Loading...
Search for:
near-miscible-condition
0.012 seconds
Experimental and Modeling Study of Two-Phase Relative Permeability at Near Miscible Condition
, M.Sc. Thesis Sharif University of Technology ; Masihi, Mohsen (Supervisor) ; Ghazanfari, Mohammad Hossein (Supervisor) ; Rasaei, Mohammad Reza (Supervisor)
Abstract
One of the main parameters in modeling of two phase gas and oil flow is an accurate relative permeability functions. This importance will be more intensified when the miscibility condition approaches. In miscible condition due to reduction of interfacial tension between oil and gas phases, parameters of conventional relative permeability functions will change and this changing affects on production results such as oil and gas recovery and also pressure drop along the core. All of the previous studies could not present a unique and consistent model to show the effect of near miscibility condition on relative permeability curves. In this work, these changing of parameters will be investigated...
Experimental and Modeling Study of Gas/WAG Injection at Near Miscible Condition in One of Iranian Oil Reservoirs
,
M.Sc. Thesis
Sharif University of Technology
;
Ghazanfari, Mohammad Hossein
(Supervisor)
;
Massihi, Mohsen
(Supervisor)
Abstract
Most of the Iranian oil reservoirs are reaching end of their natural production life, hence they are suitable candidates for EOR common processes like gas injection and WAG injection. Studies have shown that gas and WAG injection can be applied for optimal oil production. Past studies have been mainly on gas and WAG injection in immiscible or fully miscible conditions and there is a limited amount of data available on performance of these methods in near miscible conditions. Miscible injection is not feasible in old Iranian oil reservoirs due to their depleted pressure. Moreover injection in lower pressures is attractive from both economical and operational standpoints since this reduces the...
Experimental and Simulation Studies of Oil Recovery Via Immiscible and Near Miscible Simultaneous Water and CO2 Injection in an Iranian Reservoir
, M.Sc. Thesis Sharif University of Technology ; Taghikhani, Vahid (Supervisor) ; Ghazanfari, Mohammad Hossein (Supervisor)
Abstract
A simultaneous water and CO2 injection study using sandstone cores with 21°API Sarvak (Azadegan field) oil has performed to evaluate oil recovery under four injection modes: secondary immiscible, secondary near-miscible, tertiary immiscible, and tertiary near-miscible. It is demonstrated that swag injection (secondary and tertiary) is an effective method for the recovery of significant amount of oil or residual oil from water-flooded porous media, but there is always some bypassing (at the pore level) of the oil due to topological effects, water-shielding and dead-end pores. In non-homogeneous porous medium, oil recovery is depending to SWAG ratio in immiscible and near-miscible conditions....
Investigation of Gas Injection Process For Enhanced Oil Recovery Using Scaling Analysis
, M.Sc. Thesis Sharif University of Technology ; Ghazanfari, Mohammad Hossein (Supervisor) ; Fatemi, Mobeen (Supervisor)
Abstract
The process of gas injection is well-known for Enhanced Oil Recovery (EOR) among researchers in the past few decades. This process depends on both compositional effects and IFT reduction effects as the conditions approach miscibility. This study seeks to evaluate the interactions of these two fundamental mechanisms in the process of enriched gas injection for EOR. At first, we investigate the relative dominance of the key mechanisms, as well as composition paths, component and phase distribution, and component production via compositional simulation of the process of gas injection into 1D homogeneous porous media such as slim tube and core under immiscible and near-miscible conditions. Then,...