Loading...
Search for: exfoliated-graphene
0.006 seconds

    Accelerated differentiation of neural stem cells into neurons on ginseng-reduced graphene oxide sheets

    , Article Carbon ; Volume 66 , January , 2014 , Pages 395-406 Akhavan, O ; Ghaderi, E ; Abouei, E ; Hatamie, S ; Ghasemi, E ; Sharif University of Technology
    Abstract
    Asian red ginseng was used for green reduction of chemically exfoliated graphene oxide (GO) into reduced graphene oxide (rGO). The reduction level and electrical conductivity of the ginseng-rGO sheets were comparable to those of hydrazine-rGO ones. Reduction by ginseng resulted in repairing the sp 2 graphitic structure of the rGO, while hydrazine-rGO showed more defects and/or smaller aromatic domains. The ginseng-rGO sheets presented a better stability against aggregation than the hydrazine-rGO ones in an aqueous suspension. Whilst the hydrophobic hydrazine-rGO films exhibited no toxicity against human neural stem cells (hNSCs), the hydrophilic GO and ginseng-rGO films (as more... 

    Graphene based strain sensors: A comparative study on graphene and its derivatives

    , Article Applied Surface Science ; Volume 448 , 2018 , Pages 71-77 ; 01694332 (ISSN) Hosseinzadeh, A ; Bidmeshkipour, S ; Abdi, Y ; Arzi, E ; Mohajerzadeh, S ; Sharif University of Technology
    Elsevier B.V  2018
    Abstract
    In this study, we have experimentally investigated the electrical properties of graphene and its derivatives (Exfoliated graphene, CVD synthesized graphene, graphene oxide and hydrogenated graphene oxide) under uniaxial strain. We have used gauge factor as a common representation of the sensitivity of the strain sensors and found that the hydrogenated graphene oxide shows significantly higher responsivity comparing to other samples under study. Reproducibility, reliability and lack of hysteresis in the responses of the graphene based samples make them a good candidate to be used in the strain sensors. © 2018  

    DNA and RNA extractions from eukaryotic and prokaryotic cells by graphene nanoplatelets

    , Article RSC Advances ; Vol. 4, issue. 105 , 2014 , p. 60720-60728 Hashemi, E ; Akhavan, O ; Shamsara, M ; Valimehr, S ; Rahighi, R ; Sharif University of Technology
    Abstract
    Graphene nanoplatelets with lateral dimensions of ∼50-200 nm and thicknesses <2 nm were utilized for the extraction of nucleic acids (NAs) from eukaryotic and prokaryotic cells. The graphene nanoplatelets (both chemically exfoliated graphene oxide nanoplatelets and hydrazine-reduced graphene oxide nanoplatelets) successfully extracted plasmid DNA (pDNA) from Escherichia coli bacteria, comparable to a conventional phenol-chloroform (PC) method. Furthermore, it was found that the yield of graphene nanoplatelets in genomic DNA (gDNA) and RNA extractions from embryonic stem cells (ESCs) was also comparable to the yield of the conventional methods. The effects of the graphene nanoplatelets on... 

    Graphene jet nanomotors in remote controllable self-Propulsion swimmers in pure water

    , Article Nano Letters ; Volume 16, Issue 9 , 2016 , Pages 5619-5630 ; 15306984 (ISSN) Akhavan, O ; Saadati, M ; Jannesari, M ; Sharif University of Technology
    American Chemical Society 
    Abstract
    A remote controllable working graphite nanostructured swimmer based on a graphene jet nanomotor has been demonstrated for the first time. Graphite particles with pyramidal-like morphologies were fabricated by the creation of suitable defects in wide high-purity graphite flakes followed by a severe sonication. The particles were able to be self-exfoliated in water after Na intercalation between the graphene constituents. The self-exfoliation resulted in jet ejection of graphene flakes from the end of the swimmers (with speeds as high as ∼7000 m/s), producing a driving force (at least ∼0.7 L (pN) where L (μm) is swimmer size) and consequently the motion of the swimmer (with average speed of... 

    Visible light-induced photocatalytic reduction of graphene oxide by tungsten oxide thin films

    , Article Applied Surface Science ; Volume 276 , 2013 , Pages 628-634 ; 01694332 (ISSN) Choobtashani, M ; Akhavan, O ; Sharif University of Technology
    2013
    Abstract
    Tungsten oxide thin films (deposited by thermal evaporation or sol gel method) were used for photocatalytic reduction of graphene oxide (GO) platelets (synthesized through a chemical exfoliation method) on surface of the films under UV or visible light of the environment, in the absence of any aqueous ambient at room temperature. Atomic force microscopy (AFM) technique was employed to characterize surface morphology of the GO sheets and the tungsten oxide films. Moreover, using X-ray photoelectron spectroscopy (XPS), chemical state of the tungsten oxide films and the photocatalytic reduction of the GO platelets were quantitatively investigated. The better performance of the sol-gel tungsten... 

    Controlled electrophoretic deposition of electrochemically exfoliated graphene sheets on Ag nanowires network

    , Article Micro and Nano Letters ; Volume 14, Issue 4 , 2019 , Pages 389-393 ; 17500443 (ISSN) Malekshahi Byranvand, M ; Tajabadi, F ; Mardi, S ; Taghavinia, N ; Amiri Zarand, A ; Dabirian, A ; Sharif University of Technology
    Institution of Engineering and Technology  2019
    Abstract
    Electrochemical exfoliation of graphite has recently attracted a big attention as a simple, fast and scalable method for the preparation of high quality graphene, but there are some drawbacks that hinder its application. Direct deposition is one of the most critical challenges that makes it difficult to deposit uniform, compact and large scale graphene thin films. This work develops a facile electrophoretic deposition route to fabricate exfoliated graphene (EG) film on Ag nanowires (NWs) networks with a controllable film thickness in nanometers scale. EG thin films are deposited with different applied potentials and times from an EG dispersion in N, N-dimethylformamide solvent. Since...