Sharif Digital Repository

Hydro-mechanical behavior of unsaturated collapsible soils can be drastically affected by saline infiltrations. Saline infiltrations into the underlain soil layers of the urban transportation and lifelines due to deicing or existence of traffic pollutants has been a common issue of concern for years in many countries. Additionally, many reports have been published so far, indicating the construction of roads and railways on unsaturated collapsible soils. In this research, hydro-mechanical characteristics of an unsaturated collapsible loessial soil diluted with saturated solutions of three different salts that are frequently involved in transportation infrastructure (namely NaCl, CaCl2 and... 

According to recent researches, angle shear connectors are appropriate to transfer longitudinal shear forces across the steel-concrete interface. Angle steel profile has been used in different positions as L-shaped or C-shaped shear connectors. The application of angle shear connectors in tilted positions is of interest in this study. This study investigates the behaviour of tilted-shaped angle shear connectors under monotonic loading using experimental push out tests. Eight push-out specimens are tested to investigate the effects of different angle parameters on the ultimate load capacity of connectors. Two different tilted angles of 112.5 and 135 degrees between the angle leg and steel... 

The high penetration of residential air conditioners (RACs) poses a growing concern in emerging fault-induceddelayed voltage recovery (FIDVR) in power systems. FIDVR is expected to be a significant threat to the stability and reliability offuture power grids. Hence, the system planners should carry out appropriate simulation studies to mitigate the severeconsequences of FIDVR events. A key question to implement these studies is how to determine the worst condition whichresults in FIDVR. Most of the actual FIDVR events have been experienced in the hot hours of the day and this issue makes onecurious to think about the relationship between the FIDVR events and the ambient temperature. In this... 

A literature review of laboratory and field scale studies on low salinity water (LSW) injection showed that the salinity and composition of injected water can have a significant impact on oil recovery. Historically, extensive research has been completed to understand the mechanisms and factors affecting LSW injection. However, although numerous mechanisms have been proposed to describe the interactions in the target process, none have been widely accepted. In this study, waterflooding tests were used to investigate the advantages, disadvantages, and effect of LSW injection. In laboratory tests, two different brines and crude oil of one of Iran's southern reservoirs were used to assess the... 

Enhanced Oil Recovery techniques are gaining more attention worldwide as the proved oil reserves are declining and the oil price is hiking. Although many giant oil reservoirs in the world were already screened for EOR processes, the main challenges such as low sweep efficiency, costly techniques, possible formation damages, transportation of huge amounts of EOR agents to the fields especially for offshore cases, analyzing micro-scale multi-phase flow in the rock to the large scale tests and the lack of analyzing tools in traditional experimental works, hinder the proposed EOR processes. Our past experiences on using nanotechnology to the upstream cases, especially EOR processes, revealed... 

Floating urbanization could be the subject of a green flood mitigation strategy. The main part of any floating house is the buoyant part, which is made from concrete pontoons. Aggregates play the most important role in making concrete a lightweight material. Oil Palm Shell (OPS) is an agricultural waste material, which is widely available in South East Asia. This study tries to select the best cementing material from waste and produced pozzolans, to improve the specifications of green lightweight concrete with Oil Palm Shell (OPS), using decision-making methods. The decision making model was conducted by the application of a Fuzzy Preference Selection Index (PSI). Quantitative data was... 

Simulation is the gold standard for training in aviation and trauma medicine. Now it is available for diseases diagnosis and treatment. With simulation, clinicians can practice their art in a realistic, consequence free environment, combining both theory and practice in a comprehensive program. Method and materials - In the virtual clinical environment of "VPsoft mentor" software, the practitioner reviews a patient's history, orders laboratory tests and procedures, interprets findings, renders diagnoses, and prescribes medication. Every diagnostic or treatment decision the clinician makes for the patient is analyzed by E-mentor, providing instant feedback.Results - This software have been... 

Crumb rubber modification (CRM) is an effective means of improving neat asphalt performance. Numerous studies have investigated the effects of CRM using the current Superpave® laboratory tests. Recent studies have shown that the assumption of linear viscoelastic behavior or employing insufficient stress or strain levels makes current tests inadequate for properly assessing the performance of binders, especially when modified. This problem has resulted in the development of improved test methods such as the time sweep binder fatigue test and the multiple stress creep and recovery (MSCR) test for permanent deformation. The present study assesses the performance of binders modified with a wide... 

Aqueous phase trapping in many oil and gas reservoirs is a noteworthy mechanism of formation damage during drilling, completion, work over, and stimulation operation. Aqueous phase trapping can limit the productivity of a well to a high extent, especially in low permeable gas reservoirs. In this article, using aqueous phase trapping laboratory tests on low permeable sandstone cores' effect of key factors on gas reservoir's potential for aqueous phase trapping was investigated. Studied factors were initial water saturation, permeability, water filtrate viscosity, and drawdown pressure. Results showed that severity of formation damage caused by aqueous phase trapping increases as each of the... 

Side weirs are hydraulic control structures widely used in irrigation, drainage networks and waste water treatment plants. These structures can be used for adjusting and diverting of flow with minimum energy loss. In spite of many studies were carried out on rectangular side weirs, the studies on oblique and labyrinth side weirs are scarce. In this study, based on the experimental data from more than 210 laboratory tests and through using the multivariable nonlinear partial least square (PLS) method, two nonlinear equations are presented for discharge coefficient CM of triangular labyrinth side weirs with one and two cycles. The obtained empirical equations relating CM with the relevant... 

In this paper a new method of modeling shear force-displacement relationship for confined masonry walls by neural networks has been presented. Although the mathematical models have been very useful in the simulations so far, however developing more accurate models is necessary. While developing precise mathematical models for highly hysteretic materials is itself challenging and practically cumbersome, the use of learning algorithms is an attractive alternative. The issue of material modeling by neural networks has been a challenging one itself, noticing available neural networks have some limitations in the learning of non-linearity. In this paper a new type neural network, called Prandtl... 

Equations of State EOS are vastly being used to predict the phase behavior of reservoir fluids. The accuracy of EOS modeling technique over conventional correlation models would benefit an improved property prediction of these fluids. Once the crude oil or gas condensate fluid system has been probably characterized using limited laboratory tests, its PVT behavior under a variety of conditions can be easily studied. In this paper, the PVT behavior of gas condensate from a reservoir in South Pars retrograde gas field in Iran was modeled using the three-parameter Patel and Teja Equation of State. The multi-sample characterization method is used to arrive at one consistent model for retrograde... 

Separating produced water is a key part of production processing for most crude oils. It is required for quality reasons, and to avoid unnecessary transportation costs and prevent pipework corrosion rates caused by soluble salts present in the water. A complicating factor is that water is often present in crude oil in the form of emulsions. Experiments were performed to evaluate the performance of ultrasonic fields in demulsifying crude oil emulsions using novel pipe-form equipment. A horn-type piezoelectric ultrasonic transducer with a frequency of 20 kHz and power ranging from 80 W to 1000 W was used for experimental purposes. The influences of the intensity of ultrasonic fields,... 

Background: A small amount of methanol is produced endogenously in the human body but it is efficiently metabolized by alcohol dehydrogenase (ADH) and other enzymes, and the products eliminated without harm. In this study, we present a new entity of inborn error of methanol metabolism due to a mutation in the ADH1C gene coding for the γ subunit that is part of several ADH isoenzymes. Results: This disorder was discovered in an 11.58-year-old boy. During one 9-month hospital admission, he had periods of 1–4 days during which he was comatose, and between these periods he was sometimes verbose and euphoric, and had ataxia, dysarthria. Following hemodialysis treatments, he became conscious and...