Sharif Digital Repository

Carbon nanotubes (CNTs) were synthesized via arc discharge in aqueous solutions containing ferrous and ferric irons to reveal the effect of iron-charge mole ratio, R = [Fe2+]/[Fe3+], on the purity of CNTs and the process yield. Raman spectroscopy and transmission electron microscopy were used to analyze the cathodic deposits. It is shown that the nucleation of multi-walled CNTs is catalyzed by ferric irons while their growth is affected by ferrous ions. Well-graphitized CNTs with a high-yield are obtained at R = 1 and total iron concentration of 0.05 M. The effect of iron charge is described based on the two-stage formation mechanism  

Carbon nanotubes (CNTs) were synthesized via arc discharge in aqueous solutions containing ferrous and ferric irons to reveal the effect of iron-charge mole ratio, R = [Fe 2+]/[Fe 3+], on the purity of CNTs and the process yield. Raman spectroscopy and transmission electron microscopy were used to analyze the cathodic deposits. It is shown that the nucleation of multi-walled CNTs is catalyzed by ferric irons while their growth is affected by ferrous ions. Well-graphitized CNTs with a high-yield are obtained at R = 1 and total iron concentration of 0.05 M. The effect of iron charge is described based on the two-stage formation mechanism  

The primary challenge of spectroscopic techniques in selective detection and characterization of tautomeric structures of DNA and RNA bases, and moreover, the accurate interpretation and explanation of the experimental results are the main motives of theoretical studies. Surface-enhanced Raman spectroscopy (SERS) can be a powerful approach to distinguish cytosine in the presence of its tautomers. For this respect, herein, the theoretical simulation of the SERS spectra of cytosine and its three most stable tautomers adsorbed on silver clusters is carried out. The calculations of SERS spectra is based on the excited-state energy gradient approximation as a well-established approach that gives... 

We have investigated the surface-enhanced resonance Raman spectroscopy (SERRS) for 4,4′-diaminotolane absorbed on silver experimentally and theoretically. Experimental observation shows greatly enhanced bg symmetric modes ν26 and ν27, which are silent in normal Raman spectroscopy and SERS on gold. The dependence of the surface-enhanced Raman spectroscopy (SERS) spectra on five excitation lines has also been registered and classified for single bands into three profiles referring to the different contributions of resonant transitions. Theoretical calculations based on the time-dependent path integral formalism by including the Herzberg-Teller correction reproduce the experimental spectra with... 

This research focused on fabrication of various carbon nanofibers (CNFs) from electrospun Polyvinyl alcohol (PVA) by utilization of iodine (I2) and cadmium acetate dihydrate (Cd) as stabilizers. Moreover, the influence of carbon nanotube (CNT) incorporation on structure and morphology of CNFs was investigated. In this regard, PVA and PVA-Cd solutions were individually prepared and electrospun. The resulting nanofibers were treated in I2 vapor and then carbonized. In the case of CNT incorporation, oxidized CNTs were first scattered in PVA and PVA-Cd solutions and then electrospun, iodinated and carbonized in the same conditions as mentioned above. It was found that the I2, Cd and their... 

Surface-enhanced Raman spectroscopy is a highly sensitive phenomenon and a powerful fingerprint detection tool that reflects the small changes in polarizability on the pattern and intensity of Raman signals. The SERS enhancement signals elucidate with the surface-selection rules. In this regard, molecular configuration and adsorption orientation on the surface, in addition to the direction of external electric field, can lead to different patterns of SERS spectra. To evaluate how the variation of these features influences the pattern and reproducibility of the spectra, the chemical charge-transfer SERS spectra for pyridine on silver clusters are calculated for different field directions,... 

Surface-Enhanced Raman Spectroscopy (SERS) is a sensitive vibration spectroscopy method applied to analyze a variety of analytes, including toxins and pesticides. The SERS method is an accurate method for detecting significantly low concentrations of biomaterials and chemicals. In the present study, in order to detect atrazine pesticide, the glass fiber substrates coated with silver nanoparticles have been used as SERS plasmonic nanosensors. First, silver nanoparticles were prepared by applying a chemical approach named the Tollens' method, and the SERS plasmonic substrates (SPS) were fabricated by depositing the colloidal silver solution on a glass fiber substrate. The SERS plasmonic... 

Graphene nanoribbons (GNRs) fabricated using electron beam lithography are investigated using tip-enhanced Raman spectroscopy (TERS) with a spatial resolution of 5 nm under ambient conditions. High-resolution TERS imaging reveals a structurally modified 5-10 nm strip of disordered graphene at the edge of the GNRs. Furthermore, hyperspectral TERS imaging discovers the presence of nanoscale organic contaminants on the GNRs. These results pave the way for nanoscale chemical and structural characterisation of graphene-based devices using TERS. © The Royal Society of Chemistry 2021  

Betaine-based natural deep eutectic solvents (NADESs), a new class of green solvents, were immobilized into a porous polyvinylidene fluoride (PVDF) support and evaluated for the separation of CO2 from CO2/N2 and CO2/CH4 mixtures. Two types of NADESs were synthesized by mixing betaine (hydrogen bond acceptor-HBA) with malic acid and tartaric acid (hydrogen bond donors-HBD) respectively. FTIR and Raman spectroscopy were studied to confirm the synthesis and purity of the NADESs. The thermal strength of the NADESs was investigated using thermogravimetric analysis. The gas permeation results of the fabricated NADES-based-supported liquid membranes (NADES-SLMs) showed that the permeability of CO2... 

