Sharif Digital Repository

An indirect colorimetric method is presented for spectrophotometric determination of hydrazine, phenylhydrazine, and isoniazid. Reduction of silver ions to silver nanoparticles (AgNPs) by these analytes as active reducing agents in the presence of polyvinylpyrrolidone (PVP) and also cetyltrimethylammonium chloride (CTAC) as a stabilizer is the basis of the proposed method. The changes in plasmon absorbance of the AgNPs at λ = 415 nm in the presence of PVP were proportional to concentration of hydrazine, phenylhydrazine, and isoniazid in the ranges of 4.0-150.0 μM, 1.0-55.0 μM, and 2.0-30.0 μM, respectively, and the detection limit obtained was 0.79 μM. In the presence of CTAC, the linear... 

With the spread of deadly diseases worldwide, the design of rapid tests to identify causative microorganisms is necessary. Due to the unique properties of gold nanoparticles, these nanoparticles are used in designing rapid diagnostic tests, such as strip tests. The current study aimed to investigate the ability of gold nanoparticles to bind to single-chain variable fragment antibodies. In this study, the biological and chemical methods included Escherichia coli TOP-10 and the Turkevich method to synthesize the gold nanoparticles, respectively. Then, the effect of synthetic nanoparticles on their capability of binding to recombinant antibodies was assessed by agarose gel and UV-vis... 

Synthesis and immobilization of Au nanoparticles (AuNPs) was performed on transparent fluorine-doped tin oxide (FTO) substrate by pulse electrodeposition method. The method was cost effective, simple and capable of producing nanoparticles strongly attached to the substrate. Effects of several influencing factors such as duty cycle, pulse frequency, current density, solution concentration, deposition period and annealing procedure on the optical properties of AuNPs-FTO electrode were investigated. AuNPs-FTO electrodes were characterized by X-ray diffraction (XRD), field emission scanning electron microscopy (FESEM), atomic force microscopy (AFM) and UV-Vis absorption analysis. Controllability... 

A facile, straightforward, and low-cost method is proposed to synthesize gold@silver@gold core double-shell nanoparticles. The technique is a seed-mediated growth protocol that contains four steps of (1) gold seed synthesis, (2) gold seed growth, (3) silver layer coating through silver salt reduction, and (4) gold layer deposition via gold precursor reduction. The prepared nanoparticles had a narrow size distribution and the average particle size of 28 ± 1 nm. Cysteine was introduced to the nanoparticles solution as a coupling agent to assemble nanoparticles. Aggregation-induced two-photon photoluminescence enhancement of three types assembled nanoparticles, i.e., gold@silver@gold,... 

In this paper, we present a detailed analysis of a two-dimensional lossless and non-dispersive structured conducting interface, which is approximated by a two-dimensional ideal one-component plasma-like conducting sheet enclosed by two isotropic dielectrics. We present a Green's function formalism to analyze the propagation of surface plasmons and find new expressions. We also present analytical extensions of the approach to include loss, and discuss the results and applications of the theory. We study the symmetry properties of eigenmodes and show that the symmetries of the eigenmodes at high-symmetry points of the Brillouin zone are similar to those of the E-polarization eigenmodes of a... 

Copper nanorods have been synthesized by electrodeposition with different lengths in porous polycarbonate (PCT) membranes with a pore diameter of 50nm and a thickness of 4νm. The PCT membranes were dissolved in dichloromethane (CH2Cl2) and the solvent was replaced by methanol solutions. Extinction peaks at 587, 581 and 574nm were observed for the Cu nanorods with aspect ratio R = 6,8 and 10 in methanol, respectively. Polarization of the molecules of the medium around the wires changes the dielectric constant of the medium. Hence, the wavelength of the extinction peaks does not shows good agreement with calculations that were done on basis of Gans' theory with nominal dielectric constant of... 

