Sharif Digital Repository

A high-efficient method has been considered for simultaneously improving the hydrothermal and exergetic performance of heat exchangers. Two-phase Eulerian model is employed in a 3-D numerical study to precisely study the hydrothermal and entropic behaviors of Fe3O4/water ferrofluid, under the effect of a magnetic field inducer. The findings reveal that employing the magnetic field can improve the energetic and exergetic performance by generating a swirling flow in the heat exchanger. The pressure drop and entropy generation minimization are also achieved by the induced flow in comparison with other passive techniques due to the lack of any additional obstacle in the flow path. Results show... 

For the present article, a pulsating heat pipe (PHP) is fabricated and tested experimentally by bending a copper tube. The effects of working fluid, heat input, charging ratio, inclination angle, magnets location, and ferrofluid (magnetic nanofluid) volumetric concentration have been investigated on the thermal performance of this PHP. Experimental results show that using ferrofluid as a working fluid improves the thermal performance of the PHP significantly. Moreover, applying a magnetic field on a ferrofluidic PHP reduces its thermal resistance. By changing the inclination angle of the PHP from vertical mode to angles close to the horizontal mode, the present PHP has a constant and... 

In this article, a three-dimensional numerical simulation is performed to investigate the effect of magnetic field on the heat transfer of ferrofluid inside a tube which is equipped with twisted tape. This work comprehensively focused on the flow feature and temperature distribution of ferrofluid in presence of non-uniform magnetic field while ferrofluid swirled inside a tube with twisted tape. In this study, it is assumed that the ferrofluid is single phase and laminar and constant heat flux is applied on the outside of the tube. The magnetic field is established by wire in parallel direction with the axis of the tube. The base fluid is water with 0.86 Vol% Nano particles (Fe3O4). The... 

The present research proposes an effective method to enhance the heat transport capability of conventional electronic coolers and improve their thermal management. Pulsating heat pipes (PHPs) are outstanding heat transfer devices in the field of electronic cooling. In the present study, two sets of open-loop pulsating heat pipes (OLPHPs) for two different magnetic nanofluids (with and without surfactant) were fabricated and their thermal performance was experimentally investigated. Effects of working fluid (water and two types of magnetic nanofluids), heating power, charging ratio, nanofluid concentration, inclination angle, application of a magnetic field, and magnet location are described.... 

The heat transfer characteristics and entropy generation rate of hybrid graphene-magnetite nanofluids under forced laminar flow that subjected to the permanent magnetic fields were investigated. For this purpose, a nanoscale reduced graphene oxide-Fe3O4 hybrid was synthesized by using graphene oxide, iron salts and tannic acid as the reductant and stabilizer. The thermophysical and magnetic properties of the hybrid nanofluid have been widely characterized and thermal conductivity has shown an enhancement of 11%. The experimental results indicated that the heat transfer enhancement of hybrid magnetite nanofluid compared to the case of distilled was negligible when no magnetic field was... 

In this work, a four-turn pulsating heat pipe (PHP) is fabricated and tested experimentally. The novelty of the present PHP is the capability to obtain various thermal performances at a specific heat input by changing the magnetic field. The effects of working fluid (water and ferrofluid), charging ratio (40% and 70%), heat input (35, 45, 55, 65, 75, and 85 W), orientation (horizontal and vertical heat mode), ferrofluid volumetric concentration (2.5% and 7%), and magnetic field on the thermal performance of PHPs are investigated. The results showed that applying the magnetic field on the water-based ferrofluid reduced the thermal resistance of PHP in all orientations. In the presence of a... 

Experimental investigations are performed in order to determine the thermal conductivity of NiFe2O4 nanoparticles dispersed in deionized water. The magnetic nanoparticles are synthesized using a microemulsion method. The X-ray diffraction (XRD), transmission electronic microscopy (TEM), and vibration sample magnetometer (VSM) are used to characterize the structure, the size and the magnetic properties of the nanoparticles. The VSM results disclose that the NiFe2O4 nanoparticles are ferromagnetic at room temperature. Experimental measurements on thermal conductivity of the prepared nanofluids are conducted at different volume concentrations between 0% and 2% and in the temperature range of... 

The present work examines experimentally the effect of magnetic field on the viscosity and thermal conductivity of a hybrid nanofluid containing tetramethylammonium hydroxide (TMAH) coated Fe3O4 nanoparticles and Gum arabic (GA) coated carbon nanotubes (CNTs). The hybrid nanofluid was prepared by using ultrasonic dispersion method. Magnetic field was created by a pair of spaced apart magnet plates. The effect of temperature on the time variation of thermal conductivity under applied magnetic field was also investigated. According to the results of this study, viscosity of the hybrid nanofluid increases with the strength of magnetic field, while it decreases with the increase of temperature.... 

The effect of a permanent magnetic field on the heat transfer characteristics of hybrid graphene-magnetite nanofluids (hybrid nanofluid) under forced laminar flow was experimentally investigated. For this purpose, a reduced graphene oxide-Fe3O4 was synthesized by using two-dimensional (2D) graphene oxide, iron salts and tannic acid as the reductant and stabilizer. Graphene sheets acted as the supporting materials to enhance the stability and thermal properties of magnetite nanoparticles. The thermo-physical and magnetic properties of this hybrid nanofluid have been widely characterized and it shows that the thermal conductivity increased up to 11%. The hybrid nanofluid behaves as a Newtonian... 

In this work, forced-convection heat transfer of magnetic-sensitive nanofluids has been investigated in the presence of rotating magnetic field. In this regard, the laminar, Newtonian, incompressible, and two-dimensional (2D) fluid flow in a horizontal duct subject to constant wall temperature boundary condition was modeled. Moreover, the fluid was supposed to be non-electrical conductive and the magnetic field source comprised of two time varying components perpendicular to each other. Influences of magnetic field intensity and frequency, inlet fluid velocity, and spin viscosity on the forced-convection heat transfer of the magnetic nanofluids were investigated. It was found that the... 

To increase heat transfer, ferrofluids have been utilized to study the effective parameters of pool boiling. Changes and possible enhancement of pool boiling heat transfer of magnetic fluids is a function of magnetic field and concentration of nanoparticles. To the best knowledge of the authors, no systematic experiments have been conducted to visualize the phenomena during the boiling of ferrofluids with different concentrations. In this study an experimental investigation has been conducted, by designing and fabricating a novel hele-shaw vessel with glass sides, to explore via visualizations some details in the pool boiling of ferrofluids. Boiling patterns of ferrofluids at various... 

A considerable amount of energy is lost in the parabolic trough solar collectors due to the poor capability of working fluid in full absorption of the concentrated solar irradiation across the receiver tube. A new hybrid method is recommended here to cover up such deficiency by simultaneously using a rotary absorber tube and magnetic field inducer with nanofluid. Results showed that the combination effects of the receiver rotation and the magnetic field improve the convection mechanism in the absorber and increase both energetic and exergetic performance of the collector. The study reveals that there is an optimal rotational speed in the each magnetic field intensity for different... 

In this article, three-dimensional (3D) forced-convection heat transfer of magnetic nanofluids in a pipe subject to constant wall heat flux in the presence of single or double permanent magnet(s) or current-carrying wire has been investigated and compared. In this regard, laminar fluid flow and equilibrium magnetization for the ferrofluid were considered. In addition, variations of magnetic field in different media were taken into account and the assumption of having a linear relationship of magnetization with applied magnetic field intensity was also relaxed. Effects of magnetic field intensity, nanoparticle volume fraction, Reynolds number value, and the type of magnetic field source...