Sharif Digital Repository

In the present contribution, the feasibility of portable Fourier transform infrared spectroscopy (FTIR) combined with multivariate classification techniques is assessed for classification of minced beef, lamb, chicken and pork samples. In this regard, both attenuated total reflectance-FTIR (ATR-FTIR) and diffuse reflectance-FTIR (DR-FTIR) methods are evaluated. First, principal component analysis (PCA) was used for exploring FT-IR spectra of four meat species to find similarities and dissimilarities among samples. Additionally, one-class classification (OCC) was utilized as a new approach for halal meat species certification. For OCC, two scenarios were defined: (i) 100% correct... 

The specific adsorption of citrate from perchloric acid electrolytes, has been investigated using in-situ FTIR spectroscopy at Au(1 1 1) electrodes. For comparison IR spectra for formate adsorption are also presented. Clear voltammetric peaks have been observed positive of the pzc and these are shown by FTIR spectroscopy to be associated with the adsorption of citrate. Models for the surface co-ordination of the citrate anion are discussed. © 2002 Elsevier Science B.V. All rights reserved  

The biodegradability rates of two different kinds of polyethylene bonded with corn and potato starch are studied in this paper. While it is usual to use soil as the environment for biodegradation, an aerated sludge tank was used in this studywhich offers a richermicrobialmediumand increases the rate of biodegradation. The biodegradability is determined by two ways: first, comparing differences in the weight change of two samples, one placed inside distilled water and the other placed in aerated sludge tank. Second test for biodegradation is by examination of FTIR spectroscopy. Through FTIR spectroscopy, the biodegradability rate and reduction in some of the existing bonds in polymer before... 

Despite many attempts to study the interaction of fluids in low-salinity flooding, they do not examine the principles of interphasic transition phenomena. This study aims to provide a new understanding of liquid–liquid interactions during the low-salinity water interaction through a series of experiments on the oil, emulsion, and aqueous phase. Three samples of crude oils with different asphaltene concentrations and structures with known physical properties are in contact with different solutions. The brine pH, conductivity, and crude oil viscosity experiments before and after contacting the oil with brine showed that the heteroatom concentration and compaction of crude oil asphaltene... 

The current study revealed the effectiveness of polypropylene (PP) fibers and cement to enhance the strength of black cotton soil. PP fibers and cement with different concentrations were mixed with black cotton soil. The strength of PP fiber and cement-based soil samples was measured in terms of unconfined compressive strength (UCS) and California Bearing ratio (CBR). Specimens for UCS and CBR tests were prepared at 2%, 4%, 6% and 8% of cement (by dry weight of soil) and seven percentages of polypropylene fibers i.e. 0.0%, 0.1%, 0.2%, 0.3%, 0.4%, 0.5% and 0.6% (by dry weight of soil). Fourier transform infrared (FTIR) analysis confirmed the presence of polypropylene and cement contents in... 

The current study revealed the effectiveness of polypropylene (PP) fibers and cement to enhance the strength of black cotton soil. PP fibers and cement with different concentrations were mixed with black cotton soil. The strength of PP fiber and cement-based soil samples was measured in terms of unconfined compressive strength (UCS) and California Bearing ratio (CBR). Specimens for UCS and CBR tests were prepared at 2%, 4%, 6% and 8% of cement (by dry weight of soil) and seven percentages of polypropylene fibers i.e. 0.0%, 0.1%, 0.2%, 0.3%, 0.4%, 0.5% and 0.6% (by dry weight of soil). Fourier transform infrared (FTIR) analysis confirmed the presence of polypropylene and cement contents in... 

