Sharif Digital Repository

The main aim of this paper was to study the effect of a new tripodal chelating agent on La1-x Sr x Co1-y Fe y O3-δ perovskite prepared by the complexation method. For this purpose, a phenolic derivative of glycine (L) was synthesized applying the Mannich reaction and characterized by NMR and IR spectroscopies as well as by elemental analysis. To evaluate the complexation capability of L, its formation constants with the perovskite cations were measured. Comparison of these results with those reported for the complexaion with glycine, introduced L as a good candidate for the complexation with Fe(III) and La(III) cations. Furthermore, the powder XRD observations confirmed an improvement in the... 

The present study deals with the investigation of Cu2+, Ni2+ and Pd2+ chelating potential of the Schiff base, (E)-N-(2-((2-hydroxybenzylidene)amino)benzyl)-4-methylbenzenesulfonamide (H2SB). Crystal structures of Ni(HSB)2, Pd(HSB)2 and Cu(HSB)2 have been elucidated from single crystal X-ray diffraction data. NMR spectroscopy showed the presence of two conformers of Pd(HSB)2 in solution, both with an E configuration of the ligand. The determination of binding constants by fluorescence quenching showed that affinity of H2SB to Cu2+ in solution is higher than for Ni2+ and Pd2+. Since there is a high demand for selective, sensitive, rapid and simple methods to detect copper in aqueous samples... 

In the present contribution, the effects of different contaminants of emerging concerns (CECs), including parabens, drugs, and polycyclic aromatic hydrocarbons (PAHs) on antioxidant activity of Lactuca sativa L. in different concentration levels (10–500 µg L−1) were evaluated using ultraviolet–visible (UV–Vis) spectrophotometry combined with chemometric techniques. The extracts of lettuce samples were investigated for the antioxidant activity (AA), total phenolic content (TPC), and total flavonoid content (TFC) after 39 days of planting and 14 days of exposure. Then, the spectroscopic data were arranged in two different data matrices, including (i) the control lettuce samples and PAHs... 

Compound 3-benzyl-2H-pyrano[3,2-c]chromene-2,5(6H)-dione(3), was prepared and fully characterized. The vibrational modes (FT-IR) and NMR data ( 1H and 13C chemical shifts) were compared with the results of Density Functional Theory (DFT) method at the B3LYP/cc-PVTZ level. The calculated vibrational frequencies and NMR chemical shifts are in good agreement with the experimental results. The electronic (UV-Vis) spectrum was calculated using the TD-DFT method in CH2Cl2 with the Polarizable Continuum Model using the integral equation formalism variant (IEFPCM) and was correlated to the experimental spectra. The assignment and analysis of the frontier HOMO and LUMO orbitals indicate that... 

In the current study, γ-Fe2O3/SiO 2/PCA/Ag-NPs hybrid nanomaterials were successfully synthesized and characterized. At first, prepared γ-Fe2O3 core nanoparticles were modified by SiO2 layer. Then they were covered by poly citric acid (PCA) via melting esterification method as well. PCA shell acts as an effective linker, and provides vacancies for conveying drugs. Moreover, this shell as an effective capping agent directs synthesis of silver nanoparticles (Ag-NPs) via in situ photo-reduction of silver ions by sunlight-UV irradiation. This system has several benefits as a suitable cancer therapy nanomaterial. Magnetic nanoparticles (MNPs) can guide Ag-NPs and drugs to cancer cells and then... 

Green and simple synthesis strategies have gained tremendous popularity for the production of anisotropically-shaped noble metallic nanoparticles. The long-term stability of the produced particles, the short timescale of the target reaction(s), as well as the use of non-toxic chemicals, are pivotal features of a useful green procedure. Herein we describe a simple and convenient wet-chemical approach to synthesize stable, non-toxic and water-soluble small gold nanotriangles (GNTs) and gold nanospheres (GNSs) in one step at room temperature, using Tween 20 and Tween 80, respectively. A high level of purity and monodispersity was obtained for the GNTs, in addition to an excellent colloidal... 

