Sharif Digital Repository

Although several investigations have studied the low-salinity water injection (LSWI) performance during the past decades, the effect of crude oil type on the interfacial tension (IFT) and wettability alteration is still in dark. In this regard, this study is aimed to obtain the thermodynamic energies including adhesion, cohesion and spreading coefficient during LSWI. To achieve this goal, IFT and static contact angle values of three different crude oils (i.e. light, medium and heavy) are measured as a function of sea water salinity. The obtained results revealed that the dilution of sea water can change the wettability of reservoir rock from oil wet state towards water wet state, while crude... 

Polypropylene (PP) has a very low value of the surface free energy (approximately 20-25 mJ m-2). And thus, has very weak hydrophilic properties and doesn't have any affinity to any dyestuffs, such as cationic or anionic dyes. In this study, we covered some parts of PP fabrics by mask, and then irradiated them by electrons with different energies. After electron irradiation, the samples were dyed by cationic dyestuff. The result showed that, electron irradiated parts could be dyed easily and the fabric could be printed and decorated simply. The treated surfaces were investigated by scanning electron microscope (SEM), reflective spectrophotometery, and Fourier transform infrared spectroscopy... 

Behavior of nanostructures, which are characterized by a large surface-to-volume ratio, is greatly influenced by their surface parameters, such as surface elastic moduli tensor. Accurate determination of the surface elastic constants by first principles is of particular interest. To this end, through consideration of the fundamental thermodynamic arguments for free solid surfaces, an analytical formulation for the change in specific Helmholtz surface free energy is developed. Relating this formulation to the corresponding energy calculated via first principles leads to the determination of the surface elastic moduli tensor. The surface mechanical properties, namely surface energy, surface... 

We investigate a one-dimensional (1-D) Ising model for finite-site systems. The finite-site free energy and the surface free energy are calculated via the transfer matrix method. We show that, at high magnetic fields, the surface free energy has an asymptotic limit. The absolute surface energy increases when the value of f (the ratio of magnetic field to nearest-neighbor interactions) increases, and for f ≥10 approaches a constant value. For the values of f ≥0.2, the finite-site free energy also increases, but slowly. The thermodynamic limit in which physical properties approach the bulk value is also explored  

Metallic nanoparticles are interesting because of their use in catalysis and sensors. The surface energy of the FCC platinum nanoparticles are investigated via molecular dynamics simulation using Quantum Sutton-Chen (QSC) potential. We have calculated the Gibbs free energy for the FCC platinum bulk and also for its nanoparticle. All calculations have been carried out at zero pressure. We have used the thermodynamic integration method to obtain the Gibbs free energy. The total Gibbs free energy is taken as the sum of its central bulk and its surface free energy. We have calculated the free energy of a platinum nanoparticle as a function of temperature  

Recently, wettability alteration has been much attended by researchers for studying well productivity improvement in gas condensate reservoirs. Previous studies in this area only utilized water/alcohol based chemicals for this purpose. While, hydrocarbon nature of the blocked condensate in retrograde gas reservoirs, may motivate application of hydrocarbon based chemical agents. In this study, a new hydrocarbon based wettability modifier is introduced to alter wettability of carbonate and sandstone rocks to preferentially gas wetting condition. Static and dynamic contact angle measurements, spontaneous imbibition and core flooding tests were conducted to investigate the effect of proposed... 

Although several investigations have studied the low-salinity water injection (LSWI) performance during the past decades, the effect of crude oil type on the interfacial tension (IFT) and wettability alteration is still in dark. In this regard, this study is aimed to obtain the thermodynamic energies including adhesion, cohesion and spreading coefficient during LSWI. To achieve this goal, IFT and static contact angle values of three different crude oils (i.e. light, medium and heavy) are measured as a function of sea water salinity. The obtained results revealed that the dilution of sea water can change the wettability of reservoir rock from oil wet state towards water wet state, while crude... 

Dynamic contact angle measurement; as a standard method for surface wettability analysis, is usually conducted through the analysis of sessile drops formed following the low rate injection of fluid from beneath through a drilled hole via an injection needle. However, understanding/characterizing the changes of drop contact angle from the point where the flat solid surface begins is not well discussed yet. Moreover, during the evaluation of size-dependent behavior of contact angle of millimeter-scale drops, the effect of the drilled hole is ignored. In this regard, in the current study, the experimental and thermodynamic characterizations of the sessile drop advancing contact angle... 

Creating laser texture on dental implants is a novel method for accelerating osseointegration and prolongation of lifespan. The purpose of this research was twofold: (1) Creating intersecting lines pattern with different angles (0°, 15°, 30°, 45°, 60°, 75°, and 90°) on the surface of Ti6Al4V, using pulse Nd:YAG laser with a wavelength of 1064 nm and a pulse length of 170 ns and (2) comparing optical and SEM images, EDS analyses, contact angles (CAs), and surface free energies (FEs) for different intersecting lines angles. CA and FE depended on the intersecting lines angle according to Y = Y 0 + A sin (x B + C), where Y is the CA or FE; x is the intersecting lines angle; and Y0, A, B, and C... 

Recently, super gas wet and gas wet surfaces have been extensively attended in petroleum industry, as supported by the increasing number of publications in the last decade related to wettability alteration in gas condensate reservoirs. In many cases, contact angle measurement has been employed to assess the wettability alteration. Even though contact angle measurement seems to be a straightforward approach, there exist many misuses of this technique and consequently misinterpretation of the corresponding results. In this regard, a critical inspection of the most recent updated concepts and the intervening parameters in the contact angle based wettability evaluation of liquid-solid-gas... 

It is well known that the displacement efficiency of EOR processes is mainly affected by wettability of porous medium; however, the role of nanoparticles on wettability alteration of pores surfaces remains a topic of debate in the literature. Furthermore, a little is known about how the dispersed silica nanoparticles affect the microscopic/macroscopic recovery efficiency of heavy oils during common immiscible EOR processes such as water flooding. In this study, a series of injection experiments was performed on five-spot glass micromodel which is initially saturated with the heavy oil. Distilled water and dispersed silica nanoparticles in water (DSNW) at different values of weight percent... 

It is well known that the displacement efficiency of EOR processes is mainly affected by wettability of porous medium; however, the role of nanoparticles on wettability alteration of pores surfaces remains a topic of debate in the literature. Furthermore, a little is known about how the dispersed silica nanoparticles affect the microscopic/macroscopic recovery efficiency of heavy oils during common immiscible EOR processes such as water flooding. In this study, a series of injection experiments was performed on five-spot glass micromodel which is initially saturated with the heavy oil. Distilled water and dispersed silica nanoparticles in water (DSNW) at different values of weight percent... 

Wettability alteration analysis form gas-repellent to gas-wet with the aid of chemical agents has been subjected of numerous studies. However, fundamental understanding of the effect of surface tension of liquid on repellency strength, the change in the intermolecular forces due to the adsorption of nanoparticles onto the rock surfaces, and exposure of treated rock in brine are not well discussed in the available literature. In this study, X-ray diffraction, Atomic Force Microscopy, scanning electron microscopy, and energy-dispersive X-ray spectroscopy were applied to characterize the treated and fresh samples. Dynamic and static contact angle measurements were then combined with six methods...