Sharif Digital Repository

The mechanism of gold nanowire (AuNW) and nanotube (AuNT) electrodeposition in a cyanide-free solution is investigated for the first time based on the analytical model of Szabo et al. (A. Szabo et al., J. Electroanal. Chem. 217 (1987) 417) for recessed cylindrical ultramicroelectrode (UME). Track-etched Polycarbonate Template (PCT) is served as cylindrical UME ensemble/arrays. Firstly, Au is nucleated through a charge transfer step and when the Nernst thickness exceeds the pore length, the radial diffusion is established around pore mouths. By overlapping of these domains, the planar diffusion toward the whole PCT surface is obtained. An analytic expression for global diffusion coefficient... 

A deterministic model based on the discrete population balance equation (PBE) is used to examine the precipitation of barium sulfate nanoparticles in nonionic inverse microemulsion systems. It is shown that coagulation can have a significant effect at low initial reactants concentration. The simulation results show that a bimodal particle size distribution (PSD) observed in experimental analysis reported in the literature cannot be predicted by neglecting the coagulation effect. A coagulation kernel is proposed that takes into account the effect of interparticle forces through the Fuchs' stability ratio. The effect of electrolyte concentration on the surfactant headgroup area is also... 

In past decades, many attempts have been made to use water-soluble polymers as a mobility control agent to improve sweep efficiency of enhanced oil recovery processes. However, sensitivity of the thickening behavior of these polymers to some harsh conditions, such as high salinity, has cast serious doubt on their applicability in reservoir conditions. By expansion of nanotechnology, scientists discovered that nanoparticles can be utilized as thickening and rheology control agents in many polymer solutions. In this study, hydrophilic fumed silica is added to hydrolyzed polyacrylamide and sulfonated polyacrylamide solutions. The effect of the addition of nano silica on the thickening and... 

Sulfur doped and pure micro-nanoporous TiO2 film were synthesized with PEO method to produce a film with a high surface area for photocatalysis applications. The effect of applied voltage and electrolyte concentration on the microstructure and photocatalytic properties of the prepared layer were investigated via SEM, XRD, EIS and DRS studies. Electrochemical Impedance Spectroscopy (EIS) was carried out in order to determine the corrosion and electrochemical properties of the produced layer. It was found that although the barrier layer resistance decreases with the voltage, the layers porosity and consequently the surface area increases. Finally the XRD and DRS spectrums were correlated with... 

In this study, titanium substrates which previously oxidized through Micro arc oxidation method, was coated by Hydroxyapatite (HAp) coating once more by means of the same method. Morphology, topography and chemical properties as well as phase composition and thickness of layers were studied to reveal the effect of the electrolyte concentration on coating features. According to results, the obtained coatings are consisted of HAp and titania as the major phases along with minor amounts of calcium titanate and α-tri calcium phosphate. Ca and P are present on surface of obtained layers as well as predictable Ti and O based on the XPS results. Thickness profile of coatings figured out that by... 

Nanostructured molybdenum oxide having a particle size in the range of 30-80 nm was prepared by potentiodynamic electrodeposition method, and the effects of H2SO4 concentration on its capacitive behavior were studied by cyclic voltammetry, galvanostatic discharge, and electrochemical impedance spectroscopy. Poor to fair capacitive behaviors were witnessed depending on the electrolyte concentration and conditions of charge/discharge. Increasing acid concentration to 0.02 M had favorable effect, while beyond that, the effect was detrimental. Capacitance around 600 F g-1 was recorded in the potential range of 0 to -0.55 V vs. Ag/AgCl  

Micro arc oxidation was employed to grow TiO2/hydroxyapatite composite layer on titanium substrate. The correlation between electrolyte concentration, diameter and density of the pores in fabricated layers was investigated. Therefore, the effect of electrolyte concentration on composition and morphology of grown layers was studied using SEM, EDX, XRD and XPS techniques. Samples were coated in electrolytes containing 5, 10 and 15 g/l calcium acetate and 1, 3 and 5 g/l β-glycerophosphate, at optimized voltage for 3 min. Pore size variations obey a similar pattern by the addition of both calcium acetate and β-glycerophosphatein various concentrations based on SEM observations. However,... 