The current work deals with modification of the surface of a silica-polyamine with amine-based ionic liquid (IL) and its application for removal of Cu2+ from an aqueous media. The absorbent is simply prepared from commercially available reagents. The material is characterized by FT-IR spectroscopy, thermogravimetric analysis (TGA), N2 adsorption-desorption, and transmission electronic microscopy (TEM). Effects of several parameters on absorption efficiency, as well as activity of the absorbent to other metals, are also investigated. Moreover, the reusability of the absorbent is studied at the optimized condition. © The Royal Society of Chemistry 2016  

Betaine-based natural deep eutectic solvents (NADESs), a new class of green solvents, were immobilized into a porous polyvinylidene fluoride (PVDF) support and evaluated for the separation of CO2 from CO2/N2 and CO2/CH4 mixtures. Two types of NADESs were synthesized by mixing betaine (hydrogen bond acceptor-HBA) with malic acid and tartaric acid (hydrogen bond donors-HBD) respectively. FTIR and Raman spectroscopy were studied to confirm the synthesis and purity of the NADESs. The thermal strength of the NADESs was investigated using thermogravimetric analysis. The gas permeation results of the fabricated NADES-based-supported liquid membranes (NADES-SLMs) showed that the permeability of CO2... 

Compounding electron beam irradiated polytetrafluoroethylene (PTFE or Teflon) powder with silicone rubber produced silicone rubber/PTFE composites with desired physical properties. PTFE powder was exposed to electron beam irradiation at various doses and characterized by FTIR, DSC and contact angle measurements. Irradiation of PTFE with high energy electron beam induced chain scission reactions. Irradiated PTFE showed higher degree of crystallization and lower melting point with increasing absorbed dose. Number average molecular weight of irradiated PTFE was reduced significantly at higher absorbed doses. Formation of polar groups on the surface of irradiated PTFE powder was detected by FTIR... 

Following our previous work on morphology, corrosion resistance and thermal properties of unsaturated polyester (UP)/nanoclay composites, the effect of electron beam (EB) irradiation on mechanical properties of UP/nanoclay composites with various nanoclay contents is investigated in this work. Moreover, influence of EB irradiation with doses of 100, 500 and 1000 kGy on tensile properties and hardness of nanocomposite was examined. FTIR spectroscopy was employed to examine the effect of irradiation on chemical structure of polymer. EB irradiation up to 500 kGy led to the improvement of tensile strength and hardness of the samples. The best mechanical properties were observed for the... 

This research aims to present asphaltene fraction of oil by FTIR spectrum technique. For this purpose, three different oil samples with various SARA contents and almost identical API degrees were utilized in this research. Two asphaltenic oil samples were referred to as ‘A’ and ‘B’, and the aliphatic oil sample was named as ‘C’. First of all, the asphaltene fraction was extracted through the IP-143 test. The possible chemical bonds and functional groups were identified through NMR tests. Then, the FTIR spectrums of the oil samples and the extracted corresponding asphaltene fractions were taken. The interpretations were used to find the functional groups in the FTIR of the oil samples that... 

The structural and dielectric properties of Gadolinium substituted U-type hexaferrites (Sr4Zn2Fe36O60) were investigated. The samples were synthesized via the Sol-gel auto combustion route. In a muffle furnace, these samples were sintered for 5 h at 1250 °C. The pellets of synthesized powder samples were characterized by XRD, PL, Dielectric, FTIR, and Raman spectroscopies. Structural elucidation of Sr4Zn2Fe36-xGdxO60 was done via XRD. The obtained XRD patterns were matched with the prior literature. The impact of Gd3+ substitutions was measured on all the lattice parameters. Lattice constants “a" and “c" were found between 5.871 and 5.900 Å and 111.76–112.23 Å, respectively. The PL spectra... 

2,4,6,8,10,12-Hexanitro-2,4,6,8,10,12-hexaazaisowurtzitane (CL-20) as one of the high energy cage nitramines has been used in various propellants and explosive formulations. The performance of energetic materials depends on its particle size and shape. Therefore, in this research, microemulsion method has been applied for the preparation of CL-20 nanoparticles via oil in water (O/W) microemulsions. The optimized formulation contains water 45%, n-butyl acetate 20.5%, sodium dodecyl sulfate (SDS, as anionic surfactant) 6.5% and 2-propanol (as co-surfactant) 26.5%. CL-20 nanoparticles that were obtained by microemulsion method are spherical with an average diameter of 25 nm, based on TEM image.... 

