Sharif Digital Repository

A thorough investigation on different controlled release systems were evaluated. The required devices were constructed simultaneously and the required experiments were performed. The polymeric network and membranes of poly vinyl alcohol with cross-linking agent glutaraldehyde for preparation of hyrogel system was effected. Paraquat, a type of herbicide was introduced as solute in the system. Glutaraldehyde was utilized as cross-linking agent at different concentration. Increase in the concentration of the cross-linking agent will cause a decrease in the extent of release out of the system. The effect of temperature on hydrogel adsorption demonstrates a higher adsorption at lower temperature.... 

Thermal cracking is the prevalent type of distress experienced by asphalt pavements in cold regions. It is widely assumed that when thermal stresses induced in the pavement exceed the tensile strength of the asphalt surface layer, cracking occurs; however, the role of thermal fatigue should not be ignored. To better describe the low-temperature (LT) performance properties of modified asphalt binders, a new parameter, normalised tensile stress (NTS), was defined in this research. NTS values were compared with bending beam rheometer (BBR), direct tension (DT) and semi-circular bending (SCB) fracture test results. The m-value parameter of the BBR test specifies the type of asphalt binder. This... 

Thermal cracking is the prevalent type of distress experienced by asphalt pavements in cold regions. It is widely assumed that when thermal stresses induced in the pavement exceed the tensile strength of the asphalt surface layer, cracking occurs; however, the role of thermal fatigue should not be ignored. To better describe the low-temperature (LT) performance properties of modified asphalt binders, a new parameter, normalised tensile stress (NTS), was defined in this research. NTS values were compared with bending beam rheometer (BBR), direct tension (DT) and semi-circular bending (SCB) fracture test results. The m-value parameter of the BBR test specifies the type of asphalt binder. This... 

Herein, poly (acrylic acid) (PAA) microgels were synthesized via alcohol type cross-linked by a free radical precipitation polymerization approach. At the first time, 1,6-hexanediol (1–6 diol), trimethylolpropane (TMP), and pentaerythritol (PEN) were selected as multifunctional cross- linking agent to synthesize cross-linked poly(acrylic acid) microgels. Alcohol type cross-linking agents can connect the PAA chains. The cross-linking reaction takes place due to reaction between hydroxyl groups of various cross-linkers and carboxyl groups of PAA chains. All of the hydroxyl groups do not participate in the reaction with acid groups of polymer chains through the polymerization stage; therefore,... 

Chitosan was crosslinked with different amount of glutaraldehyde to prepare appropriate hydrogels to be used as drug delivery system. The swelling behavior of freeze-dried hydrogels in aqueous media at different temperature and pHs has been examined. The swelling, porosity and biocompatibility behavior of samples were investigated to check effects of polymer/polymer and polymer/drug interactions on these system characteristics. Obtained experimental results illustrates that with increasing crosslinking agent from 0.068 to 0.30, swelling of the prepared samples degrees from 1200% to 600% and pore diameters change from 100 to 500 μm. To investigate systems biocompatibility in gastric... 

A simple method for synthesis of novel organogels based on multiwalled carbon nanotubes (MWCNTs) is reported. Three classes of organogels were synthesized by crosslinking polymerization of dodecyl methacrylate with various weight percentages of 1,4-butanediol dimethacrylate, vinyl-group-modified MWCNTs or pristine MWCNTs in the presence of 2,2-azoisobutyronitrile as initiator. In this reaction, the carbon nanotubes (CNTs) served simultaneously as an adsorbent, a comonomer and a crosslinking agent. The oil-absorbent containing CNTs showed much higher swelling capacity in oil and organic solvents compared with that without CNTs. Therefore, CNT-based organogels can be introduced as a promising... 

Herein, poly (acrylic acid) (PAA) microgels were synthesized via alcohol type cross-linked by a free radical precipitation polymerization approach. At the first time, 1,6-hexanediol (1–6 diol), trimethylolpropane (TMP), and pentaerythritol (PEN) were selected as multifunctional cross- linking agent to synthesize cross-linked poly(acrylic acid) microgels. Alcohol type cross-linking agents can connect the PAA chains. The cross-linking reaction takes place due to reaction between hydroxyl groups of various cross-linkers and carboxyl groups of PAA chains. All of the hydroxyl groups do not participate in the reaction with acid groups of polymer chains through the polymerization stage; therefore,... 

A series of biopolymer-based superabsorbent hydrogels based on carboxymethyl cellulose has been prepared by free-radical graft copolymerization of acrylamide and 2-acrylamido-2-methylpropan sulfonic acid (AMPS) in aqueous solution using methylenebisacrylamide as a crosslinking agent and ammonium persulfate as an initiator. The effect of variables on the swelling capacity such as: acrylamide/AMPS weight ratio, reaction temperature, and concentration of the initiator and crosslinker were systematically optimized. The results indicated that with increasing the amount of AMPS, the swelling capacity is increased. FT-IR spectroscopy and scanning electron microscope analysis were used to confirm... 

In this research, the effects of crosslinking agent and clay content on the morphology, barrier and mechanical properties of ethylene vinyl acetate-organoclay nanocomposites prepared by solution method were studied. Dicumyl peroxide has been used as crosslinking agent. The morphology of the prepared nanocomposites was investigated using wide-angle X-ray diffraction and transmission electron microscopy. Wide-angle X-ray diffraction and transmission electron microscopyindicated that the prepared nanocomposites had predominantly intercalated morphologies. The obtained results of permeability tests showed that the permeability of ethylene vinyl acetate films dramatically decreases with addition... 

