Sharif Digital Repository

In this work the effects of backwash pressure, duration of acid and sodium hydroxide backwashing, sodium hydroxide concentration, and the duration of forward washing on performance of permeate flux recovery (PFR) were investigated. A two-level fractional factorial design (FFD) was used to design the experiments. The ability of back propagation neural network (BPNN) and radial basis function neural network (RBFNN) in predicting the performance of cleaning-in-place (CIP) of hydrophilic polyethersulfone (PES) membrane were investigated. It is found that BPNN has better ability in predicting the PFR performance than RBFNN. The best architecture of BPNN was a network consisting of 1 hidden layer... 

A horizontally oriented liquid-liquid-liquid microextraction (HOLLLME) setup was developed and applied for the isolation of two major estrogens from aquatic media. In contrast to the conventional procedure, in this setup the extracting microdrop was suspended from a horizontally positioned needle in order to provide much higher stability to the extracting phase. The developed HOLLLME approach was applied to isolate two major selected estrogens from aquatic media followed by high performance liquid chromatography-ultraviolet (HPLC-UV) determination. Estrogens were, initially, extracted from water samples into hexane and subsequently, the back extraction stage was performed with 6 μL of sodium... 

Acyclic and cyclic acetates of various alcohols and phenols were obtained in excellent yields under mild reaction conditions in the presence of a catalytic amount of sodium hydroxide under solvent-free conditions and microwave irradiation. Selective deprotection of acetate group from the corresponding phenolic compounds was carried out in the presence of LiClO4· 2H2O. Copyright © Taylor & Francis, Inc  

In this work, the addition of a novel polyaniline (PANI)/silica (SiO2) nanostructure (PSn) in chitosan/polyvinyl alcohol nanofibers (CP) was evaluated to enhance the dye removal capacity of CP. Fourier transform infrared spectroscopy (FTIR), field-emission scanning electron microscopy (FE-SEM), and energy-dispersive X-ray spectroscopy (EDS) results confirmed the chemical grafting of SiO2 on PANI nanoparticles. Brunauer-Emmett-Teller (BET) results showed a specific surface area of 61 m2 g−1 for the PSn filled CP nanofiber (CP-PSn). FE-SEM and EDS-elemental mapping results showed the uniform dispersibility of PSn in CP nanofibers. After the addition of PSn into CP, the adsorption capacity of... 

Objective: This study aimed to employ nonlinear dynamic approaches to assess trunk dynamic stability with speed, symmetry, and load during repetitive flexion-extension (FE) movements for individuals with and without nonspecific low back pain (NSLBP). Background: Repetitive trunk FE movement is a typical work-related LBP risk factor contingent on speed, symmetry, and load. Improper settings/adjustments of these control parameters could undermine the dynamic stability of the trunk, hence leading to low back injuries. The underlying stability mechanisms and associated control impairments during such dynamic movements remain elusive. Method: Thirty-eight male volunteers (19 healthy, 19 NSLBP)... 

Presence of sulfur components in liquid fuels should be controlled due to environmental issues and process considerations. In order to decrease the level of sulfurous compounds in crude gas-oil with 5750 ppmw sulfur, electrochemical oxidative desulfurization has been investigated over electrodes of copper and stainless steel because of their easy operation and mild process conditions. In this research, the effects of stirring rate, temperature, applied potential, sodium hydroxide addition as electrolyte media and water volume have been examined on the sulfur removal efficiency. The results show that electrical conductivity of gas-oil sharply increases with addition of electrolyte up to 613... 

The alkaline treatment condition plays a crucial role in governing the ultimate properties of flax fibers. In this study, flax fibers were modified with mild alkalization and severe mercerization conditions to give fundamental insight into how the molecular-scale changes in cell wall fine structure and cellulose supramolecular structure can affect the macroscopic properties of fibers. SEM, FTIR, XRD, TGA, and DSC techniques were employed to characterize the variations in morphology, composition, crystalline structure, and thermal properties of fibers. Also, tensile tests evaluated their reinforcing performance in polypropylene-based composites. The results indicated that alkalization in 5%... 

In this research, carbon nanotube decorated with Cu nanoparticles (CNT/Cu) was synthesized by a new solvothermal process. Solvothermal treatment of CuSO4 and NaOH was completed in ethanol containing ultrasonically dispersed CNTs at 160 °C for 3 h. In the solvothermal process, Cu nanoparticles were heterogeneously deposited on the surface of COOH-functionalized CNTs through the reduction of the Cu+2 ions. Cu nanoparticles with the size of ≈8 nm on CNTs (and some in the solution) and strong bonding between Cu and CNT were obtained by the used process. Microstructural characterization revealed that the solvothermal method is an appropriate method for producing homogenous CNT/Cu nanostructure.... 

Hand in hand with the flourish of the biodiesel industry, glycerol (GLY) as an inconvenient by-product has generated environmental and sustainability concerns. Devising measures for efficient transformation of GLY into value-added products is a promising solution. In this contribution, the transformation of GLY to lactic acid (LA) as a valuable chemical was investigated in a continuous process for industrial applications. In this regard, a catalytic method using heterogeneous Cu nanoparticles in NaOH solution was studied in a microreactor by a CFD simulation. A seven-inlet micromixer comprising an optimized mixing unit was incorporated for uniform distribution of the species. The effects of... 

