Sharif Digital Repository

The aim of this study is to investigate the effect of the rock brittleness indexes on the specific ampere draw of the circular diamond saws. In this study, twelve rock types belonging to granite and carbonate rock were cut with two different types of circular diamond saws on a fully instrumented laboratory-sawing rig at different feed rate and depths of cut. Rock samples were collected from factories from Iran for laboratory tests and uniaxial compressive strength and tensile strength were determined. The brittleness of B 1 (the ratio of compressive strength to tensile strength), B 2 (the ratio of compressive strength minus tensile strength to compressive strength plus tensile strength), and... 

The prediction of rock sawability is very important in the cost estimation and the best planning of the plants. Rock sawability depends on the machine characteristics and rock mechanical properties. In this study, a new classification was developed with the respect to rock mechanical properties such as Uniaxial Compressive Strength, Brazilian tensile strength, Schmidt hammer value and Los Angeles abrasion loss. Using this system the carbonate rock sawability index (CRSi) of several types of carbonate rock was evaluated and classifi ed into fi ve categories and then a new model was developed with the respect to CRSi and machining characteristics by using the statistical analyses for... 

Water flooding is widely applied for pressure maintenance or increasing the oil recovery of reservoirs. The heterogeneity and wettability of formation rocks strongly affect the oil recovery efficiency in carbonate reservoirs. During seawater injection in carbonate formations, the interactions between potential seawater ions and the carbonate rock at a high temperature can alter the wettability to a more water-wet condition. This paper studies the wettability of one of the Iranian carbonate reservoirs which has been under Persian Gulf seawater injection for more than 10 years. The wettability of the rock is determined by indirect contact angle measurement using Rise in Core technique.... 

The experimental study and modeling of gravity drainage during Water Alternative Gas Injection, WAG process, in carbonate rock for one of the Iranian off-shore reservoir at lab-scale were carried out. The mechanism of gravity drainage during the WAG process, and its contribution to the oil recovery in the fractured carbonate reservoirs were also studied. In the WAG process alternatively gas is injected during the process and gravity drainage could be happened. Changes in the block dimensions, rock properties, oil properties, gas properties, and fractures properties and their effect on the amount of oil recovered during the gravity drainage mechanism were studied. It would be worth mentioning... 

Gas injection process for more oil recovery and in particular CO2 injection is well-established method to increment oil recovery from underground oil reservoirs. CO2 sequestration which takes place during this enhanced oil recovery (EOR) method has positive impact on reducing the greenhouse gas emission which causes global warming. Direct gas injection into depleted oil reservoirs, encounters several shortcomings such as low volumetric sweep efficiency, early breakthrough (BT) and high risk of gas leakage in naturally fractured carbonate oil reservoirs. Carbonated water injection (CWI) has been recently proposed as an alternative method to alleviate the problems associated with gas... 

The prediction of production rate in ornamental stones sawing is very important in cost estimation and process planning of the rock sawing plants. The main aim of this paper is finding a mathematical correlation between production rate and rock brittleness indexes. The utilized data have been collected from several stone factories in Iran. Seventeen different granite and carbonate rocks have been experienced sawing conditions with large-diameter circular saws. The laboratory tests such as uniaxial compressive strength and tensile strength, were carried out on the rock samples which were collected from these factories. The ratio of compressive strength to tensile strength (B1), the ratio of... 

Petrography and image analysis have been widely used to identify and quantify porous characteristics in carbonate reservoirs. This paper uses the thin section images of 200 carbonate rock samples to predict the absolute permeability using intelligent and empirical methods. For each thin section, several pore network parameters are extracted from thin section images of rocks including the average pore size, average throat size, average throat length and average 2-D coordination number of pore network. A neural-based model successfully predicts the permeability of samples using pore network parameters as the inputs. Second neural network is applied for predicting absolute permeability... 

