Sharif Digital Repository

The immobilization of cellulase onto non-porous ultrafine silica particles was studied. Cellulase was extracted from a Trichoderma reesei culture after partial purification with ammonium sulfate (pH = 5.0), which was then immobilized onto non-porous ultrafine silica particles, with or without the use of glutaraldehyde as a crosslinking agent. Cellulase was immobilized by adsorption onto ultrafine silica particles efficiently, as well as by covalent cross-linking with glutaraldehysde. Increasing the concentration of the free form of enzyme increased the amount of immobilized cellulase. The maximum enzyme immobilization happened at the free enzyme concentration of 0.48 mg/ml. In general, the... 

Over the last decade, nanoparticles used as protein carriers have opened new avenues for a variety of biomedical applications. The main concern for these applications is changes in biological activity of immobilized proteins due to conformational changes on the surface of the carrier. To evaluate this concern, the preparation and biocatalyst activity of α-chymotrypsin-Fe 3O4 @ Au core/shell nanoparticles were investigated. First, Fe3O4 @ Au core/shell nanoparticles were synthesized by coprecipitation method and citrate reduction of HAuCl 4. TEM imaging revealed a core size of 13 ± 3 nm and a shell thickness of 4 ± 1 nm for synthesized nanoparticles. X-ray diffraction (XRD) was used to study... 

The isomerization of D-glucose to D-fructose using the immobilized glucose isomerase, as a typical model system of solid-liquid enzyme reactions has been carried out in a novel type of two-impinging-jets reactor (TIJR), which is characterized by a rotating inner cylinder in a stationary one. Because of the impinging process, turbulence, and complex trajectory of the solid particles within the reactor, the fractional conversion of glucose obtained in the TIJR increased dramatically compared to that obtained by conventional reaction systems. A compartment model was considered to describe the pattern of flow [residence time distribution (RTD) of solid particles] within the TIJR. Considering... 

A magnetic nanocomposite was prepared by entrapment of Fe3O4 nanoparticles into the cross-linked ionic liquid/epoxy type polymer. The resulting support was used for covalent immobilization of cellulase through the reaction with epoxy groups. The ionic surface of the support improved the adsorption of enzyme, and a large amount of enzyme (106.1 mg/g) was loaded onto the support surface. The effect of the presence of ionic monomer and covalent binding of enzyme was also investigated. The structure of support was characterized by various instruments such as FT-IR, TGA, VSM, XRD, TEM, SEM, and DLS. The activity and stability of immobilized cellulase were investigated in the prepared support. The... 

A destabilizing effect at pH 7 of sodium phosphate on several lipases immobilized via interfacial activation is shown in this work. This paper investigates if this destabilizing effect is extended to other inactivation conditions, immobilization protocols or even other immobilized enzymes (ficin, trypsin, β-galactosidase, β-glucosidase, laccase, glucose oxidase and catalase). As lipases, those from Candida antarctica (A and B), Candida rugosa and Rhizomucor miehei have been used. Results confirm the very negative effect of 100 mM sodium phosphate at pH 7.0 for the stability of all studied lipases immobilized on octyl agarose, while using glutaraldehyde-support the effect is smaller (still... 

In recent years there has been potential increase in the use of alkaline protease as industrial catalysts. Many major industrial and commercial applications, such as food and textile industries, and medical diagnoses, are highly dependent on the protease enzyme. In the cell immobilization technique, the free movement of microorganisms is restricted in the process, and a continuous system of fermentation can be used. In the present work, this technique has been used for alkaline protease production using different carriers, such as chitosan, corn cob and corn tassel. Enzyme activity before immobilization (72 h) was 78.3 U/ml. Corn cob, with 65% immobilization capacity and the highest enzyme... 