In this article, droplet size and its distribution along a pulsed liquid-liquid extraction column, is studied where SiO2 nanoparticles with concentrations of 0.01, 0.05 and 0.1vol.% and different hydrophobicities are applied to the dispersed phase. Using ultrasonication, nanoparticles were dispersed in kerosene as the base fluid. Nanofluids' stability was ensured using a UV-vis spectrophotometer. Some 22,000 droplets were measured by photographic technique and results were compared with systems containing no-nanoparticles (Water-Acetic acid-Kerosene). Addition of nanoparticles changed the droplet shape from ellipsoidal to spherical. Also, there was a marked influence on droplet breakage and... 

Simple synthesis of silver doped TiO2 nanostructured layers by micro arc oxidation process is reported for the first time. The layers consisted of anatase and rutile phases whose characteristic XRD-peaks shifted toward lower diffraction angles when compared to the pure micro arc oxidized TiO 2 layers. Silver-doping was confirmed by XPS technique. The anatase phase crystalline size was determined as 27.6 and 21.8 nm for the layers grown under the voltages of 350 and 500 V. Employing a UV-Vis spectrophotometer, a red shift in the absorption edge of the layers was observed when silver was incorporated into the titania lattice  

ZnS nanoparticles were synthesized through a one-step precipitation process. Effect of time and temperature on the formation reaction was investigated. The synthesized samples were characterized by X-ray diffraction (XRD), ultraviolet (UV) visible absorption and photoluminescence (PL) spectrophotometry. Based on XRD and UV-Vis data, the particles produced at 70 °C had a mean particle size of about 5 nm. Increasing time and temperature of the synthesis reaction resulted in photoluminescence intensification. PL spectroscopy helped understanding the adsorption kinetics of oxygen on ZnS nanoparticles during the precipitation synthesis process. Fabrication of ZnS structures with appropriate... 

A new gelator based of oleylamide has been introduced, which was gelled nonpolar hydrocarbon and CCl4 solvents through self-assembly. Also, the gelator formed a two-component hydrogel in combination with SDS, an anionic surfactant. UV-Vis studies revealed that the H-type and J-type aggregation of organogels in hexane and hydrogel in water, respectively. The xerogel, obtained by evaporating the solvent of organogel, selectively gelled and adsorbed oil spills on water surfaces. The effect of the various parameters, including temperature, water acidity and pH on the oil spill adsorption was studied, revealing the high ability of the xerogel to removing the oil contamination from water in up to... 

In this research, Ag-Al2O3 nanostructures have been prepared via combustion synthesis and ammonium acetate and urea have been applied as fuels. The prepared Ag-Al2O3 nanostructures were characterized by DTA, XRD, SEM, TEM, and BET spectroscopy. The effect of different ratios of silver to alumina and fuel percentage on morphology and particle size of prepared products were investigated. The results showed that using ammonium acetate fuel led to the production of Ag-γ-Al2O3 nanocompounds, while using urea produced Ag-α-Al2O3. Also, the photocatalytic activity of Ag-Al2O3 nanostructures for Congo red degradation was evaluated by UV-Vis diffuse reflectance spectroscopy. The photocatalytic... 

In this work, synthesis of CuIn0.75Ga0.25S2 (CIGS) nanoparticles, the formation of stable dispersion, deposition of high-quality films and, fabrication of thin-film Perovskite solar cells are reported. The stability of nanoparticle ink is crucial in the formation of device-quality films. The chalcogenide-based materials are widely used in thin-film solar cells; in particular, Cu(In,Ga)S2 are used as an absorber and hole transporting layer. In the present study, the nanoparticles of about 20 nm size and bandgap of 1.5 eV are synthesized using a heat-up method. A variety of solvents are used as dispersing media and the stability of the inks is evaluated by precise optical monitoring. We... 

Structural and intermolecular interactions of solvatochromic probes 4-nitroaniline, 4-nitroanisole, and Reichardt’s dye were investigated in the binary mixtures of 2-hydroxy ethylammonium formate as an ionic liquid with N,N-dimethyl formamide, dimethyl amine, and dimethyl sulfoxide. Solvatochromic parameters (ETN, normalized polarity parameter; π*, dipolarity/polarizability; β, hydrogen-bond acceptor basicity; α, hydrogen -bond donor acidity) were determined in ionic liquid mixtures at 25 °C using UV−vis spectroscopy. ETN parameters obtained from absorbance of Reichardt’s dye within various mixtures of ionic liquid were observed to be higher than predicted values from ideal additive... 