This study investigates the effect of stress magnitude and stress history on porosity and permeability values of anhydride and carbonate rocks. Porosity and permeability properties are measured for twelve anhydride and carbonate core samples under stress loading and unloading conditions. The results of permeability measurements show that tighter core samples are more stress dependent while the anhydride samples are generally more sensitive to the stress. The gap between stress loading and unloading (hysteresis) is more considerable at lower effective stress values. The results also indicate that the hysteresis is more noticeable in the anhydride core samples. The gas slippage factor is also... 

Low salinity water flooding (LSWF) has the potential to enhance the oil recovery by affecting the fluid-fluid and rock-fluid interactions. Therefore, a systematic investigation on the effect of initial wetting state (water-wet or oil-wet) of pure calcite is conducted to study the importance of these interactions on the effectiveness of LSWF. In the case of initially water-wet cores, more oil recovery efficiency is observed for more saline water cases. To shed light on the possible involved mechanisms, dynamic IFT, dynamic contact angle (CA), oil/brine and rock/brine surfaces zeta potentials, and effluent pH are measured. It is shown that the short-term effect of IFT reduction and long-term... 

Oil production from asphaltenic oil reservoirs has always encountered difficulties, such as plugging and unpredictable fluid properties. To physically recognize the aspects of asphaltene deposition, several dynamic and static asphaltene deposition tests were designed and performed on one of the giant south Iranian oil reservoirs using dead and live crude oil and real core samples. Moreover, the effects of fluid velocity on the extent of damage were investigated. It was found that surface deposition of asphaltene particles is the main source of formation damages in the porous media and the resulting permeability impairment obeys an exponential behavior. All of the experiments confirm that... 

In this study, kinetics, equilibrium, and mechanisms of SDBS adsorption onto carbonate rock in presence/absence of alkaline/electrolyte, which is not well discussed in the available literature, is analyzed through batch experiments. Analysis of kinetic data showed that adsorption rate of SDBS onto carbonate is controlled by both boundary layer and intraparticle diffusion, also adsorption kinetics meets pseudo second-order model. The coefficient of kinetic model is a linear function of initial and equilibrium concentrations. The adsorption isotherm experiences four distinct regions, with a rising trend in the first regions until reaching to a maximum after which decreases slightly, as the... 

In this study, kinetics, equilibrium, and mechanisms of SDBS adsorption onto carbonate rock in presence/absence of alkaline/electrolyte, which is not well discussed in the available literature, is analyzed through batch experiments. Analysis of kinetic data showed that adsorption rate of SDBS onto carbonate is controlled by both boundary layer and intraparticle diffusion, also adsorption kinetics meets pseudo second-order model. The coefficient of kinetic model is a linear function of initial and equilibrium concentrations. The adsorption isotherm experiences four distinct regions, with a rising trend in the first regions until reaching to a maximum after which decreases slightly, as the... 

Tortuosity and cementation factor are two critical parameters that significantly affect estimates of reservoir properties. Tortuosity factor can be used to estimate permeability using the Carman-Kozeny equation and is an important parameter for formation resistivity factor calculation using a modified version of Archie's formula. It is also used to predict water saturation of reservoir rocks. Tortuosity as an input parameter in Biot's equation can be used to estimate velocity dispersion. In this work, based on the Generalized Archie Equation Curve Fitting (GAECF), tortuosity and cementation factor are determined for selected intervals in a carbonate reservoir. Formation resistivity factor... 

The aim of this paper is developing a new hierarchical model to evaluate and rank the sawability (power consumption) of carbonate rock with the use of effective and major criteria, and simultaneously taking subjective judgments of decision makers into consideration. The proposed approach is based on the combination of Fuzzy Analytic Hierarchy Process (FAHP) method with TOPSIS (Technique for Order Preference by Similarity to Ideal Solution) methods. FAHP is used for determining the weights of the criteria by decision makers, and then rankings of carbonate rocks are determined by TOPSIS. The proposed method is applied for Iranian ornamental stone to evaluate the power consumption in rock...