In this paper, the performance of immobilized packed bed glucose isomerase enzyme was mathematically modeled. A modified Michaelis-Menten type relation was used to describe the enzyme kinetics. Mass transfer inside the biocatalyst particle and through the bed column was analyzed simultaneously. Using measured data, physicochemical properties including diffusivity, viscosity and density of sugar solutions were correlated with its concentrations and were used to provide precision in solving the set of model equations. Model equations were solved using the Runge-Kutta and Gauss-Seidel algorithms and finite difference numerical method in MATLAB environment. Model output was used to demonstrate... 

In this paper, immobilization of penicillin G aclylase onto non-porous ultrafine silica particles has been studied. The amount of penicillin G acylase immobilized was increased by increasing the free enzyme concentration and, at 0.45 mg/ml concentration of the free enzyme, 80% of the enzyme was immobilized. The optimum pH for immobilization was found to be 7.0, close to the pl of the enzyme. Although immobilization of the enzyme on ultrafine silica particles with and without glutaraldehyde showed almost the same activities, the enzyme immobilized with glutaraldehyde retained its initial activity much longer during 40 cycle-repeated batches with a half life of 163.2 h. © Sharif University of... 

Application of immobilized horseradish peroxidase (HRP) in porous calcium alginate (ca-alginate) for the purpose of phenol removal is reported. The optimal conditions for immobilization of HRP in ca-alginate were identified. Gelation (encapsulation) was optimized at 1.0% (w/v) sodium alginate in the presence of 5.5% (w/v) of calcium chloride. Upon immobilization, pH profile of enzyme activity changes as it shows higher value at basic and acidic solution. Increasing initial phenol concentration results in a decrease in % conversion. The highest conversion belongs to phenol concentration of 2 mM. Investigation into time course of phenol removal for both encapsulated and free enzymes showed... 

In the present work, an amperometric inhibition biosensor for the determination of sulfide has been fabricated by immobilizing Coprinus cinereus peroxidase (CIP) on the surface of screen printed electrode (SPE). Chitosan/acrylamide was applied for immobilization of peroxidase on the working electrode. The amperometric measurement was performed at an applied potential of -150. mV versus Ag/AgCl with a scan rate of 100. mV in the presence of hydroquinone as electron mediator and 0.1. M phosphate buffer solution of pH 6.5. The variables influencing the performance of sensor including the amount of substrate, mediator concentration and electrolyte pH were optimized. The determination of sulfide... 

Chondroitinase ABCI (cABCI) is a drug enzyme that can be used to treat spinal cord injuries. Due to low thermal stability of cABCI, this enzyme was immobilized on Fe3O4 nanoparticle to increase its thermal stability. The size and morphology, structure and magnetic property of the Fe3O4 nanoparticles were characterized by the analyses of SEM, XRD and VSM, respectively, and FTIR spectroscopy was employed to confirm the immobilization of cABCI on the surface of Fe3O4 nanoparticles. The results indicated that the optimum conditions for pH, temperature, cABCI-to-Fe3O4 mass ratio and incubation time in immobilization process were 6.5, 15 °C, 0.75 and 4.5 h, respectively, and about 0.037 mg cABCI... 

Enzymatic removal of Bisphenol A (BPA), acknowledged as an environmentally friendly approach, is a promising method to deal with hard degradable contaminants. However, the application of “enzymatic treatment” has been limited due to lower operational stability and practical difficulties associated with recovery and recycling. Enzyme immobilization is an innovative approach which circumvents these drawbacks. In this study, laccase from Trametes hirsuta was used for BPA removal. Amino-functionalized magnetic Fe3O4 nanoparticles were synthesized via the co-precipitation method followed by surface modification with (3-aminopropyl)trimethoxysilane (APTMS). The as-prepared nanoparticles were... 

The presence of pharmaceutical micropollutants in water and wastewater is considered a serious environmental issue. To eliminate these pollutants, biodegradation of pharmaceuticals using enzymes such as laccase, is proposed as a green method. In this study, immobilized laccase was used for the removal of two model pharmaceutical compounds, carbamazepine and diclofenac. Polyvinylidene fluoride (PVDF) membrane modified with multi-walled carbon nanotubes (MWCNTs) were synthesized as a tailor-made support for enzyme immobilization. Covalently immobilized laccase from Trametes hirsuta exhibited remarkable activity and activity recovery of 4.47 U/cm2 and 38.31%, respectively. The results also... 