The kinetics of coalescence is studied experimentally using a new technique for tracking the process in the bulk phase. For this aim, aqueous solutions of KSCN (colorless) and FeCl3 (light yellow) are used to make individual W/O emulsions. Any coalescence occurred between drops containing KSCN solution and those containing FeCl3 solution would combine these solutions. This leads to a reddish brown solution due to the formation of iron(III)thiocyanate. The intensity change of this red color with time represents the dynamics of coalescence occurring between drops of different emulsified aqueous droplets. The detector response to any changes in the system is recorded as a function of time. In... 

A series of V2O5 catalysts supported on multiwall carbon nanotube (MWCNT), single wall carbon nanotube (SWCNT), and graphene were synthesized by hydrothermal and reflux methods for oxidative dehydrogenation of propane (ODHP) to propylene. The catalysts were characterized by techniques including the BET surface area measurements, XRD, FTIR, H2-TPR, NH3-TPD, FESEM, and UV-vis diffuse reflectance spectroscopy. The performance of the catalysts and the supports were subsequently examined in a fixed bed reactor. The main products were propylene, ethylene and CO x. The vanadium catalyst supported on graphene with C/V molar ratio of 1:1 synthesized through the hydrothermal method had the best... 

We have studied systematically photocatalytic properties of the vertically aligned ZnO@CdS core-shell nanorods where the features were grown through a multistep procedure including sol-gel for the formation of ZnO seed layer, hydrothermal process to grow ZnO nanorods, and successive ion layer adsorption and reaction (SILAR) process to deposit CdS nanoshells onto the ZnO nanorods. Formation of the ZnO seed layer and vertically aligned ZnO nanorods (d ∼ 40 nm) with a hexagonal cross-section was confirmed by AFM and SEM imaging. Successful capping of ZnO nanorods with homogeneous CdS nanocrystallites (∼5 nm) was ascertained by HRTEM diffraction and imaging. Optical properties of the samples... 

A facile sonochemical method has been developed to prepare very small zinc sulfide nanoparticles (ZnS NPs) of extremely small size about 1. nm in diameter using a set of ionic liquids based on the bis (trifluoromethylsulfonyl) imide anion and different cations of 1-alkyl-3-methyl-imidazolium. The structural features and optical properties of the NPs were determined in depth with X-ray powder diffraction (XRD), transmission electron microscopy (TEM), high-resolution TEM (HRTEM), Fourier transform infrared (FTIR) spectroscopy, dynamic light scattering (DLS) analysis, and UV-vis absorption spectroscopy. The energy band gap measurements of ZnS NPs were calculated by UV-vis absorption... 

Tungsten oxide nanoparticles were fabricated by a pulsed laser ablation method in deionized water using the first harmonic of a Nd:YAG laser (λ = 1064 nm) at three different laser pulse energies (E1 = 160, E2 = 370 and E3 = 500 mJ/pulse), respectively. The aim is to investigate the effect of laser pulse energy on the size distribution and gasochromic property of colloidal nanoparticles. The products were characterized by dynamic light scattering (DLS), atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS) and UV-Vis spectroscopy. The results indicated that WO 3 nanoparticles were formed. After ablation, a 0.2 g/l PdCl 2 solution was added to activate the solution against... 

The morphological manipulation, structural characterization, and optical properties of different CdSe nanocrystals were reported. Several different CdSe nanostructures, including nanowires, tetrapod crystals, and nanoparticles were grown by varying the volume ratio of triethylenetetraamine (TETA) and water (WA) in their mixed solution. By manipulating the growth driving force (i.e., the degree of supersaturation) and kinetics of the process (i.e., growth rate), the morphology and crystal structure of CdSe nanocrystals can be tailored. Growth driving force changed their morphology from nanowires to tetrapod structures and from the latter structure to nanoparticles. Moreover, kinetics of the...