Sharif Digital Repository

The graphene-based Ziegler-Natta catalyst has been used to prepare ultrahigh molecular weight polyethylene/graphene oxide (UHMWPE/GO) nanocomposite via in situ polymerization. The morphological investigations have been conducted using X-ray diffraction patterns and scanning electron microscopy method. The obtained results indicated that no diffraction peak is detected in a GO pattern, which could be due to the exfoliation of graphene nanosheets in the UHMWPE matrix. Morphological investigations indicated that GO nanosheets are dispersed almost uniformly in polymeric matrix, and that there should exist a good interaction between nanofillers and matrix. The mechanical properties of the... 

Prediction of reaction yield as the most important characteristic process of a slurry polymerization industrial process of propylene has been carried out. Stacked neural network as an effective method for modeling of inherently complex and nonlinear systems-espe-cially a system with a limited number of experimental data points-was chosen for yield prediction. Also, effect of operational parameters on propylene polymerization yield was modeled by the use of this method. The catalyst system was Mg(OEt)2/DIBP/TiCl 4/PTES/AlEt3, where Mg(OEt)2, DIBP (diisobutyl phthalate), TiCl4, PTES (phenyl triethoxy silane), and triethyl aluminum (AlEt3) (TEAl) were employed as support, internal electron... 

In this article, preparation of polypropylene/clay nanocomposites (PPCNC) via in situ polymerization is investigated. MgCl2/montmorillonite bisupported Ziegler-Natta catalyst was used to prepare PPCNC samples. Montmorillonite (MMT) was used as an inert support and reinforcement agent. The nanostructure of the composites was characterized by X-ray diffraction, scanning electron microscopy, and transmission electron microscopy techniques. Obtained results showed that silica layers of the MMT in these PPCNC were intercalated, partially exfoliated, and uniformly dispersed in the polypropylene matrix. Thermogravimetric analysis showed good thermal stability for the prepared PPCNC. Differential... 

Ultrahigh-molecular-weight polyethylene (UHMWPE)/graphene nanocomposites with molecular weights as high as 3 × 106 g/mol were prepared via in situ polymerization using a bi-supported Ziegler-Natta catalytic system. Effects of [Al]/[Ti] molar ratio, temperature, monomer pressure, and polymerization time on productivity of the catalyst have been investigated. Increasing [Al]/[Ti] molar ratio from 128 to 320, increased productivity from 1667 g PE/mmol Ti.h to maximum value which was 2420 g PE/mmol Ti.h. Further [Al]/[Ti] ratio decreased the productivity. Reaction temperature effect investigation reveals that the optimal activity was obtained at 60°C. the polymerization productivity increases... 

In this research, ultrahigh-molecular-weight polyethylene (UHMWPE)/multiwalled carbon nanotube (MWCNT) nanocomposites with different nanotube concentrations (0.5, 1.5, 2.5, and 3.5 wt %) were prepared via in situ polymerization with a novel, bisupported Ziegler-Natta catalytic system. Magnesium ethoxide [Mg(OEt) 2] and surface-functionalized MWCNTs were used as the support of the catalyst. Titanium tetrachloride (TiCl 4) accompanied by triethylaluminum constituted the Ziegler-Natta catalytic system. Preparation of the catalyst and the polymerization were carried out in the slurry phase under an argon atmosphere. Support of the catalyst on the MWCNTs was investigated with Fourier transform...