Nonporous and mesoporous silica-coated magnetite cluster nanocomposites particles were fabricated with various silica structures in order to develop a desired carrier for the lipase immobilization and subsequent biodiesel production. Lipase from Pseudomonas cepacia was covalently bound to the amino-functionalized particles using glutaraldehyde as a coupling agent. The hybrid systems that were obtained exhibited high stability and easy recovery regardless of the silica structure, following the application of an external magnetic field. The immobilized lipases were then used as the recoverable biocatalyst in a transesterification reaction to convert the soybean oil to biodiesel with methanol.... 

This paper presents a new method for spectrophotometirc detection of sulfide applying fungal peroxidase immobilized on sodium alginate. The sensing scheme was based on decrease of the absorbance of the orange compound, purpurogallin produced from pyrogallol and H2O2 as substrates, due to the inhibition of peroxidase by sulfide. Absorbance of purpurogallin was detected at 420nm by using a spectrophotometer. The proposed method could successfully detect the sulfide in the concentration range of 0.6-7.0μM with a detection limit of 0.4μM. The kinetic parameters of Michaelis-Menten with and without sulfide were also calculated. Possible inhibition mechanism of peroxidase by sulfide was deduced... 

A cost-effective design of reusable enzyme-functionalized particles with better catalytic activity is of great scientific interest due to their applications in a wide range of catalytic reactions in several industrial processes. In this work, a systematic approach for preparing amine-functionalized magnetic nanocomposite particles through the surface modification of core/shell type Fe3O4 cluster@SiO2 particles by the small molecules of 3-(2-aminoethyl)aminopropyltrimethoxysilane (AAS) or the large molecules of polyethyleneimine (PEI) with two different molecular weights, as the support materials for enzyme immobilization, has been demonstrated. The functional... 

In this study, anti-leukemic enzyme L-asparaginase (E.C.3.5.1.1) from Escherichia coli ATCC 11303 was modified by the microencapsulation technique onto calcium alginate beads. Using response surface methodology (RSM), a three-level full factorial design, the values of concentration of sodium alginate, concentration of calcium chloride, and enzyme loading were investigated to obtain the highest residual L-asparaginase (L-ASNase) activity % (immobilized enzyme activity/free enzyme activity). The effects of the studied factors on immobilization were evaluated The predicted values by the model were close to the experimental values, indicating suitability of the model. The results presented that... 

In this study, graphene oxide (GO) was synthesized via modified Hummer's method and exploited as an ideal enzyme immobilization support due to its exclusive chemical and structural features. Then, laccase from genetically modified Aspergillus was covalently immobilized onto GO (nanobiocatalyst). Enzymatic characterization of the nanobiocatalyst exhibited promising results: laccase loading of 156.5 mg g−1 and immobilization yield of 64.6% at laccase concentration of 0.9 mg/ mL. Further employment of various structural characterization techniques including Fourier Transform Infrared Spectroscopy (FTIR), X-ray Powder Diffraction (XRD), Scanning Electron Microscopy (SEM), Thermo-Gravimetric... 

In this study Fe3O4/CMC magnetic nanoparticles were synthesized through co-precipitation method. Afterward, laccase from Trametes hirsuta was immobilized onto Carboxymethyl cellulose (CMC)-coated magnetic Fe3O4 nanoparticles by covalent bonding between carboxyl groups of carboxymethyl cellulose and amine group of laccases. Also, the resulted magnetic nanoparticles and immobilized laccase were characterized by Fourier-transform infrared spectroscopy (FTIR), scanning electron microscope (SEM) and dynamic light scattering (DLS) analysis. Moreover, the vital factors in enzyme immobilization, such as contact time, amount of N-hydroxysuccinimide (NHS), and the amount of nanoparticles were...