium and wave... 

Although viability of low-salinity waterflooding (LSWF) at the laboratory scale has been proven, there are some challenges associated with its field application, which sheds uncertainties on its economic success. One of the challenges is the minimum required volume of low-salinity water, which should be injected to the reservoir due to the salt dispersion in porous media. Once the low-saline brine is injected into the reservoir, mixing of injected (low-salinity) and resident (high-salinity) brines occurs and the developed mixing zone grows continuously as the front moves from the injection well toward the production well. Increase in the salinity of the front reduces the efficiency of LSWF.... 

Recorded ground accelerations at various locations of Karun III Dam during November 20, 2007, were recorded by an array of accelerometers located on the dam. In terms of amplitude and phase, these accelerations show non-uniformities in different elevations. In this paper, the effect of these non-uniform ground motions on the seismic response of the dam taking dam-reservoir-foundation interaction into account is investigated. The EACD-3D-2008 finite element program and ABAQUS Software are used for carrying out the seismic analyses. For this purpose, time histories of the earthquake accelerations are interpolated at nodal points located on the dam foundation interface. The analysis has been... 

Real-time measurement of soil water pressure has been recognized as an essential part of investigating water ow in unsaturated soils. Tensiometry, amongst di erent measuring techniques, is a common method for direct evaluation of water pressure. However, the lower limit of measurable water pressure by a conventional tensiometer becomes even more limited by increasing its length in the vertical installation. This paper describes the development of a Vacuum-Re lled Tensiometer (VRT) for monitoring soil water pressure independent of installation depth. This is achieved by xing the distance between pressure sensor and ceramic cup together with incorporating an ancillary vacuum-re lling assembly... 

Real-time measurement of soil water pressure has been recognized as an essential part of investigating water ow in unsaturated soils. Tensiometry, amongst different measuring techniques, is a common method for direct evaluation of water pressure. However, the lower limit of measurable water pressure by a conventional tensiometer becomes even more limited by increasing its length in the vertical installation. This paper describes the development of a Vacuum-Refilled Tensiometer (VRT) for monitoring soil water pressure independent of installation depth. This is achieved by fixing the distance between pressure sensor and ceramic cup together with incorporating an ancillary vacuumre filling... 

During the low salinity waterflooding (LSWF) of a viscous asphaltic oil reservoir, fluid-fluid interactions have a large influence on the fluid flow, pore-scale events, and thus oil recovery efficiency and behavior. In-situ water-in-oil (W/O) emulsion formation is a consequence of crude oil and brine interfacial activities. Despite the published studies, the pore-scale mechanisms of W/O emulsion formation and the role of injected brine salinity, injection rate, and pore-scale heterogeneity on emulsion formation and stability requires a deeper understanding. To address these, a series of static and dynamic micro-scale experiments were performed. The salinity dependent oil-brine interactions... 

One of the acceptable assumptions in engineering practice is vertical propagation of earthquake waves. When the source of earthquake is located very deep in the ground, this assumption is valid, but for sources located in shallow ground, it loses its viability. In this study, linear seismic analysis of a system of concrete dam-massed foundation-reservoir is performed under inclined earthquake excitation. Both P- and SV-type earthquakes are considered for the purpose of the seismic analysis. To consider the effects of inhomogeneous waves for the case of SV wave propagation, post-critical angles are also considered in the analysis. To investigate the effects of earthquake frequency content on... 

Deep saline aquifers are among the most favorable geological sites for short- and long-term carbon geosequestration. Injection of CO2 into aquifers causes various hydro-physical, chemical, and geomechanical interactions that affect the injectivity of wellbores. Despite the extensive research conducted on carbon capture and storage (CCS), there exists a lack of focus on the concept of injectivity. The present study aims to identify the gaps by reviewing the major factors contributing to CO2 injectivity in deep saline aquifers. Moreover, the existing analytical and numerical mathematical models to estimate maximum sustainable injection pressure and pressure build-up are critically reviewed.... 

By reducing the exploration of new oil reservoirs, enhanced oil recovery from previous oil reservoirs is a solution to supply energy demand. In order to develop the production, various technologies and methods have been proposed such as steaming, direct heating, flooding by nano-fluid, chemical injection, polymer injection and etc. In the present study, nanofluid flooding has been attempted on a rock reservoir with incomplete cone geometry and its performance has been evaluated on oil recovery. The porous media is considered heterogeneous in simulation in accordance with oil reservoirs. The heterogeneous geometry considered in this study is incomplete cone that is heterogeneous in a random... 

In this study, flooding of oil reservoir by implementing Nanoscale colloidal solutions as a working fluid is simulated. All oil reservoirs are heterogeneous porous media; therefore, in this investigation for more accurate prediction of the problem, the porous media is considered heterogeneous. The governing equations of this problem are solved by finite element method (FEM). Moreover two-phase equations of Darcy and mass transfer equations are used. In this paper, the effect of temperature and volume fractions of nanoparticles on the rate of oil recovery is investigated. The SiO2, Al2O3, and CuO nanoparticles are used in the enhanced oil recovery (EOR) process. Also, in order to solve the... 

The low salinity water injection has become one of the most important studies in the oil industry for improving oil recovery compared to conventional seawater injection. Thus, extensive studies have been conducted in carbonate and sandstone reservoirs to investigate how the physical properties of rocks and the chemical composition of fluids influence low salinity effect, while, the carbonate reservoir rocks requires more investigation of the effect of molecular and/or ionic interactions. In this experimental work, the effectiveness of various water flooding schemes in carbonate reservoir rock samples is investigated. In this regard, the oil recovery potential of seawater (SW), reservoir... 

Engineered water (EW) flooding is one of the enhanced oil recovery (EOR) techniques in carbonate reservoirs. In this method, the wettability of reservoir rock is altered by controlling the amount of various ions in the injected brine. The thermodynamics of wettability is related to the surface interactions and stability of water film on a rock surface. It can be identified by calculating disjoining pressure isotherms. In this study, core flooding tests, contact angle and zeta potential measurements along with the disjoining pressure isotherm calculation by the DLVO theory were used to investigate the wettability alteration of dolomite rock. Four brines include reservoir formation water... 

Petroleum industry is moving toward enhancing oil recovery methods, especially water-based methods, including low salinity and smart water flooding which water with an optimized composition is injected into the reservoir for improving oil recovery. Injection of water into the target formation is also a common operation in geothermal energy production. As the water is being injected into the reservoir, pressure and temperature change along the well column and cause scale formation. Mineral scale precipitation and deposition is a common problem for water injection wells which reduces the effective radius of the wellbore and affects the injection efficiency. In this paper, modeling scale... 

The chemical, thermal, and mechanical degradation of polymer chains under high salinity, temperature, and shear rates in oil reservoirs are the current challenges of the polymer flooding process. To answer such a complex requirement, recently, acrylamide (AM)-based thermoassociating graft copolymers (TAP) were synthesized that presented excellent performance as a viscosity enhancer, especially under high temperature and salinity conditions. The purpose of this study was to further investigate the effect of salinity, shear rate, mechanical strength, and adsorption of these TAPs on viscosity-enhancing performance at different temperatures. Finally, the performance of the TAPs was studied in...