Sharif Digital Repository

A moving bed biofilm reactor with pre-denitrification configuration was fed with a synthetic wastewater containing high chemical oxygen demand (COD) and ammonia. By changing different variables including ammonium and COD loading, nitrification rate in the aerobic reactor and denitrification rate in the anoxic reactor were monitored. Changing the influent loading was achieved via adjusting the inlet COD (956-2,096 mg/L), inlet ammonium (183-438 mg/L), and hydraulic retention time of the aerobic reactor (8, 12, and 18 hours). The overall organic loading rate was in the range of 3.60-17.37 gCOD/m2·day, of which 18.5-91% was removed in the anoxic reactor depending on the operational conditions.... 

A number of human diseases, including Alzheimer's and Parkinson's have been linked to amyloid formation. To search for an anti-amyloidogenic product, alkaloid enriched extract from borage leaves was examined for anti-amyloidogenic activity using Hen Egg White Lysozyme (HEWL) as a model protein. After isolation of the plant extract using rHPLC, only one fraction indicated a significant bioactivity. TEM analysis confirmed a remarkable reduction of amyloid fibrils in the presence of the bioactive fraction. To identify the effective substance in the fraction, mass spectrometry, FTIR, and NMR were performed. Our analyses determined that the bioactive compound as... 

A crude phenolic glycolipid extract from Mycobacterium bovis BCG was fractionated by column chromatography. A reversed-phase high performance liquid chromatography (HPLC) method with UV detection at 275nm was developed for simultaneous detection and separation of phenolic glycolipids (PGLs) in Mycobacterium bovis BCG. This analysis provides a good resolution. Different solvent systems and columns for HPLC were compared. A system composed of acetonitrile-water in the ratio of 0→80% at a flow rate of 0.8 mL/min and C8 analytical column were found to be optimum for HPLC of the phenolic glycolipids. This simple method is therefore appropriate to purify these compounds present in M. bovis extract... 

In this paper multivariate response surface methodology (RSM) has been used for the optimization of hydrodistillation-headspace solvent microextraction (HD-HSME) of thymol and carvacrol in Thymus transcaspicus. Quantitative determination of compounds of interest was performed simultaneously using gas chromatography coupled with flame ionization detector (GC-FID). Parameters affecting the extraction efficiency were assessed and the optimized values were 5 min, 2 μL and 3 min for the extraction time, micro-drop volume and cooling time after extraction, respectively. The amounts of analyte extracted increased with plant weight. The calibration curves were linear in the ranges of 6.25-81.25 and... 

Functionalized magnetic core-zeolitic shell nanocomposites were prepared via hydrothermal and precipitation methods. The products were characterized by vibrating sample magnetometer, X-ray powder diffraction, Fourier transform infrared spectroscopy, nitrogen adsorption-desorption isotherms, and transmission electron microscopy analysis. The growth of mordenite nanocrystals on the outer surface of silica-coated magnetic nanoparticles at the presence of organic templates was well approved. The removal performance and the selectivity of mixed metal ions (Pb2+ and Cd2+) in aqueous solution were investigated via the sorption process. The batch method was employed to study the sorption kinetic,... 

In the present study, CS-CA nanoparticle was prepared for forming a new amide linkage, by grafting the amino groups of CS in the presence of carboxylic groups of CA that acts as cross-linking agent. The as-prepared CS-CA nanoparticle samples were characterized by use of dynamic light scattering (DLS), scanning electron microscopy (SEM), Fourier-transformed infrared spectroscopy (FTIR), X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) techniques, which showed that the cross-linking agent preserved during the chemical modifications. The adsorption capacity of the CS-CA nanoparticles for the removal of Cr (VI) in aqueous solution was studied. The adsorption equilibrium data... 

Extraction of the essential oil from a medicinal plant called Dracocephalum kotschyi Boiss was performed by green technology of supercritical carbon dioxide (SC-CO2) extraction. A Taguchi orthogonal array design with an OA16 (45) matrix was used to evaluate the effects of five extraction variables: pressure of 150-310bar, temperature of 40-60°C, average particle size of 250-1000μm, CO2 flow rate of 2-10ml/s and dynamic extraction time of 30-100min. The optimal conditions to obtain the maximum extraction yield were at 240bar, 60°C, 500μm, 10ml/s and 100min. The extraction yield under the above conditions was 2.72% (w/w) which is more than two times the maximum extraction yield that has been... 

