Sharif Digital Repository

Adsorption and recovery of uranium by nanoporous MCM-41 from aqueous solutions (synthetic solution and uranium conversion facility liquid waste) were investigated by use of a fixed-bed column (1.2 cm diameter and 3.0 cm height). Adsorption was carried out at flow rates 0.2 and 0.5 mL min-1, which correspond to retention times of 10 and 6 min. The maximum breakthrough capacity for uranium ions was achieved by use of nanoporous MCM-41 at the optimum pH of 3.6 and flow rate 0.2 mL min-1 (61.95 μg g-1). The Thomas and Yan models were applied to the experimental data, by use of linear regression, to determine the characteristics of the column for process design. The breakthrough curves calculated... 

In this paper, a mathematical model for the mesophilic bioleaching of uraninite is developed. The case of constant temperature, pH, and initial ore concentration is considered. The model is validated by comparing the calculated and measured values of uranium extraction, ferric and ferrous iron in solution, and cell concentration. Good fits of the model were obtained, while the values of the parameters were within the range expected. New rate expressions were used for the iron precipitation and uranium leaching rates. The rates of chemical leaching and ferric precipitation are related to the ratio of ferric to ferrous in solution. The fitted parameters can be considered applicable only to... 

In this study the bioleaching of a low-grade uranium ore containing 480 ppm uranium has been reported. The studies involved extraction of uranium using Acidithiobacillus ferrooxidans derived from the uranium mine samples. The maximum specific growth rate (μ max) and doubling time (t d) were obtained 0.08 h-1 and 8.66 h, respectively. Parameters such as Fe2+ concentration, particle size, temperature and pH were optimized. The effect of pulp density (PD) was also studied. Maximum uranium bio-dissolution of 100 ± 5 % was achieved under the conditions of pH 2.0, 5 % PD and 35 °C in 48 h with the particles of d 80 = 100 μm. The optimum concentration of supplementary Fe2+ was dependent to the PD.... 

Continuous fixed-bed column studies were carried out by using Amberlite CG-400 anion exchange resin for the recovery of uranium from aqueous solutions (synthetic solutions and uranium conversion facility (UCF) liquid waste). Effects of operating parameters such as flow rate and bed height were studied. The breakthrough capacity decreases with increasing flow rate, but this dependence was not significant with a long column. The maximum breakthrough capacity of uranium ions were achieved by CG-400 resin at a flow rate of 0.2 mL min-1 and bed height 9.1 cm (4 g resin). The elution behavior of uranium from CG-400 resin by various eluents have been investigated and the results show that 0.5 mol... 

The performance of a gas centrifuge that is used for isotopes separation is dependent on the gas flow inside it. In this study, for modeling the UF6 gas flow, an Implicit Coupled Density-Based (ICDB) solver, was developed in OpenFOAM. To validate the ICDB solver, the gas flow within the rotor in total reflux state was compared with the analytical solution obtained by Onsager model and the numerical solution obtained by the Fluent software. The results showed that the ICDB solver had acceptable accuracy and validity. Also the computational efficiency of Roe, AUSM (Advection Upstream Splitting Method) and AUSM+ up schemes were compared. The results showed AUSM+ up scheme is efficient. Then,... 

The purpose of this study is to investigate production of high quality ammonium uranyl carbonate (AUC) from “uranyl nitrate + ammonium bicarbonate”, or “uranyl nitrate + sodium carbonate” precursor solutions, by controlled injection of ammonium carbonate solution which could be applicable in material testing reactor (MTR) fuel production plant for recycling of rejected uranium oxide powder. The experimental observations revealed: at pHs higher than 6, precipitation proceeds with formation of no intermediate, thus ensuing a better morphology and size distribution of the AUC products. The results of scanning electron microscopy, X-ray diffraction, particle size analysis, and uranium content... 

During the past decade, the CANDLE burnup strategy has been proposed as an innovative fuel cycle and reactor design for complete utilization of uranium resources. In this strategy the shapes of neutron flux, nuclide densities and power density distribution remain constant but the burning region moves in axial direction. The feasibility of this strategy has been demonstrated widely by using the diffusion technique in conjunction with nuclide transmutation equations. On the other hand since the Monte Carlo method provides the exact solution to the neutron transport, the Monte Carlo technique is becoming more widely used in routine burnup calculations. The main objective of this work is startup... 

In this paper, the sorption of uranium onto nanoporous silica adsorbent in the presence of nitrate, sulfate, chloride, fluoride and phosphate was studied. The effect of contact time between the nanoporous sorbent and aqueous solution, pH and initial concentration of uranium was also investigated. Uranium sorption onto nanoporous silica adsorbent is a very fast process as sorption rate increases with pH increment. Optimum pH for uranium sorption was 4-8. Experimental sorption isotherm is successfully described by Langmuir and Freundlich models. The results obtained by batch experiments showed that the presence of high concentration of nitrate, sulfate, chloride and phosphate anions alone had... 

In this paper, uranium sorption onto amberlite CG-400 anion exchange resin in the presence of phosphate anions was studied. The effect of contact time between the sorbent and aqueous solution, pH, initial concentration of uranium and temperature were also investigated. Kinetic studies show that uranium sorption onto amberlite CG-400 resin in the presence of phosphate is a fast process and follows pesudo-second-order kinetics. It was also found that the pH value and the presence of phosphate play very important roles in the uranium sorption onto CG-400 resin. Optimum pH for uranium sorption in the presence of phosphate anions was about 3.5. The experimental sorption isotherm is successfully... 

Carbonaceous radioactive waste is produced by adsorption of effluent gases of UF6 production line, on a bed of charcoal. Current research was aimed at developing a process for recovery of uranium from this waste in a laboratory and at pilot scale. As a first step, leaching of uranium from carbonaceous radioactive waste was undertaken by successive steps using Al(NO3)3 and nitric acid, the former used to eliminate corrosivity of the F− ions. The stoichiometry of reaction between F− and Al3+ ions form complexes ranging from AlF2+, AlF2+ to AlF3 depending upon their molar ratio. The results showed that the increase of NO3−/U ratio increased the uranium leaching efficiency. Presence of some... 

Thermodynamic and kinetic studies have been carried out on the adsorption of uranium(VI) by Amberlite IRA-910 resin. The adsorption process has been investigated as a function of adsorbate concentration, solution acidity, contact time, adsorbent dosage, and temperature. The experiments were preformed in batch mode, where uranium initial concentration on the solution samples were 185.5, 277.6 and 456.8 (mg/lit), sulfuric acid concentration range was 0.02-9 (mol/lit) and sorbent dosages were 0.2, 0.3 and 0.5 g. Equilibrium isotherm data were analyzed using Freundlich and Dubinin-Radushkevich isotherm models. The results showed that the adsorption process was well described by Freundlich...