We proposed a new method for Non-invasive measuring of blood glucose levels by using micro sphere Stimulated Raman scattering. We show that this method can be used to measure biological glucose levels with low power lasers. The field enhancement due to the resonance condition of high quality factor microsphere causes to reduce stimulated Raman scattering thresholds of its surrounding media (glucose) and hence observing stimulated Raman scattering with low power. The results from theoretical studies indicate that the stimulated Raman signal amplitude levels produced from the very low Glucose concentrations. By measuring the changes of the signal intensity in output of fiber, we can determine... 

This work presents the synthesis of nanostructured hollow polyaniline (PANI) capsules and their application for encapsulation of corrosion inhibitor 2-Mercaptobenzothiazole (MBT). The pH-triggered release of MBT from the capsules was evidenced using UV–vis and Surface Enhanced Raman Spectroscopy (SERS). Incorporation of MBT loaded PANI capsules into epoxy ester coating on AA2024-T3 resulted in a protective system with self-healing ability confirmed by Electrochemical Impedance Spectroscopy (EIS) and Scanning Vibrating Electrode Technique (SVET). The results showed that the incorporation of MBT-loaded PANI capsules into the coating has significantly improved its corrosion protection... 

A green and simple synthesis method based on a two-step chemical vapor deposition approach has been developed to synthesize transition metal dichalcogenides flakes. With non-toxic precursor such as transition metal oxides and elemental sulfur, large-area, strong photoluminescent and uniform MoS2 nanoflakes were produced at a relatively low growth temperature (650 °C). Controlling the layer number and morphology was achieved only by precursor concentration without any oxide impurity revealed by SEM, PL and Raman spectroscopy. This method can be used to make wide range of metal chalcogenides such as ZnS, SnS2, PtS2 and PdS2  

An easy method for green and low-temperature (40 °C) reduction of graphene oxide (GO) by increasing the antioxidant activity of green tea polyphenols (GTPs) in the presence of iron was developed. The reduction level (obtained by X-ray photoelectron spectroscopy) and electrical conductivity (obtained by current-voltage measurement) of the GO sheets reduced by GTPs in the presence of iron were comparable to those of hydrazine-reduced GO and much better than those of the GO reduced by only GTPs (in the absence of iron) at reduction temperatures of 40-80 °C. Raman spectroscopy indicated that application of GTPs in the presence of iron, in contrast to hydrazine, resulted in better recovering of... 

Interactions of chemically exfoliated graphene oxide (GO) nanosheets and Escherichia coli bacteria living in mixed-acid fermentation with an anaerobic condition were investigated for different exposure times. X-ray photoelectron spectroscopy showed that as the exposure time increased (from 0 to 48 h), the oxygen-containing functional groups of the GO decreased by ∼60%, indicating a relative chemical reduction of the sheets by interaction with the bacteria. Raman spectroscopy and current-voltage measurement confirmed the reduction of the GO exposed to the bacteria. The reduction was believed to be due to the metabolic activity of the surviving bacteria through their glycolysis process. It was... 

Graphene is usually synthesized through deoxygenation of graphene oxide (GO) by hydrazine as the most common and one of the strongest reducing agents. But, due to the high toxicity of hydrazine, it is not a promising reductant in large-scale production of graphene. Here, for the first time, we used melatonin (MLT), as a powerful antioxidant and a biocompatible competitor of hydrazine in reduction of GO suspension. X-ray photoelectron spectroscopy (XPS), current-voltage and optical characteristics of the sheets indicated that the deoxygenation efficiency of the GO suspensions by MLT and under heating in an alkaline condition for 3 h was comparable with the efficiency obtained by hydrazine in... 

TiO2 nanoparticles were physically attached to chemically synthesized single-layer graphene oxide nanosheets deposited between Au electrodes in order to investigate the electrical, chemical, and structural properties of the TiO2/graphene oxide composition exposed to UV irradiation. X-ray photoelectron spectroscopy showed that after effective photocatalytic reduction of the graphene oxide sheets by the TiO2 nanoparticles in ethanol, the carbon content of the reduced graphene oxides gradually decreased by increasing the irradiation time, while no considerable variation was detected in the reduction level of the reduced sheets. Raman spectroscopy indicated that, at first, the photocatalytic... 

In this study by Thermal Chemical Vapor Deposition (TCVD) method, the synthesis of carbon nanotubes (CNTs) and temperature affects on the grown CNTs on the NiSio2 catalyst and 304-type stainless steel was investigated. The purification of the grown CNTs on the 304-type stainless steel was also investigated in this study. The synthesis and purification of the samples were characterized by scanning electron microscope (SEM), transmission electron microscope (TEM), termogravimetric analysis (TGA) and Raman spectroscopy. Our obtained result by SEM and TEM shows that densities of CNTs growth on the 304-type stainless steel are more than the CNTs growth on the NiSio2 catalyst and both of them have...