Sharif Digital Repository

Porous silicon samples obtained from p+-type silicon wafers were impregnated with Pd by electroless process in different conditions. Scanning electron microscopy was used to study the change in the features of the surface after palladium plating. Results showed how the factors like Pd-salt concentration, HCl concentration, temperature of the electroless solution and the time of process affect on the growth and nucleation of Pd particles. Observations demonstrated that illumination-assisted process and pre-oxidation of the surface before process have drastic effect on the growth of palladium. Variation of the electrical resistance in the presence of diluted hydrogen at room temperature... 

A novel approach is obtained during the fabrication of NiCoFe-B nanotube arrays via electroless method. Porous anodic aluminum oxide (AAO) templates fabricated by anodization of aluminum foil were sensitized using PdCl 2 solution and immersed into electroless plating baths at room temperature to produce nanotube arrays. Compositional and morphological properties of the nanotube arrays are characterized. Results indicates the formation of end-closed nanotubes with the dimension of 100-130 nm in outside diameter, which is determined by the pore size of the AAO template, and about 15 nm in thickness of tube walls. The possible formation mechanism of end-closed metallic nanotube arrays is... 

Tungsten oxide thin films on glass substrates were fabricated by pulsed laser deposition under different experimental conditions for gasochromic applications. Palladium clusters were overlaid on the film surface by the electroless plating method. Hydrogen gasochromic investigation revealed that desirable samples are amorphous deposited films in oxygen partial pressure. The maximum colouration velocity of deposited films at 13.3 Pa oxygen partial pressure and 25 °C, 150 °C and 300 °C substrate temperatures are 0.010 s-1, 0.027 s-1 and 0.030 s-1, respectively, while at 300 °C substrate temperature by increasing the oxygen partial pressure to 66.7 Pa the maximum colouration velocity enhances to... 

The present paper demonstrates the performance of the radiation grafting technique as a chemically based surface pretreatment method to adhesion modification of polyethylene surfaces toward the metallic layer. Gamma irradiation over a dose range of 4-10 kGy is used for grafting of vinyl monomers including acrylamide (AAm) and 1-vinyl-2-pyrrolidone (NVP) onto the surface of three different polyethylenes including low density polyethylene (LDPE) and two kinds of high density polyethylenes, namely HDPE-1 and HDPE-2. The grafting yield is evaluated based on the weight increase of the samples. It is found that the grafting yield is dominated by the crystallinity of the polyethylene, so that lower... 

Nickel-Boron-Titania (Ni-B-TiO2) composite coatings were successfully obtained on mild steel (St-37) by simultaneous electroless deposition. TiO2 particles were dispersed in a suspension by ultrasonic irradiation. The surface morphology, particle size, elemental composition and phase analysis of the coatings were characterized by scanning electron microscopy (SEM), inductively coupled plasma (ICP) and X-ray diffraction (XRD). The hardness and friction coefficient of as- plated and heat treated Ni-B and Ni-B-TiO2 composite coatings were determined by Vickers diamond indentation and indentation scratch tests and compared with Ni-B coatings. As a result, the hardness (1263 HV) of the as-plated...