Sharif Digital Repository

In this paper, we study theoretically the generation of high repetition rate short pulses using fiber optical parametric amplification. We show that the pulse shape and duration depend on the signal location relatively to the pump frequency. We demonstrate that in order to get the shortest pulse width, the signal must be located at one of the extremities of the gain spectrum associated with the pump peak power. We derive the analytical expression of the pulse shape in this case and compare it to the exponential gain regime case. Using numerical simulations, we also analyze the impact of walk-off and pump phase modulation that is required to suppress Stimulated Brillouin Scattering and derive... 

In this letter we consider optimum code structure for positive optical code division multiple-access (optical CDMA) systems. Positive systems are a class of systems that operate with positive real numbers only. We consider the effect of multipleaccess interference in our model and show that code design for both On-Off Keying (OOK) and Binary PPM optical CDMA systems results in the same solutions. Furthermore, we show that a class of codes known as optical orthogonal codes (OOCs) are the best possible positive codes. In obtaining the results we define normalized divergence based on signal-to-multipleaccess interference ratio (SIR) for a multiple-access system in a useful manner and use it as... 

In this paper we examine the transmission of two types of ultra-wideband (UWB) signals, multiband orthogonal frequency division multiplexing (MB-OFDM) and impulse radio ultra-wideband (IR-UWB), over single mode fiber at 1550 nm. In order to investigate the impact of optical components such as laser diode, external modulator and single mode fiber on UWB signals, we develop mathematical models for these components. These models are experimentally verified and corresponding numerical parameter values are obtained by experiment. Using these models we discuss the transmission of two types of UWB signals over single mode fiber. A new figure of merit namely distortion factor is defined. Using... 

Nowadays, dynamic analysis of air-conditioner units is essential to achieve satisfactory comfort conditions in buildings with low energy consumption and operation cost. In this paper, a nonlinear multi input-multi output model (MIMO) of an air-handling unit (AHU) is considered. In the presence of realistic harmonic disturbances, nonlinear dynamics of AHU is investigated. The effect of various thermodynamics and geometrical parameters on limit cycles behaviour of the indoor temperature is investigated. It is observed that the indoor space volume plays as the bifurcation parameter of the system. Decreasing the indoor space volume leads to the occurrence of secondary Hopf (Neimark) bifurcation... 

The theory of silicon optical modulators of ring resonators based on PN diode in reverse bias is primarily discussed. It secondarily provides a full-featured simulator to investigate the behavior of such modulators. Wave equation for ring structure will be solved by using the conformal transformation method and the matrix method as it was used to analyze bent planar optical waveguides. Power coupling between ring and straight waveguides will be calculated by coupled theory of nonparallel waveguides based on experimental results. The time response demonstrates the capability of this device to operate correctly at up to 10 Gbs-1 bitrate, and the frequency spectrum analysis of device shows a >... 

We use a nonlinear analytic approach to predict the main oscillation mode power and spurious levels in ultrapure microwave optoelectronic oscillators (OEOs). This approach takes into account N simultaneously mode falling inside the RF filter bandwidth and calculates all the dominant InterModulation Products (IMPs) that fall in the fundamental zone. We show that nonlinear microwave photonic links exhibit the capture effect. By considering this effect, we derive analytical expressions that govern the behavior of the OEOs in the steady state. We find that when the small-signal open-loop gain is increased beyond a critical value, OEOs start a multimode operation from which the spurious levels... 

A classical question of Yoneda asks when the tensor product of two injective modules is injective. A complete answer to this question was given by Enochs and Jenda in 1991. In this paper the analogue question for pure-injective modules is studied  

An electromagnetically induced phase grating (EIG) controlled by coherent population trapping (CPT) in a fourlevel Y-type atomic system is studied. The CPT condition promotes significantly the dispersion of light into the first-order diffraction in constructing a phase modulation grating by transferring energy from zero-order to firstorder diffraction. The diffraction efficiency of the phase grating is enhanced by up to 30% of the total probe intensity at the first-order diffraction. The present atomic scheme takes full advantage of the microwave-driven field for generating the EIG, which induces the quantum coherence and controls linear and nonlinear behaviors of the present system.... 

An efficient low-complexity VLSI architecture for timing synchronization of a real-time intensity modulation direct detection optical OFDM (IMDD-OOFDM) system is proposed, which results in a significant area reduction. This architecture calculates the correlation among cyclic prefix (CP) regions to estimate the beginning of the OFDM symbol. The proposed architecture utilizes only one functional unit for this purpose, while the throughput is devised for high data-rate optical OFDM systems. Synthesis results of this architecture proves an area saving of 31% compared to the previous work. Moreover, the performance of the correlation method is significantly improved due to a modification applied... 

Operation of two different optical fiber sensor designs for distance measurements with a good sensitivity, resolution, and wide dynamic range is reported. Design is based on the intensity modulation due to reflectance measurement from a target surface. Two reported designs are fabricated with a triple-fiber assembly, in which one uses a double-transmitter, while another one uses a double-receiver fiber design. Reflection signals from different targets are tested with these sensors and results for the mirror and A4 paper surfaces are described. The response curve for both experiments starts from a near zero level, shows a maximum at a certain distance and gradually drops to the background... 