As developed countries’ ability to control infectious diseases increases, it has become clear that genetic diseases are a major cause of disability, death, and human tragedy. Coronavirus has recently spread throughout the world, and the capacity to detect low concentrations and virus changes can help to prevent the sickness from spreading further. In this paper, a surface plasmon resonance sensor based on nanostructured thin films and graphene as a 2D material has been designed with high sensitivity and accuracy to identify DNA-based infectious diseases such as SARS-CoV-2. The transfer matrix method assesses the effects of different structural factors, including nanolayer thickness on the... 

A highly sensitive and simple indirect spectrophotometric method has been developed for the determination of trace amounts of inorganic mercury (Hg2 +) in aqueous media. The method is based on the inhibitory effect of Hg2 + on the activity of horseradish peroxidase (HRP) in the oxidation of ascorbic acid by hydrogen peroxide followed by the reduction of Au3 + to Au-NPs by unreacted ascorbic acid and the measurement of the absorbance of localized surface plasmon resonance (LSPR) peak of gold nanoparticles (at 530 nm) which is directly proportional to the concentration of Hg2 +. Under the optimum conditions, the calibration curve was linear in the concentration range of 1-220 ng mL- 1. Limits... 

We explore whether localized surface plasmon polariton modes can transfer heat between molecules placed in the hot spot of a nanoplasmonic cavity through optomechanical interaction with the molecular vibrations. We demonstrate that external driving of the plasmon resonance indeed induces an effective molecule-molecule interaction corresponding to a heat transfer mechanism that can even be more effective in cooling the hotter molecule than its heating due to the vibrational pumping by the plasmon. This mechanism allows us to actively control the rate of heat flow between molecules through the intensity and frequency of the driving laser. © 2019 American Physical Society  

A naked-eye (equipment-free), label-free (cost-effective), and RNA extraction-free (to speed up) method for SARS-CoV-2 (as a case study of RNA viruses) detection is developed. Here, the DNA is being used as a template for in situ formation of anisotropic gold nanoparticles (AuNPs) without any chemical modification or DNA labeling. In this study, synthesized AuNPs for the direct detection of N-gene (nucleocapsid phosphoprotein) of SARS-CoV-2 are exploited. To this aim, antisense oligonucleotides (ASOs) with an extra poly guanine tail (G12) were designed. Thus, in the presence of its viral target RNA gene and ASOs@AuNPs-RNA hybridization, there was a red shift in its localized surface plasmon... 

A seeding-growth approach was used to prepare Au@Ag@Au core double shell nanoparticles which were loaded on a rutile-nanorods/anatase-nanobranches thin film via the impregnation method. The thin film was synthesized on a fluorine-doped SnO 2 substrate via three stages of (i)TiCl 4 treatment, (ii)hydrothermal, and (iii)aqueous chemistry. The photocatalytic capability of the newly developed nanostructure was higher than P25 TiO 2 thin film by 40% under visible light and by 100% under UV light irradiation. Photogenerated charges separation at the junctions of rutile-nanorods and anatase-nanobranches along with localized surface plasmon resonance followed by the hot electron transfer from the... 

In this paper, the excitation of surface waves in the presence of interface charges is discussed. Interface charges affect the dispersion of surface waves, and therefore they can be used in various applications such as optical modulators, switches, sensors and filters. These waves can be superior to surface plasmon waves since they are not lossy. The lossless property is satisfied in a limited range of millimetre waves to far infrared  

Co-deposition of RF-sputtering and RF-PECVD from acetylene gas and Au target were used to prepare sensor chip of gold nanoparticles (Au NPs). Deposition conditions were optimized to reach a Localized Surface Plasmon Resonance (LSPR) sensor chip of Au NPs with particle size less than 10 nm. The RF power was set at 180 W and the initial gas pressure was set at 0.035 mbar. Transmission Electron Microscopy (TEM) images and Atomic Force Microscopy (AFM) data were used to investigate particles size and surface morphology of LSPR sensor chip. The Au and C content of the LSPR sensor chip of Au NPs was obtained from X-ray photoelectron spectroscopy (XPS). The hydrogenated amorphous carbon (a-C:H)... 