In the present work, the roles of inorganic oxide nanoparticles on the extraction efficiency of polyethylene terephthalate-based nanocomposites were extensively studied. Four fiber coatings based on polyethylene terephthalate nanocomposites containing different types of nanoparticles along with a pristine polyethylene terephthalate polymer were conveniently electrospun on stainless steel wires. The applicability of new fiber coatings were examined by headspace-solid phase microextraction of some environmentally important volatile organic compound such as benzene, toluene, ethylbenzene and xylene (BTEX), as model compounds, from aqueous samples. Subsequently, the extracted analytes were... 

An imprinted interpenetrating polymer network (IPN) was synthesized and used as a medium for isolation of carbamazepine from urine samples. The polymer network consisted of a homogeneous polystyrene–sol gel hybrid constructed by in–situ radical polymerization method. In this process, within the sol–gel reaction duration, styrene monomer could penetrate into the reaction mixture and after the polymerization initiation, a monolithic IPN structure was prepared. The scanning electron microscopy (SEM) image and energy dispersive spectroscopy (EDX) are indications of the polystyrene dispersion at nano- to micro-meter level in the sol gel matrix. Eventually, the synthesized IPN was used as a... 

Human parvovirus B19 (B19) is a small, non-enveloped virus and belongs to Parvoviridae family. B19 persists in many tissues such as thyroid tissue and even thyroid cancer. The main aim of this study was to determine the presence of B19, its association with increased inflammation in thyroid tissue, and thus its possible role in thyroid cancer progression. Studies have shown that virus replication in non-permissive tissue leads to overexpression of non-structural protein and results in upregulation of proinflammatory cytokines such as interleukin 6 and tumor necrosis factor alpha. A total of 36 paraffin-embedded thyroid specimens and serum were collected from patients and 12 samples were used... 

In this study, QuEChERS combined with dispersive liquid-liquid microextraction is developed for extraction of ten pesticides in complex sample matrices of water and milk. In this regard, effective factors of proposed extraction technique combined with gas chromatography with flame ionization detector were designed, modeled, and optimized using central composite design, multiple linear regression, and Nelder–Mead simplex optimization. Later, univariate calibration model for ten pesticides was developed in concentration range of 0.5–100 ng/mL. Surprisingly, quadratic calibration behavior was observed for some of the pesticides. In this regard, Mandel's test was used for evaluating linearity... 

The potential of electrospun cellulose acetate/chitosan/single walled carbon nanotubes/ferrite/titanium dioxide (CA/chitosan/SWCNT/Fe3O4/TiO2) nanofibers was investigated for the removal of Cr(VI), As(V), Methylene blue and Congo red from aqueous solutions via the adsorption and photocatalytic reduction processes. The properties of synthesized SWCNT/Fe3O4/TiO2 and fibers were characterized using TEM, SEM, FTIR, XRD, TGA and BET analysis. In adsorption process, the influence of adsorbent type including SWCNT to Fe3O4 ratio, TiO2 to SWCNT/Fe3O4 ratio and SWCNT/Fe3O4/TiO2 concentration as well as the adsorption parameters including pH, contact time, and initial concentration of adsorbates on... 

Polystyrene is one of the best candidates as the extracting medium due to its high stability in different media and acceptable extraction capability. However, the hydrophobic nature and low wettability of polystyrene limits its application to non–polar analytes. To resolve this limitation, in this project, amine groups were chemically attached to the surface of magnetic polystyrene. The resulting hydrophilic magnetic particles were expected to be capable of extracting both polar and non–polar analytes. Non–steroidal anti–inflammatory drugs (NSAIDs) were chosen for testing the applicability of modified magnetic polystyrene according to the importance of their analysis and also their wide... 