A novel silica-functionalized ammonium tungstate interphase catalyst has been reported as a non-nitric acid route for adipic acid production from one-pot oxidative cleavage of 30% hydrogen peroxide and catalytic amounts of p-toluenesulfonic acid (PTSA). The catalyst has been simply prepared by commercially available starting material. The structure of the catalyst has been investigated using FT-IR spectroscopy, atomic absorption, TEM, SEM and XRD analysis. The catalyst has shown good to high activity even up to 10 runs of reaction. Simple preparation of the catalyst, avoids using harmful phase transfer catalyst (PTC) and/or chlorinated additives are among the other benefits of this work  

In this study, 1,4-diazabicy lo[2.2.2] octane (DABCO) tribromide was immobilized on silica support by using 3-chloro propyl trimethoxy silane to obtain a silica-supported DABCO tribromide reagent. The synthesized reagent was characterized with elemental analysis, FT-IR spectroscopy, and thermo-gravimetric analysis (TGA). This reagent has been applied in the conversion of alcohol to corresponding carbonyl compounds. Alcohol oxidation reactions yield in 52-95%, and the reagent may be recycled five times with further bromine treatment  

Poly (vinylidene fluoride) (PVDF) nanocomposites were prepared via melt, solution, and co-precipitation mixing methods using Cloisite 30B as organoclay. The results from X-ray diffraction patterns display intercalation or exfoliation of nanoclay depending on the nanocomposite preparation method. The solvent cast and co-precipitated samples showed exfoliation, while intercalation was observed in the nanocomposites prepared by melt mixing. Introducing organoclay induced formation of β-crystals in the PVDF nanocomposites as evidenced by XRD and FT-IR. FT-IR analysis indicated that the samples prepared by the co-precipitation method had a higher tendency for β phase formation, while the sample... 

In this study organically modified nanoclay were prepared by exchanging of the cetyltrimethylammonium (CTAB), with inorganic/metal ions/cations in montmorillonite structure. To investigate the influence of the amount of modifier on basal spacing and subsequent removal efficiency of hydrocarbon, different amount of modifier was used. The modified and unmodified nanoclays characterized by XRD, CHN and FTIR techniques. The X-ray diffraction results showed that the interlayer spacing of CTAB-modified clays increased from 12 to 22Å. The effectiveness of the sorbent materials for sorption of a range of products was investigated using crude oil, kerosene, gasoline and toluene. The process... 

Low temperature plasma (LTP) is nowadays an intensively investigated superficial treatment of wool. In this work we have investigated the effect of LTP on wool fabric under different conditions. The effect of the position of samples inside the reactor and the kind of gases used as discharge medium has been also investigated. The results show that not only the topography of the surface is modified but also the chemical composition of the surface. It is shown that the hydrophilicity of the samples and also their shrink resistance and anti-felting behavior have improved significantly under LTP treatment. The results show that the shrinkage of 30.1% for untreated samples has reduced to about... 

An easily synthesized fluorescent probe for detecting copper in aqueous samples, with a short response time and at neutral pH, has been investigated. Through the chelation of Cu2+ ions or by binding to CuO nanoparticles, the fluorescence emission of the 2-(aminomethyl)aniline derivative H2L is quenched by over 50%. Spectroscopic determination of the association constants of H2L with some metal ions showed that the ligand has a higher affinity toward Cu2+ than toward other d-block metal ions. The comparative bonding ability of the aniline-based fluorescent probe in d-block metal complexes was studied in solution by a combination of UV-Vis, 1H NMR and mass spectrometry analyses. Besides these,... 

Temperature dependency of infrared band intensity for methylene rocking vibration could be used as indication for creation of solid crystals while decreasing temperature. In this work, different experiments were conducted to measure wax appearance temperature, WAT, such as cross polarized microscopy, rheometry and FTIR spectroscopy. Three Iranian crude oils were characterized based on the SARA test and PC-SAFT model was developed to predict WAT. The obtained results by FTIR spectroscopy and PC-SAFT model were in quite agreement. FTIR spectroscopy determined higher WAT values which may be due to its higher sensitivity to smaller wax crystals. Also, the effect of a polymeric crystal modifier...