This article reports the first oil-absorbent cross-linked copolymer consisting of modified multiwalled carbon nanotube (MWCNT) and showing high oil absorbency. Also, to investigate and evaluate the effective parameters on oil absorbency, cross-linked dodecyl methacrylate (DDMA)-diphenylacrylamide (DPAA) and DDMA-butyl acrylate (BA) copolymers were synthesized. DDMA was copolymerized with different mol% of DPAA or BA and cross-linked using azobisisobutyronitrile as the initiator and various weight percentages of 1,4-butandiol dimethacrylate, methylene bisacrylamide, or vinyl group-modified MWCNT cross-linkers. The effects of monomer feed composition, cross-linker concentration, and the... 

Synthesis of dextran-graft-poly(hydroxyethyl methacrylate) gels as a new fluoride biosorbent was considered in this work. For this propose, the Taguchi experimental design method was used for optimizing the synthetic conditions of the gels to reach high level of fluoride absorbency. The effects of three main parameters including concentrations of monomer (hydroxyethyl methacrylate), crosslinking agent (ethylene glycol dimethacrylate), and initiator (ammonium persulfate) on the final properties of the prepared gels were investigated. The proposed mechanism for grafting and chemically crosslinking reactions was proved with equilibrium water absorption, Fourier-transformed infrared, scanning... 

Salep, known as a biodegradable polysaccharide, is hydrolyzed and used as both a reducing agent and stabilizer for graphene oxide (GO). The functionalized reduced graphene oxide (f-rGO) is homogenously dispersed in an aqueous solution of poly(vinyl alcohol) (PVA). PVA based hydrogel and film nanocomposites are prepared and proposed as new biomaterials for tissue engineering applications. The mechanical properties of the film nanocomposites are investigated with varying content of f-rGO, glycerol and citric acid as a reinforcing agent, a plasticizer agent and a cross linking agent respectively. For the first time, chemically cross linked PVA hydrogels are synthesized using... 

Biocompatible porous polymeric scaffolds provide a suitable environment for proliferation of stem cells in human body. In this research work, porous gelatin–poly(ethylene glycol), PEG, based scaffolds were prepared using combination of freeze-gelation and freeze-extraction methods. Effects of various parameters such as freezing temperature, cross-linking agent, concentrations of gelatin and PEG and their blending ratio on physical and mechanical properties, swelling ratio, porosity, pore size, and degradation rate of scaffolds were investigated. Also, proliferation of fibroblast skin cells on the scaffolds was examined by MTS assay to assess the suitability of the scaffolds in wound healing... 

An easy and ecofriendly method for designing double-network (DN) hydrogels based on chitosan and poly(vinyl alcohol) (PVA) with high mechanical performance is described. When covalent bonds in the networks are used as crosslinking agents in the achievement of a higher mechanical strength, the irreversible deformation of these hydrogels after a large force is applied is still one of the most important obstacles. To overcome this problem, we used physical crosslinking for both networks. The mechanical strength, surface morphology, and cytotoxicity of the films were studied by tensile testing, scanning electron microscopy analysis, and an MTT assay. The synthesized chitosan–PVA DN hydrogels... 

In this study, the synthesis and characterization of a novel nano-porous superabsorbent hydrogel with high water swelling capacity is described. A nano-porous hydrogel was prepared by employing (2-dimethylaminoethyl) methacrylate (PDMAEMA) as a pH sensitive monomer and sodium alginate (SA) as a water soluble polysaccharide under γ-ray irradiation. The polymerization reaction was performed at room temperature in the absence of chemically toxic crosslinking agent and initiators. The interactive parameters including biopolymer backbone concentration, monomer concentration and γ-irradiation dose were selected as major factors in the synthesis of superabsorbent and three levels for each factor... 

A series of superabsorbent composites were synthesized through graft copolymerization of acrylic acid (AA) onto carboxymethyl cellulose (CMC) in the presence of celite powder using N,N'-methylenebisacrylamide (MBA) as a cross-linking agent and ammonium persulphate (APS) as an initiator. The chemical structure and thermal properties of the composite hydrogels were characterized by FTIR spectroscopy and TGA methods, respectively. Morphology of the samples was examined by scanning electron microscopy (SEM). In free-state, the swelling conditions and hence the related data are not real, because in all their applications the swelling particles of superabsorbent must absorb aqueous solutions while... 

A novel full-polysaccharide hydrogel was prepared by crosslinking of chitosan with periodate-oxidized sucrose. A tetraaldehyde molecule is synthesized via periodate oxidation of sucrose and then applied as a crosslinking agent to form a new hydrogel network. A mechanism for the superabsorbent hydrogel formation via reductive N-alkylation was also suggested. The structure of the hydrogel was confirmed by FTIR spectroscopy, scanning electron microscopy (SEM), and thermogravimetric analysis (TGA). It is shown that crosslinking of chitosan can improve its thermal stability. The effects of crosslinker concentration, pH, and inorganic salt on the swelling behavior of the hydrogel were studied. The... 

This work focused on the design of new pH-responsive nanoparticles for controlled delivery of anticancer drug doxorubicin (Dox). Nanoparticles of poly(methacrylic acid)-polysorbate 80-grafted starch (PMAA-PS 80-g-St) were synthesized by using a one-pot method that enabled simultaneous grafting of PMAA and PS 80 onto starch and nanoparticle formation in an aqueous medium. The particles were characterized by FTIR, 1H NMR, TEM, DLS, and potentiometric titration. Dox loading and in vitro release from the nanoparticles were investigated. The FTIR and 1H NMR confirmed the chemical composition of the graft terpolymer. The nanoparticles were relatively spherical with narrow size distribution and...