Loading...
Search for: different-solvents
0.005 seconds

    Understanding the polydisperse behavior of asphaltenes during precipitation

    , Article Fuel ; Vol. 117, issue. PART A , 2014 , pp. 206-217 Tavakkoli, M ; Panuganti, S. R ; Taghikhani, V ; Pishvaie, M. R ; Chapman, W. G ; Sharif University of Technology
    Abstract
    Asphaltenes are a polydisperse fraction of the crude oil, the phase behavior of which is significantly affected by the changes in pressure, temperature and composition. The focus of this study is to model the polydisperse asphaltenes' precipitation onset condition and the amount of precipitate from solvent-diluted crude oils using the Perturbed Chain form of the Statistical Associating Fluid Theory (PC-SAFT) over a wide range of crude oil density. Heavy oil and bitumen production can involve diluting with paraffinic solvents. Different fractions of the polydisperse asphaltenes thus precipitated are predicted and when compared to the experimental data show a remarkable matching for different... 

    Determination of antioxidant component and activity of rice bran extract

    , Article Scientia Iranica ; Volume 18, Issue 6 , December , 2011 , Pages 1402-1406 ; 10263098 (ISSN) Arab, F ; Alemzadeh, I ; Maghsoudi, V ; Sharif University of Technology
    2011
    Abstract
    Rice bran is one of the most important co-products in the rice milling. In this research, antioxidant activity of two Iranian rice bran varieties, Fajr and Tarem, extracted by three different solvents (methanol, ethanol and ethyl acetate) was evaluated. The order of antioxidant activity was evaluated by measurement of total phenolic content, antioxidant activity in linoleic acid system, reducing power and scavenging capacity by DPPH radical. The methanolic extract of Fajr rice bran showed a total phenolic content of 3.31 mg Gallic acid/gr rice bran and a DPPH free radical-scavenging activity of 93.91%, achieved at 50 mg/ml concentration, and a percent inhibition of linoleic acid peroxidation... 

    Modeling and optimization of asphaltene deposition in porous media using genetic algorithm technique

    , Article Society of Petroleum Engineers - International Oil and Gas Conference and Exhibition in China 2010, IOGCEC, 8 June 2010 through 10 June 2010 ; Volume 1 , June , 2010 , Pages 479-491 ; 9781617388866 (ISBN) Hematfar, V ; Kharrat, R ; Ghazanfari, M. H ; Bagheri, M. B ; Sharif University of Technology
    2010
    Abstract
    Different models have been proposed for deposition of asphaltene on reservoir rocks that due to complexity of asphaltene nature, most of them have not been productive. Here, a reliable model is proposed which despite of previous models, considers the change in asphaltene saturation in the core. The obtained experimental data in the laboratory was used for model validation. In this work, a series of core flooding tests was carried out in presence of connate water at different solvent-oil volume ratios. Pressure drop was measured at three different terminals along the core. The obtained experimental data as well as mass balance equations, momentum equation, asphaltene deposition and... 

    Effect of casting solvent on the characteristics of nafion/TiO2 nanocomposite membranes for microbial fuel cell application

    , Article International Journal of Hydrogen Energy ; Volume 41, Issue 1 , 2016 , Pages 476-482 ; 03603199 (ISSN) Bazrgar Bajestani, M ; Mousavi, S. A ; Sharif University of Technology
    Elsevier Ltd  2016
    Abstract
    Synthesis and characterization of Nafion/TiO2 membranes (TiO2 1 wt%) with different solvents (DMF, DMAc, NMP) for proton exchange membrane operating at Microbial Fuel Cell (MFC) was investigated in this study. Nanocomposite membranes are studied due to their better physical properties and higher production voltage in comparison with Nafion 112 in MFC systems. Nafion/TiO2 nanocomposite membranes were prepared by solution casting Method. The structures of membranes were investigated by Scanning Electron Microscopy (SEM). In addition, water uptake, proton conductivity, and ion exchange capacity (IEC) of membranes were measured and compared with Nafion 112 in microbial fuel cell. The... 

    One-dimensional cadmium sulfide (CdS) nanostructures by the solvothermal process: Controlling crystal structure and morphology aided by different solvents

    , Article Materials Letters ; Volume 65, Issue 9 , 2011 , Pages 1291-1294 ; 0167577X (ISSN) Dalvand, P ; Mohammadi, M. R ; Fray, D. J ; Sharif University of Technology
    Abstract
    Cadmium sulfide (CdS) nanowires and nanorods with different aspect ratios were successfully synthesized by the solvothermal method aided with various solvents, namely ethylenediamine, ethanolamine and triethylene tetraamine. X-ray diffraction (XRD) and Fourier transform infrared spectroscopy (FTIR) analyses revealed that, highly pure CdS nanostructures were crystallized with different structures and preferable growth orientations depending on solvent nature. Field emission electron microscope (FE-SEM) images showed that the aspect ratio of CdS nanostructures depends upon the dielectric constant and boiling temperature of solvents. CdS nanostructures with the highest aspect ratio in the form...