Sharif Digital Repository

In some well-known passive localization methods, when the number of equations equals the number of unknown object coordinates, there arise finite number of possible solutions. A localization disambiguation technique is required to identify the correct solution in these cases. As an example, the exact solution of time-difference-of-arrival (TDOA) based equations for four receiver sites, leads to a couple of solutions with only one of them being the true target position. This ambiguity, conventionally is resolved by using angle-of-arrival (AOA) measurements or using an additional receiver site which increase the cost and complexity of the system. In this paper a localization disambiguation... 

In the current study, a novel approach which takes into account the effectiveness of both convectional surfactants and biosurfactants was investigated. The biosurfactant produced by Enterobacter cloacae strain was utilized concomitant with conventional surfactant (sodium dodecyl benzene sulfonate (SDBS)) to evaluate its capability to reduce the SDBS adsorption on rock surface (biosurfactant acts as sacrificial agent) or synergistically enhance the effectiveness of the SDBS. In this regard, the wettability alteration and interfacial tension (IFT) measurements and calculation of spreading coefficient were performed considering two different scenarios. In the first scenario, SDBS was added to... 

In some well-known passive localization methods, when the number of equations equals the number of unknown object coordinates, there arise finite number of possible solutions. A localization disambiguation technique is required to identify the correct solution in these cases. As an example, the exact solution of time-difference-of-arrival (TDOA) based equations for four receiver sites, leads to a couple of solutions with only one of them being the true target position. This ambiguity conventionally is resolved by using angle-of-arrival measurements or using an additional receiver site, which increase the cost and complexity of the system. In this paper, a localization disambiguation... 

Separation of the effects of initial horizontal stress and relative density on cone tip resistance in sandy soils has been a complicated issue for many years. In order to overcome this problem, a numerical modeling of CPT which has been verified by calibration chamber tests, has been used in this paper to achieve a reliable analytical solution. The analytical solution has resulted in two relationships for sleeve friction and cone tip resistance in terms of the initial conditions of sandy soil. Based on the presented solution, the initial horizontal stress and relative density can be determined according to CPT measurements. © 2017 Elsevier Ltd  

Effective diffusion coefficient is an important parameter which needs to be determined in different fields of study, such as cathode catalyst layers of PEM fuel. For this purpose, a Loschmidt diffusion cell can be used. When a porous medium is placed in Loschmidt apparatus, the effective gas diffusion coefficient (EGDC) of this section must be correlated by diffusion coefficient in absence of a porous medium. In the previous researches studying the Loschmidt diffusion cell, a simplifying infinite-length assumption was used in the analytical solution. Therefore, the solution is only applicable for a short time range, and this can result in high error. In order to overcome this challenge, the... 

Elliptic localization is a range-based positioning technique exploiting multiple transmitter-receiver pairs, each of which provides separate bistatic range (BR) measurements. In this paper, a novel computationally efficient solution for locating a single target from BR measurements in distributed MIMO radar systems is proposed. Due to nonconvex nature of the associated maximum likelihood (ML) estimation problem, its globally optimal solution is difficult to obtain. We first reformulate the ML estimation as a nonconvex constrained weighted least squares problem. Owing to special structure of the resulting problem, it is recast as a convex problem, whose exact solution can be obtained in... 

In this research, the ZnOG hybrid thin film was produced via solgel method. The surface morphology, band gap and photoactive properties of the films were studied by means of SEM, UV–Vis and photoluminescence analysis. In addition, the ability of the thin film in photocathodic protection of carbon steel (CS) and 304 stainless steel in 3.5 wt.% NaCl and Na2S solutions under dark and UV illumination was investigated by polarization test as well as OCP and current measurements during coupling of steels with ZnOG photoanode. The mix band gap is reduced to the orders of 1.17 eV through hybridization of ZnO with graphene oxide. In both NaCl and Na2S solutions, the ZnOG thin film could effectively... 

The Persian Liquorice was introduced as a sustainable corrosion inhibitor with excellent inhibition action for mild steel in sodium chloride solution. Persian Liquorice is a root of Glycyrrhiza glabra including many active compounds like Glycyrrhizin (GL), 18β- Glycyrrhetinic acid (GA), Liquritigenin (LTG), Licochalcone A (LCA), Licochalcone E (LCE), and Glabridin (GLD). The Fourier transform infrared (FT-IR) spectroscopy was utilized to track various active components exist in the Persian Liquorice extract. Electrochemical impedance spectroscopy, potentiodynamic polarization and electrochemical current noise measurements were conducted to investigate the corrosion inhibition role of various... 

In this study, the different parts of carthamus tinctorius plant, including petal (SPE), leaf (SLE), and shoot (SSE), have been extracted. Adsorption of the extracts on mild steel in 3.5 wt. % NaCl solution was evaluated employing electrochemical impedance spectroscopy (EIS), potentiodynamic polarization, and electrochemical noise measurements (EN). The field-emission scanning electron microscopy (FE-SEM) and attenuated total reflectance Fourier transform infrared spectroscopy (ATR-FTIR) were employed to appraise the morphology of the samples surface subjected to the test solutions. According to the EIS results, the maximum adsorption efficiency belonged to the solution containing 1 g L−1 of...