In this study, a method was described for the extraction of three antibiotic residues from cow milk samples using a graphene oxide–starch–based nanocomposite. The prepared nanocomposites were employed as an extractive phase for micro-solid phase extraction of antibiotics from cow milk samples. The extracted antibiotics, i.e. amoxicillin, ampicillin and cloxacillin, were subsequently analyzed by high-performance liquid chromatography–ultraviolet detection (HPLC–UV). Important variables associated with the extraction and desorption efficiency were optimized. High extraction efficiencies for the selected antibiotics were conveniently achieved using the starch–based nanocomposite as the... 

An impedimetric human papilloma virus (HPV) DNA biosensor based on gold nanotubes (AuNTs) in label free detection was materialized. The AuNTs decorated nanoporous polycarbonate (AuNTs-PC) template as biosensor electrode was fabricated by electrodeposition method. The single strand DNA (ss-DNA) probe was covalently immobilized onto the AuNTs-PC electrode. The hybridization of target sequences with the ss-DNA probe was observed by the electrochemical impedance spectroscopy (EIS). The biosensor showed high selectivity and could differentiate between the complementary, mismatch and non-complementary DNA sequences. The EIS measurements were matched to Randle's equivalent circuit. The... 

In the present work, with the focus on an environmentally–friendly approach, some gels were prepared by synthesizing amine–modified lignin, extracted from sugarcane bagasse, and further esterification and subsequent freeze–drying. These lignin–based gels were implemented as extractive phases in an online micro–solid phase extraction (μSPE) setup in conjunction with high performance liquid chromatography (HPLC) with UV detector. The developed method was used for analytical determination of valsartan and losartan in urine samples. To study the effect of the functionalization process, the efficiency of the unmodified lignin and the functionalized lignin were compared both in the absence and the... 

In this research, an attempt was made toward synthesizing a sol–gel–based silica aerogel and its subsequent coating on a copper wire by phase separation of polystyrene. Adaption of this new approach enabled us to coat the metallic wire with powder materials. The use of this method for coating, led to the formation of a porous and thick structure of silica aerogel. The coated wire was placed in a needle and used as the sorbent for in–tube solid phase microextraction of chlorobenzenes (CBs). The superhydrophobicity of sorbent on extraction efficiency was investigated by using different ratios of tetraethylorthosilicate/methyltrimethoxysilane. The surface coated with the prepared silica aerogel... 

The direct growth of self-supported metal-organic frameworks (MOFs) thin film can be considered as an effective strategy for fabrication of the advanced modified electrodes in sensors and biosensor applications. However, most of the fabricated MOFs-based sensors suffer from some drawbacks such as time consuming for synthesis of MOF and electrode making, need of a binder or an additive layer, need of expensive equipment and use of hazardous solvents. Here, a novel free-standing MOFs-based modified electrode was fabricated by the rapid direct growth of MOFs on the surface of the glassy carbon electrode (GCE). In this method, direct growth of MOFs was occurred by the formation of vertically... 

In this paper the field-effect transistor DNA biosensor for detecting hepatitis B virus (HBV) based on indium tin oxide nanowires (ITO NWs) in label free approach has been fabricated. Because of ITO nanowires intensive conductance and functional modified surface, the probe immobilization and target hybridization were increased strongly. The high resolution transmission electron microscopy (HRTEM) measurement showed that ITO nanowires were crystalline and less than 50 nm in diameter. The single-stranded hepatitis B virus DNA (SS-DNA) was immobilized as probe on the Au-modified nanowires. The DNA targets were measured in a linear concentration range from 1fM to 10 µM. The detection limit of... 

In this study, titania-ceria-graphene quantum dot (TC-GQD) nanocomposite was synthesized by hydrothermal method for the first time. The prepared nanomaterials were characterized by XRD, FTIR dynamic light scattering (DLS), FESEM, HRTEM, and EDX spectroscopy along with elemental mapping. The synergistic effect of the nanocomposite components was studied by diffuse reflectance spectroscopy (DRS) and electrical conductivity meter. The results showed that band gap of TC-GQD nanocomposite was shifted to visible lights relative to its components (1.3 eV), and electrical conductivity of the sample was significant increased to 89.5 μS cm−1. After chemical and physical characterization, prepared new...