Sharif Digital Repository

The use of polymer flooding as one of enhanced oil recovery methods has recently increased. The occurrence of high shear rates in reservoir and near well bore through perforation nozzles during polymer flooding cause shear degradation of polymers and therefore polymer viscosity has decreased. Rheological behavior of polymer solution in different conditions of oil reservoir is one of the key factors to develop use of polymer solutions. A few researches are available regarding improving rheological behavior of polymeric solution. In this study, to investigate the effect of nanoparticles on rheological behavior of polymer solutions two samples were prepared: polyacrylamide solution in water and... 

The main objective of perforating is to connect the wellbore to the reservoir zone by creating tunnels through casing and damaged zone into the undamaged rock. The process of detonating perforation charges generally causes damage due to crushed rock material around the perforation tunnels. There are different methods used to mitigate damage due to perforation, such as static and dynamic underbalanced perforation. In static underbalanced perforation, conventional high shot density perforating guns are run in underbalanced conditions in order to have clean-up after perforation. In dynamic underbalanced perforation, a specific gun design associated with gun puncher charges provides dynamic... 

Deposition of asphaltenes upon precipitation is a main flow assurance concern, which propelled the development of various experimental and modeling techniques to accurately predict its occurrence. This work develops an integrated approach combining thermodynamic and deposition modules with a multiphase flow simulator to simultaneously model asphaltenes precipitation and deposition in wellbores. The Peng-Robinson equation of state and the modified Miller-Flory-Huggins theory are used to calculate the thermodynamic properties of the oil and asphaltenes precipitation, respectively. The deposition module is based on conservation laws for asphaltenes transport and is linked to the flow simulator... 

During transient tests, both pressure and temperature are changed depending on downhole flow rate. In gas producing wells, Joule-Thomson cooling and frictional heating effects are the main dynamic factors causing flowing bottomhole temperature to differ from the static formation temperature at that depth. When a gas well is shut in, JT cooling effect is vanished and this causes a sharp increase in sandface temperature. As effect of wellbore storage ends, wellbore temperature gradually cools down due to heat conduction with near wellbore region. This paper demonstrates a new technique for using temperature transient data in gas wells in order to determine end of wellbore storage. Also, effect...