Sharif Digital Repository

Simple compression and microscopy techniques were employed to characterise the microstructural origin of the deformation behaviour of nickel base superalloy IN625 during large strain testing. The alloy exhibited a four-stage strain hardening response similar to that previously reported for low stacking fault energy face centred cubic alloys. At strains lower than about -0.06 (stage A), a falling regime of the hardening rate was observed. This stage was followed by a second stage (stage B) of slow increasing hardening rate, which was found to be coincident with the formation of Lomer-Cottrell locks. The second falling regime of strain hardening (stage C) was seen in the strain range of -0.25... 

True stress vs. true strain responses of Cu-6 wt.% Al and Cu-12 wt.% Mn alloys are presented. While Cu-6 wt.% Al alloy shows the typical mechanical response of low stacking fault energy alloys, the Cu-12 wt.% Mn alloy behaved similarly to medium to high stacking fault energy alloys. These findings clearly show that while short-range ordering triggers slip planarity, it has a minor effect on total dynamic recovery of these copper alloys