Sharif Digital Repository

Interactions of two distinct shapes of the pulses namely positive/negative chirped pulse and fast/slow rising-edge pulse with plasma are studied using particle-in-cell simulation. It is found that, for a pulse duration of 34 fs and intensity a0 = 12, proton acceleration could be enhanced by asymmetric pulses with either pulse envelope or pulse frequency modification. The number of accelerated protons, as well as the proton energy cut-off, is increased by asymmetric pulses. In this work, for positive chirped pulse, electrostatic field at the rear side of the target is improved by about 30%, which in turns leads to an increase in the proton energy cut-off more than 40%. Moreover, in contrary... 

The amount of stored energy is an important issue in the low-droop and high-precision pulse generation. Pulse forming network (PFN) simulating an open-ended transmission line seems to be useful due to its minimum stored energy. The drawbacks of the PFN include low-output pulse quality and constant pulsewidth, which limit their applications. Another limitation of generating rectangular pulses using PFN is that half of the charged voltage appears in the output when delivering the entire stored energy to the matched load. This paper proposes a structure of PFN-based pulse generator that overcomes the above-mentioned limitations. For continuous pulsewidth adjustment, a lossless scheme is... 

The power supply of microwave tubes has high voltage and the possibility of produce high power pulse, which called in modulator. In this work, the results of design, construction and characterization of a direct drive pulse modulator for driving high power short pulse-width magnetron are reported. The sub-assemblies of modulator are; a primary high voltage supply, a switch bank with drivers and snubber circuits, a filament circuit, a digital control circuit with sensors and finally a pulse transformer. This paper is concerned with introduction and presentation of experimental evaluation of a new drive method for high power high voltage modulating-cathode microwave tubes. ©2009 IEEE  

The multielectron dissociative ionization of CH4 and CH2O molecules has been investigated using optimum convolution of different dual tailored short laser pulses. Based on three dimensional molecular dynamics simulations and TDDFT approach, the dissociation probability is enhanced by designing the dual chirped-chirped laser pulses and chirped-ordinary laser pulses for formaldehyde molecule. However, it is interesting to notice that the sensitivity of enhanced dissociation probability into different tailored laser pulses is not significant for methane molecule. In this presented modifications, time variation of bond length, velocity, time dependent electron localization function and evolution... 

This letter presents a novel method based on sparsity, to solve the problem of deinterleaving pulse trains. The proposed method models the problem of deinterleaving pulse trains as an underdetermined system of linear equations. After determining the mixing matrix, we find sparsest solution of an underdetermined system of linear equations using basis pursuit denoising. This method is superior to previous ones in a number of aspects. First, spurious and missing pulses would not cause any performance reduction in the algorithm. Second, the algorithm works well despite the type of pulse repetition interval modulation that is used. Third, the proposed method is able to separate similar... 

In this study WO x films were deposited by laser ablation of ultra-pure (5N) tungsten trioxide targets onto SiO2 or silicon substrates at 250°C temperature, 100 mTorr oxygen partial pressure and 1×10-5 Torr vacuum. Surface chemical states and compositions of the deposits were determined by X-ray photoelectron spectroscopy. The results showed that deposits in oxygen partial pressure contain W6+ with x ∼ 3.1, while vacuum-deposited films have different W states with various percentage distributions as W4+>W5+>W 6+>W0, and x ∼ 1. We used fast electrical resistance measurement as a probe to study the deposition process. Film resistance as a function of deposition time in vacuum revealed some... 

Methane reforming by carbon dioxide in pulsed glow discharge at atmospheric pressure is examined. The plasma pulse is compressed to less than 50 ns. This compression enables one to work at higher frequencies, over 3 kHz, without glow-arc transition. The main products of the reaction are synthetic gases (H2, CO) and C2 hydrocarbons. Approximately 42% of plasma energy goes to the chemical dissociation, when the reactant ratio is C O2 C H4 =1. At this point, the energy expense is less than 3.8 eV per converted molecule while reactant conversions are relatively high reaching to 55% (C H4) and 42% (C O2). The reactor energy performance even gets better at higher C O2 C H4 ratios. While energy... 

[No abstract available]  

In this study, the authors study a fibre-optic local area network deploying optical code division multiple access technique with differential M-ary pulse position modulation (DPPM). The authors present the performance analysis of DPPM signalling using a double optical hardlimiter receiver structure considering the impairment caused by interference of other users. The analysis assumes a set of bit asynchronous transmitters employing generalised optical orthogonal codes for their DPPM signalling (GOOC-DPPM). Using mathematical analysis and simulations, the authors have demonstrated that GOOCDPPM improves both frame error probability and the maximum achievable network throughput compared with... 

Flow mediated dilation (FMD) is a non-invasive method for endothelial function assessment providing an index extracted from ultrasonic B-mode images. Although utilized in the research community, the difficulty of its application and high cost of ultrasonic devices prevent it from being widely used in clinical settings. In this study we show that substituting the ultrasonic device with more easily handled and low cost photoplethysmography and electrocardiography is possible. We introduce new indices based on the photoplethysmogram (PPG) and electrocardiogram (ECG) and show that they are correlated with the ultrasound-based FMD Index. To this end, a conventional ultrasound FMD test was carried... 

In this paper, we have studied the properties of SrTiO3 thin films which have been deposited on Si/Ti/Pt substrates using pulsed laser deposition technique. The as-deposited films were annealed at temperature of 700 °C in oxygen environment for 1 h. The surface morphology, crystalline phase and chemical composition of the films were characterized by AFM, XRD and XPS techniques, respectively. The XRD data show that phase transition from amorphous to polycrystalline structure happens and also the lattice constant enhances during annealing process. This enhancement can be related to oxygen vacancies in thin films. The XPS data show partial lack of titanium atoms on the surface. The AFM analysis... 

Optimum operating parameters for pulse co-deposition of nano-Al2O3 with Cr from a trivalent chromium bath onto Cu cathode are selected by using “technique for order performance by similarity to ideal solution” (TOPSIS), “VIšekriterijumsko KOmpromisno Rangiranje” (VIKOR), “elimination and choice expressing the reality” (ELECTRE) and “complex proportional assessment” (CORPAS) accompanied with analytic hierarchy processing (AHP) to compare methods for achievement of the best tribological coating performance. Criteria for appropriate selection include wear loss, corrosion resistance, micro-hardness, bath condition and current efficiency. Results ascertain the best Cr–Al2O3 nano-composite coating...