This article examines the Weibull statistical analysis that was used for investigating the effect of melt filtration on tensile properties and defects formed inside the casting. Forming and entrapping of double oxide films have been explained by using the context of critical velocity of melt in the runner. SutCast software results were used to examine the amounts of the velocity of melt as such. SEM/EDX analysis is used to observe the presence of double oxide films in the fracture surfaces of the tensile specimens. The article goes on to propose that castings made with foam filters with smaller pores show higher mechanical properties and reliability due to higher Weibull modulus and fewer... 

The main contribution of this paper is to present a new set of approximate analytical solutions for the parameters of a photovoltaic (PV) five-parameter double-diode model that can be used as initial values for the numerical solutions based on the Newton-Raphson method. The proposed formulations are developed based on only the limited information given by the PV manufacturers, i.e., the open-circuit voltage (V), the short circuit current (I), and the current and voltage at the maximum power point (Im). Compared with the existing techniques that require the entire experimental I-V curve or additional information such as the slope of the I-V curves of the open circuit and the short circuit... 

This paper presents a fragmented-spectrum synchronous OFDM-CDMA modulation and utilize it as secondary users modulation in a cognitive radio-based network to provide high data rate by efficiently exploiting available spectrum bands in a target spectral range while simultaneously offering multiple-access capability. In particular, given preexisting communications in the spectrum where the system is operating, a channel sensing and estimation method is used to obtain information of subcarrier availability. Given this information, some three-level codes are provided for emerging new cognitive radio users. Furthermore, analytical results of the system performance in a typical cognitive radio... 

The noise performance of intensity-modulation direct-detection microwave photonic links (MWPL) operating under large-signal conditions has been studied in this paper. A sinusoidal signal plus narrow-band white Gaussian noise is applied at the radio frequency input of the link, and the output spectrum is derived using a nonlinear analytical approach. We show that the output SNR can be severely affected by the interaction of signal and noise due to the nonlinearity of the MWPL combined with the large input modulating signal. It is shown that the large-signal noise figure (NF) of an MWPL depends on the input power, a dependence that is not readily apparent under small-signal conditions, due to... 

A novel technique is presented to design efficient full-rate space-time block codes (STBCs) over correlated Rician fading channels. The authors first derive a formula for the achievable information rate of a linear dispersion coded multi-input single-output system as a function of correlation at the transmitter in a Rician fading channel. In addition, the authors obtain the bit-error-rate (BER) equations for this system, when multiple phase shift keying and multiple quadrature amplitude modulation schemes are used at the transmitter. Therefore with regard to derived formulae and using a genetic algorithm, a method is presented to construct STBCs over correlated Rician fading channels. The... 

In this work, two-membrane distillation (MD) modes, direct contact MD, and sweeping gas MD were investigated for synthesized and real (Persian Gulf) seawater desalination. A commercial PTFE membrane with 0.22 μm pore size was characterized (using atomic force microscopy and scanning electron microscopy) and was used for experiments. A multipurpose plate and frame MD module was used for desalination experiments. The effects of various operating conditions and MD module design, as well as feed type on the permeation flux have been studied. The feed temperature was found to be the most effective operating parameter. The flow rate in both sides of the MD module was found to be effective;... 

A body insonified by a constant (time-varying) intensity sound field is known to experience a steady (oscillatory) force that is called the steady-state (dynamic) acoustic radiation force. Using the classical resonance scattering theorem (RST) which suggests the scattered field as a superposition of a resonance field and a background (non-resonance) component, we show that the radiation force acting on a cylindrical shell may be synthesized as a composition of three components: background part, resonance part and their interaction. The background component reveals the pure geometrical reflection effects and illustrates a regular behavior with respect to frequency, while the others... 

In this paper, we report our evaluation of the strength of random number generator and RSA key-pair generator of some commercially available constrained hardware modules, i.e., tokens and smart cards. That was motivated after recent related attacks to RSA public keys, which are generated by constrained network devices and smart cards, and turned out to be insecure due to low-quality randomness. Those attacks are mostly computing pair-wise GCD between the moduli in public keys, and resulted in breaking several thousands of these keys. Our results show that most of the tested hardware modules behave well. However, some have abnormal or weak random generators which seem to be unsuitable for... 

Hydrogen is considered to be the fuel of the future. It is a cleaner alternative to the fossil fuels we consume every day. Of all the different hydrogen production pathways that exist, producing the gas by utilizing the power generated by renewable energy sources has been a topic of interest for many researchers across the world. The following work focuses on minimizing the energy loss by optimizing the size and the operating conditions of an electrolyzer directly connected to a photovoltaic (PV) module at different irradiance. The hydrogen, in the proposed system, is produced using a proton exchange membrane (PEM) electrolyzer. A nonlinear method is considered, because of the complexity of... 

This paper presents an approach for optimal operation of a grid-connected hybrid system to maximize the system expected generated energy while maximizing the electricity sale revenue. The hybrid system consists of a photovoltaic (PV) module, an electrolyser (EL), hydrogen storage tank (HS) and a proton exchange membrane (PEM) fuel cell (FC). The generated energy is sold to the distribution grid. During the grid interruptions, the hybrid system output is used as an emergency supply to serve the local load, hence increasing the supply reliability. The proposed approach splits the whole problem in two sub problems: revenue maximizing problem (RMP) and expected generation maximizing problem...