A novel glucose biosensor based on chromophore (silver nanoparticles) decolorizing for the photometric determination of glucose was developed. Silver nanoparticles are directly synthesized in the sol-gel matrix by a one-step method based on the reduction of the inorganic precursor AgNO3 and were used for the preparation, characterization and calibration of a highly sensitive and cost-effective localized surface plasmon resonance-based glucose biosensor. In the presence of glucose oxidase (GOx) and due to the enzyme-substrate (glucose) reaction, H2O2 was produced and silver nanoparticles in the sol-gel glass have the ability for the decomposition of hydrogen peroxide. Due to the degradation... 

Spectrophotometric analysis method based on the combination of the principal component analysis (PCA) with the feed-forward neural network (FFNN) and the radial basis function network (RBFN) was proposed for the simultaneous determination of paracetamol (PAC) and p-aminophenol (PAP). This technique relies on the difference between the kinetic rates of the reactions between analytes and silver nitrate as the oxidizing agent in the presence of polyvinylpyrrolidone (PVP) which is the stabilizer. The reactions are monitored at the analytical wavelength of 420 nm of the localized surface plasmon resonance (LSPR) band of the formed silver nanoparticles (Ag-NPs). Under the optimized conditions, the... 

When illuminated by TM polarized waves, periodic arrays of graphene ribbons are known to exhibit plasmonic resonances due to their dual inductive-capacitive nature. It is demonstrated here that even in TE polarization, resonances can be observed in these structure. These resonances, which are of nonplasmonic origin, are explained by means of a circuit model. It is shown that, for a certain frequency range, arrays of graphene ribbons have both capacitive and inductive properties, which lead to an ultra-sharp inductor-capacitor resonance. The banw idth of this resonance can be as narrow as ∼0.0002 nm at a wavelength of 630 nm. The resonance can also be viewed as the grating excitation of a TE... 

The aim of this review is to cover advances in noble metal nanoparticle (MNP)-based biosensors and to outline the principles and main functions of MNPs in different classes of biosensors according to the transduction methods employed. The important biorecognition elements are enzymes, antibodies, aptamers, DNA sequences, and whole cells. The main readouts are electrochemical (amperometric and voltametric), optical (surface plasmon resonance, colorimetric, chemiluminescence, photoelectrochemical, etc.) and piezoelectric. MNPs have received attention for applications in biosensing due to their fascinating properties. These properties include a large surface area that enhances biorecognizers... 

Microfluidic systems (MFS) provide a range of advantages in biomedical applications, including improved controllability of material characteristics and lower consumption of reagents, energy, time and money. Fabrication of MFS employs various materials, such as glass, silicon, ceramics, paper, and metals such as gold, copper, aluminum, chromium and titanium. In this review, gold thin film microfluidic channels (GTFMFC) are discussed with reference to fabrication methods and their diverse use in chemical and biomedical applications. The advantages of gold thin films (GTF) include flexibility, ease of manufacture, adhesion to polymer surfaces, chemical stability, good electrical conductivity,... 

In this work, formation of gold nanoparticles in radio frequency (RF) reactive magnetron co-sputtered Au-SiO 2 thin films post annealed at different temperatures in Ar + H 2 atmosphere has been investigated. Optical, surface topography, chemical state and crystalline properties of the prepared films were analyzed by using UV-visible spectrophotometry, atomic force microscopy (AFM), X-ray photoelectron spectroscopy (XPS) and X-ray diffractometry (XRD) techniques, respectively. Optical absorption spectrum of the Au-SiO 2 thin films annealed at 800 °C showed one surface plasmon resonance (SPR) absorption peak located at 520 nm relating to gold nanoparticles. According to XPS analysis, it was... 

Colloidal copper nanoparticles were prepared by pulsed Nd:YAG laser ablation in water and acetone. Size and optical properties of the nanoparticles were characterized by transmission electron microscopy and UV-visible spectrophotometry, respectively. The copper particles were rather spherical and their mean diameter in water was 30 nm, whereas in acetone much smaller particles were produced with an average diameter of 3 nm. Optical extinction immediately after the ablation showed surface plasmon resonance peaks at 626 and 575 nm for the colloidal copper in water and acetone, respectively. Time evaluation showed a blue shift of the optical extinction maximum, which is related to the change of...