Sharif Digital Repository

We propose a bidirectional terahertz (THz) spectrum splitter using a practically simple metamaterial structure consisting of rectangular grooves covered by graphene. Thanks to the graphene optoelectronic tunability and by adjusting the grooves width, this structure provides nearly 2π phase shift. At the same time, the reflection efficiency is acceptable throughout the phase shifts. We design each of the meta-atoms using a circuit model, and then we synthesize the final supercell based on the generalized Snell’s law so that the structure reflects different frequency waves to totally different directions. The full-wave simulations demonstrate the beam splitting with a remarkable efficiency of... 

Echo and sound resonance in a conference room cause obscure speech and make listeners tired. Thus, the acoustical properties of a conference room are vitally important. The conference room 412 at Sharif University Physics Department failed to meet basic acoustical standards. The aim of this research is to improve reverberation time (RT) of the conference room using Helmholtz resonators with defined dimensions, diffusers, and sound absorbers. Helmholtz resonators are widely used to absorb sound noise especially at low frequencies. They are particularly useful when noise has a narrow-frequency band. One of the advantages of using Helmholtz resonators is their capacity to be tuned on different... 

Data aggregation is a key, yet time-consuming functionality in wireless sensor networks (WSNs). Multi-channel design is a promising technique to alleviate interference as a primary reason for long latency of TDMA aggregation scheduling. Indeed, it provides more potential of parallel transmissions over different frequency channels, thus minimizing time latency. In this paper, we focus on designing a multi-channel minimum latency aggregation scheduling protocol, named MC-MLAS, using a new joint approach for tree construction, channel assignment, and transmission scheduling. To our best knowledge, this is the first work in the literature which combines orthogonal channels and partially... 

In this study, the authors extend the concept of relay channel with orthogonal components to define a class of symmetric relay networks with orthogonal components named symmetric orthogonal relay network. In the defined network, the channels diverge from each node sender use different frequency bands whereas the channels converge to each node receiver use the same frequency band. This structure is very well understood in half-duplex transmission systems where the relays cannot send and receive at the same time or over the same frequency band. The authors show that the unicast capacity of the defined network is equal to the cut-set bound. In the achievability proof, the authors take advantage... 

Nowadays, design and tuning of controllers with predefined structures are among the most popular topics in control system theory. During the last decade, many studies have focused on designing fixed-structure fractional-order compensators. This paper presents a generalized version of fractional-order compensators to achieve the required magnitudes and phases at two given frequencies (for example, to achieve desired phase and gain margins with adjustable cross frequencies). In this generalization, at first some basic analysis of the phase behaviour of this introduced type of fractional-order compensators is presented. Also, exact formulas are found for designing this family of compensators in... 

This paper presents a new experimental-numerical method for deriving the transfer functions of a half-automobile model, containing: chassis, body, engine, engine mount and steering wheel, with five degrees of freedom. In this method different parts of system are not required to be disassembled from the main system and the transfer functions of subsystem are obtained through testing of the whole system. This method is based on the experimental results and does not need a mathematical model of the half-automobile. In this method, transfer functions of various parts of chassis are calculated through obtaining the response of secondary elements mounted on the chassis to the displacement input... 

In this paper, we investigate the implementation of wavelet modulation (WM) in a digital communication system and propose novel methods to improve its performance. We will put particular focus on the structure of an optimal detector in AWGN channels and address two main methods for inserting the samples of the message signal in different frequency layers. Finally, computer based algorithms are described in order to implement and optimize receivers and transmitters  

This article presents a novel dual-band transmission line (TL), consisting of a multibranch stub, which can provide equal unwrapped phases at two different frequencies. The frequency ratio can be close to one without any significant degradation in the device performance. Besides, the bandwidth of the proposed line can be manipulated at both frequencies by adjusting the design parameters. The behavior of the structure over the frequency bands is investigated theoretically, and the design procedure and relations are derived. The simulation and measurement results of a quarter-wavelength open-ended stub and a branch-line coupler (BLC) are presented and compared to verify the performance of the... 

Fast, accurate and efficient sensing is of important aspects in cognitive radio technology. A new sensing circuit is proposed using a phase frequency detector for cognitive radio applications. Using this method, spectral sensing can be done in a very short time by a low cost, low power circuit, compared with available implemented methods. The PFD circuit resolves different frequencies without the need of variable filter bandwidth or the banks of filters. Also it accelerates sensing procedure because of short time needed to detect the signal. Simulations show the accurate operation of this method and comparison with other methods shows faster sweep rates  

In this paper a novel T type scheme for 1-phase direct ac/ac converters is proposed. In this topology, frequency changing takes place directly (without common DC voltage bus) through three converters that are connected in a T structure. Unity power factor and precise output voltage regulation is achieved through appropriate control of these three converters. H-bridge converters are implemented, as the basic unit, in each branches of T to make the proposed converter. The converter is controlled such that the average active power of each H-bridges remains zero. So capacitors are implemented in DC links of H-bridges. In comparison to conventional back-to-back converters, life time of each... 

