Sharif Digital Repository

Polypropylene matrix nanocomposites reinforced with organoclay are investigated and their ability to replace some polyamide automotive parts is evaluated. This is so interesting from industrial point of view because of cost saving and ease of processing and recycling. This work is focused on different nanocomposite systems which are PP/nanoclay, and PP/PA/nanoclay. Also the effect of compatibilizer is presented here. Structure of these systems are studied by using WAXD, TEM and SEM. Mechanical properties of specimens are studied using uniaxial tensile test. As it will be demonstrated, nanoclay sheets tend to disperse in PA particles. On the other hand, introducing nanoclay into PP/PA blends... 

Ternary nanocomposites of polypropylene/polyamide 6/layered silicate were prepared through three different processing procedures. X-ray diffraction and transmission electron microscopy were used to study the nanostructure of the samples, and tensile and impact strength measurements were conducted to assess the mechanical properties. It was shown that processing route has a significant effect on the delamination of clay platelets. Fully exfoliated nanostructure was achieved through a certain two-step processing route. Compatibilization of the blends affected microstructure as well as nanostructure. Mechanical properties were affected by changing the processing route, to a great degree.... 

In this article, preparation of polypropylene/clay nanocomposites (PPCNC) via in situ polymerization is investigated. MgCl2/montmorillonite bisupported Ziegler-Natta catalyst was used to prepare PPCNC samples. Montmorillonite (MMT) was used as an inert support and reinforcement agent. The nanostructure of the composites was characterized by X-ray diffraction, scanning electron microscopy, and transmission electron microscopy techniques. Obtained results showed that silica layers of the MMT in these PPCNC were intercalated, partially exfoliated, and uniformly dispersed in the polypropylene matrix. Thermogravimetric analysis showed good thermal stability for the prepared PPCNC. Differential... 

This work aims to investigate the structure-property relationship in ternary nanocomposites consisting of polypropylene as the matrix, nanoclay as the reinforcement and polyamide 6 as the intermediate phase. In this regard, composites of polypropylene/organoclay, polyamide/organoclay, blends of polypropylene/polyamide, and ternary nanocomposites of polypropylene/polyamide/layered silicate with and without compatibilizer were produced via melt compounding. Nanostructure was investigated by wide-angle X-ray diffraction and transmission electron microscopy. Scanning electron microscopy was employed to study the microstructure. Modulus of elasticity and yield strength were measured by uniaxial...