Sharif Digital Repository

A glassy carbon electrode was coated with a thin layer of multi-walled carbon nanotubes and subsequently was electro-polymerized with polypyrrole. The prepared electrode was used for the voltammetric determination of olanzapine (OLZ). The peak current of OLZ increases remarkably on the surface of the modified electrode. This is due to the large increase in the microscopic area of the electrode surface along with the strong adsorption of OLZ on the surface of the electrode. The film modifier was characterized by scanning electron microscopy, atomic force microscopy and cyclic voltammetry techniques. Experimental variables, such as deposited amount of nanotube suspension, pH of the supporting... 

Morphine is a strong opioid used for the treatment of moderate to severe pain. Its use is, however, associated with adverse effects including sedation, nausea, constipation, respiratory depression, and development of tolerance as well as dependence. Thus, in this work electrochemical oxidation of morphine has been done on BaFe12O19 nanoparticles of the modified electrode. BaFe12O19 nanoparticles of the modified graphite screen-printed electrode (GSPE) and the bare GSPE were compared, representing that the modified electrode takes advantages of higher sensitivities and selectivities with lower limit of detection. Differential pulse voltammetric procedure has been used to analyze data. Results... 

The present study reports synthesis of BaFe12O19 nanoparticles by sol gel technique followed by its characterization using Energy dispersive X-ray spectroscopy (EDS), X-Ray diffraction (XRD), field emission scanning electron microscopy (FESEM), vibrating sample magnetometer (VSM) analysis, and Fourier-transform infrared spectroscopy (FTIR). The BaFe12O19 nanoparticles have been applied to construct a modified graphite screen-printed electrode (GSPE). BaFe12O19/GSPE has been applied as a working electrode in the analysis of tramadol and acetaminophen by voltammetric techniques. The BaFe12O19/GSPE showed a good selectiveness for analysis of tramadol in the presence of acetaminophen with the... 

Risperidone (RIS), one of the typical antipsychotics drugs, originally approved to be used for the mental illness treatment, especially schizophrenia, bipolar disorder, autism and major depression. In the present study, different carbon nanostructures including functionalized multi-walled carbon nanotubes (F-MWCNTs), carbon nanoparticles, nanodiamond-graphite and reduced graphene oxide were employed for modification of the surface of glassy carbon electrode (GCE) for ultrasensitive detection of RIS. The most significant increase in the anodic peak current of RIS was observed on F-MWCNTs-modified electrode (compared to the other modified electrodes and bare GCE). The influence of different... 

A novel ultrasensitive modified electrode was fabricated with a graphene nanosheets and carbon nanospheres (GNS-CNS)-based nanocomposite film as a powerful platform. Pt nanoparticles (PtNPs) were simply electrodeposited onto the GNS-CNS-coated glassy carbon electrode creating a PtNPs/GNS-CNS hybrid nanocomposite modified electrode. Scanning electron microscopy, energy dispersive X-ray spectroscopy and linear sweep voltammetry (LSV) techniques were used for the characterization of the prepared modified electrode. The results of investigation of electrochemical response characteristics of cefepime (CP) revealed a considerable improvement in the oxidation peak current of CP on PtNPs/GNS-CNS/GCE... 

For the first time graphene nanosheets and carbon nanospheres/chitosan (GNS-CNS/CS) based nanocomposite film modified electrode was used for the electro-oxidation of mebendazole (MD). MD is a benzimidazole drug that is used to treat human infections caused by parasitic worms. MD causes slow immobilization and death of the worms by selectively and irreversibly blocking uptake of glucose. The electrochemical behavior of MD at GNS-CNS/CS modified glassy carbon electrode has been investigated using cyclic and differential pulse voltammetry in aqueous media at different pHs. The prepared electrode showed an excellent electrochemical activity toward the electro-oxidation of MD leading to a... 

As a selective estrogen receptor modulator, raloxifene (RXF) prevent of osteoporosis in postmenopausal women by estrogenic actions on bone and decreases the risk of invasive breast cancer by anti-estrogenic actions on the breast and uterus tissue. However, RXF may increase the risk of blood clots, including deep vein thrombosis and pulmonary embolism. For the first time glassy carbon electrode modified with a thin film of melamine/carbon nanoparticles (CNPs/Mela) was constructed and used for the sensitive voltammetric determination of RXF. In comparison with unmodified electrode, the presence of the CNPs/Mela film resulted in a remarkable increase in the peak currents and sharpness of the... 

In the present study, a 3D porous graphene-carbon nanotube (G-CNT) network is successfully constructed on the surface of glassy carbon electrode (GCE) by electrochemical co-deposition from a concentrated graphene dispersion. The large accessible surface area provided by the interpenetrated graphene backbone in one hand and the enhanced electrical conductivity of the 3D network by incorporating CNTs on the other hand, dramatically improved the electrochemical performance of GCE in determination of Methotrexate (MTX) as an important electroactive drug compound. Under the optimum conditions, the electrode modification led to a significant increase in the anodic peak current (∼25 times) along... 