Precious metal-free electrocatalysts based on two-dimensional nanomaterials have efficiently been used for oxygen evolution reaction; however, the low activity and stability of these materials as compared with noble metals are still distractive. We present a novel and high-performance electrocatalyst based on nanowires of mixed transition metal oxysulfide supported by three-dimensional highly porous graphene networks. Electrochemical studies indicated that the high electron transport medium of nanowires and bilayer graphene nanosheets as well as their high active surface area promote the kinetics of oxygen evolution reaction (OER). A quite small overpotential of 260 mV at the current density... 

In this study, a series of highly swelling hydrogels based on sodium alginate (NaAlg) and polymethacrylamide (PMAM) was prepared through free radical polymerization. The graft copolymerization reaction was performed in a homogeneous medium and in the presence of ammonium persulfate (APS) as an initiator and N,N'-methylenebisacrylamide (MBA) as a crosslinker. The crosslinked graft copolymer, alginate-graft-polymethacrylamide (Alg-g-PMAM), was then partially hydrolyzed by NaOH solution to yield a hydrogel, hydrolyzed alginate-graft-polymethacrylamide (H-Alg-g-PMAM). During alkaline hydrolysis, the carboxamide groups of Alg-g-PMAM were converted into hydrophilic carboxylate anions. Either the... 

To reduce the sulfur content of crude diesel, several sets of experiments have been conducted using electrochemical oxidative desulfurization technique using electrolyte of NaOH at different applied voltages. Due to impacts of operating parameters on desulfurization, kinetic study is pursued and it is found that the kinetic follows a second order reaction rate with a high accuracy. The reaction of desulfurization was modeled using COMSOL and followed by coupled electrochemical oxidation-extraction, while the extraction process was particularly performed using process simulator. The effects of different solvents on extraction performance were studied and dimethyl sulfoxide was selected for... 

Owing to its dual role as a hormone and neurotransmitter, norepinephrine (NE) detection is of great significance to biomedical diagnosis. In the present work, we have explored intense green fluorescence of poly (norepinephrine) (PNE) nanoparticles synthesized by oxidizing NE in alkaline condition, in combination with red fluorescent bovine serum albumin-stabilized gold nanoclusters (BSA-AuNCs) for naked-eye detection of NE. The effect of sodium hydroxide on the emission behavior of NE was studied. The surface morphology and optical properties of PNE nanoparticles were characterized by UV–Vis, fluorescence, FTIR, Transmission Electron Microscopy (TEM) and Dynamic Light Scattering (DLS)... 

In this paper, the optimum alkali activator solution properties in alkali-activated pastes based on ground granulated blast furnace slag (GGBFS) and micro-silica (MS) were investigated. For this purpose, sodium hydroxide (NH) solutions with molarities of 8 M, 12 M, and 16 M were prepared and mixed with sodium silicate (NS) solutions at NS:NH ratios of 1.0, 2.5, and 4.0 to produce the final activator solution. Two sets of pastes were manufactured: (1) pastes based on GGBFS, and (2) pastes in which 10% by weight of GGBFS was replaced with MS. The fresh density increased with increasing NH molarity and NS:NH ratio; whereas, the final setting time reduced with an increase in the aforementioned... 

Copper slag (CS) is an industrial waste, which is generally disposed of in landfills, posing threats to the environment. Alternatively, it can be used as natural aggregate replacement in concrete/mortar, however, it results in a significant increase in material density, production and handling cost. The use of crumb rubber in combination with CS can overcome these problems, but there was no prior study on effect of such combination on the properties of alkali activated mortars (AAMs). The primary aim of this study is to address the problem stated above by replacing CS with 5, 10, 15% (by volume) crumb rubber in alkali-activated slag mortars. Furthermore, the effect of pre-treatment of crumb... 

In this research, we investigate the effect of alkali metal cations including Li, Na and Cs in hydrothermal solution on the morphology, stability, and photoactivity of nanostructured TiO2 nanoflakes as a photoanode. The TiO2 nanoflakes are formed through hydrothermal treatment of Ti foil in 1.0 M LiOH, NaOH or CsOH at 100 °C for 3 h. By subsequent thermal reduction of the structure in an optimized Ar/H2 environment, conductive TiO2 nanoflakes were formed. The reduction treatment remarkably improves the photocurrent density of the TiO2 nanoflakes and has the highest impact on the sample treated in the NaOH alkali solution. For the nanoflakes produced in NaOH alkali solution, the bandgap is... 

The development of noble-metal-free electrocatalysts with enhanced active sites is of great significance for the production of renewable energy on large scale. Ultrathin transition metal compounds (e.g., phosphides and sulfides) have unique structural features but their stability and electroactivity must still be improved for practical applications. We propose a new strategy to synthesis ultrathin sheets of Ni-Cu-Co transition metals on porous nickel and self-assemble them into yarn-shaped microspheres. Enhance catalytic activity and stability are then attained by thermochemical phosphorization without morphological modifications. We employed various analytical techniques including XRD, SEM,... 

This study was aimed at evaluating the effects of alkali activator solution and utilization of silica fume (SF) on durability and microstructural characteristics of alkali-activated ground granulated blast furnace slag (GGBFS) pastes. The pastes were activated with sodium silicate (SS) blended with NaOH (SH) solution with molar concentrations of 8 M, 12 M, and 16 M and SS:SH ratios of 1.0, 2.5, and 4.0. The same mixes were prepared with SF as partial replacement of GGBFS at a dosage of 10% by weight. The initial and final water absorption as well as the electrical resistivity of the specimens were measured. The optimal paste fabricated with 12 M NaOH solution and SS:SH ratio of 2.5 showed...