Enhancement of heat transfer is investigated in an experimental study of ferrofluid flow in a tube subjected to a constant and uniform heat flux on its wall, filled with permeable material under the effect of magnetic field. Effect of ferrofluid volume fraction, Reynolds number, and different frequencies of various magnetic field modes on heat transfer is examined by measuring the temperature on the wall. Using ferrofluid under the effect of magnetic field improves the heat transfer, and porous media makes the temperature distribution more uniform. Volumetric percentage of nano-particles has the greatest effect on the heat transfer  

In this paper, microgravity modulation effects on free convection in a cavity are investigated using the lattice Boltzmann method. In order to create microgravity modulation, a sinusoidal time-dependent function is considered. Parameters of the flow are chosen such that the maximum Rayleigh number approaches 106. The natural frequency of the system is obtained at first. Afterwards, effects of different frequencies on the flow and heat transfer fields are investigated in detail. Results are presented in four different frequency ratios categorized as (1) ω∗=1200, 1100, 120, and 110; (2) ω∗=18, 15, 13, and 12; (3) ω∗ = 0.75, 0.85, and 0.95; and (4) the last one is considered for natural... 

Attention as a cognitive aspect of brain activity is one of the most popular areas of brain studies. It has significant impact on the quality of other activities such as learning process and critical activities (e.g. driving vehicles). Because of its crucial influence on the learning process, it is one of the main aspects of research in education. In this study, we propose a brand new protocol of brain signal recording in order to classify human attention in educational environments. Unlike other protocols used to record EEG signals, our protocol does not require strong memory and strong language knowledge to carry out. To this end, we have recorded EEG signals of 12 subjects using the... 

Steady-State Visual Evoked Potentials (SSVEPs) are one of the most important EEG signals used in Human Computer Interface (HCI) systems. These signals are generated by Looking at flickering external light sources stimulating the central part of the retina. By increasing the number of external light sources, detection of the corresponding SSVEPs from the recorded EEG signal becomes more complicated. On the other hand, the ratio of the sensitivity to specificity in high-speed classifiers becomes more significant. This study presents the effect of the twinkling frequencies and the inter-sources distance of two Light Emitting Diodes (LEDs) on the ratio of the sensitivity to specificity of the... 

Chatter suppression in machining processes results in more material removal rate, high precision and surface quality. In this paper, a single degree of freedom model of orthogonal turning process is used to set up the delay differential equation of motion with considering the tool wear effect as a contact force between the workpiece and tool flank surfaces. Sinusoidal spindle speed variations with different frequencies around the mean speed are modulated to disturb the regenerative mechanism. The optimal amplitudes of the speed modulations are found based on a genetic algorithm such that the input energy to the turning process is minimized. Results of the stability analysis and the... 

Embedded systems account for wide range of applications. However, the design of such systems is faced with a diverse spectrum of criteria. The energy consumption, performance, and demanding security concerns are some of the most significant challenges in designing of such systems. With these challenges, the design process can be managed more easily if a flexible logic circuit with the ability of satisfying the abovementioned concerns is taken into account. To achieve such a logic circuit, in this paper we have combined the sub-threshold operation and charge recovery techniques. Using our technique, lower power consumption, ability of operating at higher frequencies, and more security (to... 

Parameter variations reveal themselves as different frequency and leakage powers per instances of the same MPSoC. By the increasing variation with technology scaling, worst-case-based scheduling algorithms result in either increasingly less optimal schedules or otherwise more lost yield. To address this problem, this paper introduces a variationaware task and communication scheduling algorithm for multiprocessor system-on-chip (MPSoC). We consider both delay and leakage power variations during the process of finding the best schedule so that leakier processors are less utilized and can be more frequently put in sleep mode to reduce power. Our algorithm takes advantage of event tables to... 

This article proposes a bang-bang auxiliary frequency control scheme for doubly-fed induction generator (DFIG)-based wind turbines. It results in the DFIGs emulate the primary frequency control of conventional units and, thus, increases the power system frequency stability. Indeed, the suggested hysteresis controller causes to deliver the maximum extractable kinetic energy of DFIGs to the grid and consequently further enhance the power system frequency. This is accomplished using different frequency deviation indices, which determine the size of power mismatch and lead to an appropriate frequency response by the DFIGs. The operational constraints of the DFIGs are taken into account in the... 

Accelerograms recorded near active faults have some important characteristics that make them different from those recorded in far-fault regions. High-frequency components in acceleration records and long-period velocity pulses are among notable specifications of such ground motions. In this paper, a moving average filtering with appropriate cut-off frequency has been used to decompose the near-fault ground motions into two components having different frequency contents: first, Pulse-Type Record (PTR) that possesses long-period pulses; second, the relatively high-frequency BackGround Record (BGR), which does not include large velocity pulses. Comparing the results with those extracted through... 

In this study, a dielectrophoresis field-flow fractionation device was analyzed using a numerical simulation method and the behaviors of a set of different cells were investigated. By reducing the alternating current frequency of the electrodes from the value used in the original setup configuration and increasing the number of exit channels, total discrimination in cell trajectories and subsequent separation of four cell types were achieved. Cells were differentiated based on their size and dielectric response that are represented in their real part of Clausius–Mossotti factor at different frequencies. A number of novel designs were also proposed based on the original setup configuration....