Micro Arc Oxidation (MAO) process was utilized to fabricate nano bioceramic TiO 2-hydroxyapatite coatings on titanium substrates. Samples were produced in electrolytes contained 1 g/l β-glycerophosphate and 5, 10 and 15 g/l calcium acetate for 3, 6 and 10 min at 350 V. The techniques including XRD, XPS, SEM, FESEM and EDX were employed to study the effect of processing parameters. Hydroxyapatite, anatase, α-tri calcium phosphate and calcium titanate phases as well as 30-60 nm-size crystals were detected in the coating layer. It was also observed that the pore volume would increase by increasing the electrolyte concentration. The growth time was also found to influence the total pore volume.... 

In this study, the values of the surface tension for a number of single aqueous electrolyte solutions were measured at various temperatures and electrolyte concentrations using the well-known and computer-aided pendant-drop method. In order to conduct the experimental measurements, a high-pressure IFT-700 apparatus, equipped with a view cell and a data acquisition system, was used. The systems studied in this study were aqueous solutions of KCl, NaCl, CaCl 2, and Na 2SO 4. The pooled standard deviation and the confidence limit of the surface-tension data for a 95 % confidence level were determined to be 0.17mN · m -1 and σ̄ ± 0.19, respectively. It should be noted that while the surface... 

Pure titania porous layers consisted of anatase and rutile phases, chemically and structurally suitable for catalytic applications, were grown via micro-arc oxidation (MAO). The effect of applied voltage, process time, and electrolyte concentration on surface structure, chemical composition, and especially photocatalytic activity of the layers was investigated. SEM and AFM studies revealed that pore size and surface roughness of the layers increased with the applied voltage, and the electrolyte concentration. Moreover, the photocatalytic performance of the layers synthesized at medium applied voltages was significantly higher than that of the layers produced at other voltages. About 90% of... 

It has been attempted to gain a new viewpoint in transient cell modeling of vanadium redox flow battery. This has been achieved by considering electrochemical relations along with conceptual electrical circuit of this kind of battery. The redox flow battery is one of the best rechargeable batteries because of its capability to average loads and output power sources. A model of transient behavior is presented in this paper. The transient features are considered as the most remarkable characteristics of the battery. The chemical reactions, fluid flow, and electrical circuit of the structure govern the dynamics. The transient behavior of the redox flow battery based on chemical reactions is... 

Sulfur doped TiO2 layers containing nano/micro-sized pores were synthesized by micro-arc oxidation process. Effect of the applied voltage and the electrolyte composition on physical and chemical properties of the layers was investigated using SEM, AFM, XRD, XPS, and EDS techniques. A UV-vis spectrophotometer was also used to study optical properties of the layers. It was found that the doped layers were porous with a pore size of 40-170 nm. They consisted of anatase and rutile phases with varying fraction depending on the applied voltage and electrolyte concentration. Our XPS investigations revealed the existence of sulfur in the forms of S4+ and S6+ states which substituted Ti4+ in the... 

WO3-TiO2 nano porous layers were synthesized by micro arc oxidation (MAO) process under different applied voltages in electrolytes containing sodium tungstate and phosphate salts with various concentrations. X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and energy dispersive X-ray spectroscopy (EDS) techniques were employed to study phase structure and chemical composition of the layers. According to our data analysis, the nano porous layers consisted of anatase, rutile, and tungsten oxide phases with a varying fraction depending on the voltage and electrolyte concentration. Moreover, it was found that WO3 not only dispersed in the TiO2 matrix, but also doped into the TiO2... 

In this research, the effect of applied voltage and electrolyte concentration on structure, chemical composition, optical properties, and especially photo-catalytic activity of the TiO2 layers containing micro/nano-sized pores are discussed. TiO2 layers were synthesized by micro arc oxidation (MAO) process using different electrolyte concentrations and applied voltages. Surface structure of the layers was studied by scanning electron microscope (SEM); furthermore, energy dispersive spectrophotometry (EDS), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS) techniques were employed to determine phase structure and chemical composition of the layers. Photo-activity of the... 

Micro-arc oxidation process was used to synthesize V2O5-TiO2 porous layers for the first time. Surface morphology and topography of the layers were investigated by scanning electron microscope (SEM) and atomic force microscope (AFM). X-ray diffraction (XRD) and X-ray photoelectron spectroscopy (XPS) techniques were also employed to evaluate phase structure and chemical composition of the layers. It was found that the V2O5-TiO2 layers consisted of anatase, rutile, and vanadium pentoxide phases fraction of which varied with the applied voltage and the electrolyte concentration. It was also revealed that pore size and surface roughness increased with the applied voltage and the electrolyte...