A novel modified electrode is reported for the electrochemical investigation of the oxidation mechanism and also voltammetric determination of raloxifene (RLX). The surface of the electrode was modified with a thin layer of reduced graphene oxide-carbon nanotube nano-composite (rGO-CNT) was prepared, and successfully employed for the electrochemical studies of RLX. The morphology of the sensor surface was characterized by using a scanning electron microscopy. RLX Oxidation response significantly increased at the GCE covered with rGO-CNT, regarding the bare and CNT or rGO functionalized GCE. Experimental parameters affecting the RLX response were optimized and mechanism of the RLX oxidation... 

In this report, the fabrication of vertically aligned carbon nanotube nanoelectrode array (VACNT-NEA) by photolithography method is presented. Electrochemical impedance spectroscopy as well as cyclic voltammetry was performed to characterize the arrays with respect to different diffusion regimes. The fabricated array illustrated sigmoidal cyclic voltammogram with steady state current dominated by radial diffusion. The fabricated VACNT-NEA and high density VACNTs were employed as electrochemical glutamate biosensors. Glutamate dehydrogenase is covalently attached to the tip of CNTs. The voltammetric biosensor, based on high density VACNTs, exhibits a sensitivity of 0.976 mA mM-1 cm-2 in the... 

A carbon paste electrode (CPE) modified with thionine immobilized on multi-walled carbon nanotube (MWCNT), was prepared for simultaneous determination of ascorbic acid (AA) and acetaminophen (AC) in the presence of isoniazid (INZ). The electrochemical response characteristics of the modified electrode toward AA, AC and INZ were investigated by cyclic and differential pulse voltammetry (CV and DPV). The results showed an efficient catalytic role for the electro-oxidation of AA and AC, leading to a remarkable peak resolution (∼303 mV) for two compounds. On the other hand, the presence of INZ, which is considered as important drug interference for AC, does not affect the voltammetric responses... 

A sensitive glutamate biosensor is prepared based on glutamate dehydrogenase/vertically aligned carbon nanotubes (GLDH, VACNTs). Vertically aligned carbon nanotubes were grown on a silicon substrate by direct current plasma enhanced chemical vapor deposition (DC-PECVD) method. The electrochemical behavior of the synthesized VACNTs was investigated by cyclic voltammetry and electrochemical impedance spectroscopic methods. Glutamate dehydrogenase covalently attached on tip of VACNTs. The electrochemical performance of the electrode for detection of glutamate was investigated by cyclic and differential pulse voltammetry. Differential pulse voltammetric determinations of glutamate are performed... 

Multi-walled carbon nanotubes (MWCNTs) were immobilised with cobalt nanoparticles and analyzed by transmission electron microscopy. This modification procedure substantially improved colloidal dispersion of the immobilised MWCNTs in water and organic solvents, yielding uniform and stable thin films for modification of the glassy carbon electrode surface. The modified electrode showed an efficient catalytic role for the electrochemical oxidation of thioridazine (TR), leading to remarkable decrease in its oxidation overpotential of approximately 100 mV and enhancement of the kinetics of the electrode reaction, which can be confirmed by increasing in the peak current and sharpness of the peak.... 

The electrochemical behavior of lamotrigine (LMT) at the pyrolytic graphite electrode (PGE) is investigated in detail by the means of cyclic voltammetry. During the electrochemical reduction of LMT, an irreversible cathodic peak appeared. Cyclic voltammetric studies indicated that the reduction process has an irreversible and adsorption-like behavior. The observed reduction peak is attributed to a two-electron process referring to the reduction of azo group. The electrode showed an excellent electrochemical activity toward the electro-reduction of LMT, leading to a significant improvement in sensitivity as compared to the glassy carbon electrode. The results of electrochemical impedance... 

A modified glassy carbon electrode, prepared by potentiostatic electrodeposition of platinum-ruthenium nanoparticles (Pt-RuNPs) onto a multi-walled carbon nanotube (MWCNT) layer, offers dramatic improvements in the stability and sensitivity of voltammetric responses toward methyldopa (m-dopa) compared to glassy carbon electrodes individually coated with MWCNT or Pt-RuNPs. The surface morphology and nature of the hybrid film (Pt-RuNPs/MWCNT) deposited on glassy carbon electrodes was characterized by scanning electron microscopy (SEM), cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS) techniques. A remarkable enhancement in the microscopic area of the electrode together... 

A sensitive and selective electrochemical sensor was fabricated via the drop-casting of carbon nanoparticles (CNPs) suspension onto a glassy carbon electrode (GCE). The application of this sensor was investigated in simultaneous determination of acetaminophen (ACE) and tramadol (TRA) drugs in pharmaceutical dosage form and ACE determination in human plasma. In order to study the electrochemical behaviors of the drugs, cyclic and differential pulse voltammetric studies of ACE and TRA were carried out at the surfaces of the modified GCE (MGCE) and the bare GCE. The dependence of peak currents and potentials on pH, concentration and the potential scan rate were investigated for these compounds... 

A new sensitive and selective electrochemical sensor was developed for determination of naltrexone (NAL) in pharmaceutical dosage form and human plasma. Naltrexone is an opioid antagonist which is commonly used for the treatment of narcotic addiction and alcohol dependence. A voltammetric study of naltrexone has been carried out at the surface of glassy carbon electrode (GCE) modified with Nafion-doped carbon nanoparticles (CNPs). The electrochemical oxidation of naltrexone was investigated by cyclic and differential pulse voltammetric techniques. The dependence of peak currents and potentials on pH, concentration and the potential scan rate was investigated. The electrode characterization...