Loading...
Search for: asphaltene-adsorption
0.007 seconds

    Investigation on Wettability Alteration of Reservoir Rock During Adsorption of Organic Component of Crude Oil

    , M.Sc. Thesis Sharif University of Technology Monjezi, Reza (Author) ; Ghotbi, Siroos (Supervisor) ; Jafari Behbahani, Taraneh (Supervisor) ; Baghalha, Morteza (Supervisor)
    Abstract
    This study investigates the dynamic adsorption of asphaltene-in-toluene solutions on pack of wet calcite. All experiments were performed on mineral packs in sand-pack with mesh sizes between 100 to 140 (105 to 150 micron) and porosities between 40 to 46 percent. A UV–vis spectrophotometer was used to monitor the outlet concentration of asphaltenes. Experiments were performed for seven ionic strength of sodium chloride (6 to 1500 mM), five ionic strength of sodium sulfate (6 to 2400 mM) and four ionic strength of these salts mixture (12 to 3300 mM). In previous experiments the asphaltene concentration is 500 mg/l. Also two experments were performed with asphaltene concentration of 2000... 

    Experimental investigation of dynamic asphaltene adsorption on calcite packs: The impact of single and mixed-salt brine films

    , Article Canadian Journal of Chemical Engineering ; Volume 97, Issue 7 , 2019 , Pages 2028-2038 ; 00084034 (ISSN) Monjezi, R ; Ghotbi, C ; Jafari Behbahani, T ; Bakhshi, P ; Sharif University of Technology
    Wiley-Liss Inc  2019
    Abstract
    In this study, the dynamic adsorption of asphaltene on a calcite surface is investigated. This study investigates the effect of mixed-salt brines on asphaltene adsorption. The results of this work can facilitate the understanding of the complex wettability behaviour of carbonate reservoirs. All experiments were performed in porous media, which were sand-packs filled with calcite powder, to study the influence of the type and concentration of salt on adsorption. The experiments were conducted with asphaltene concentration of 500 mg/L for brines of NaCl, Na2SO4, and a mixture of the two at various ionic strengths. In addition, two tests were performed with an asphaltene concentration of 2000... 

    Adsorption and Conversion of Heavy Oil Asphaltene on Composite Nanostructures

    , M.Sc. Thesis Sharif University of Technology Torka Bidokhti, Mostafa (Author) ; Ghotbi, Siros (Supervisor) ; Khodadadi, Abbasali (Supervisor)
    Abstract
    The aim of this project was to upgrade and reduce viscosity of heavy oils by adsorbing of asphaltene on Ni-Mo/CB and converting it into lighter and more valuable gas and liquid compounds. Asphaltene has been extracted from a heavy crude oil sample of Soroush oil field in Iran. After adsorption, Asphaltene conversion to lighter components (gas/liquid) was studied through hydrocracking process. To prepare the support of catalyst, Carbon Black, initially a thermal treatment step under the argon gas atmosphere followed by acid-washing process was performed. Afterward, the catalysts was prepared through dry impregnation method. In order to activate catalyst for hydrocracking, the catalysts has... 

    Investigation of asphaltene adsorption in sandstone core sample during CO2 injection: Experimental and modified modeling

    , Article Fuel ; Vol. 133 , 2014 , Pages 63-72 ; ISSN: 00162361 Jafari Behbahani, T ; Ghotbi, C ; Taghikhani, V ; Shahrabadi, A ; Sharif University of Technology
    Abstract
    In this work, asphaltene adsorption in a sandstone core sample under dynamic conditions and during miscible CO2 injection was studied using live oil sample which is close to real conditions in petroleum reservoirs. In order to investigate of damage in sandstone core sample by the deposited material such as asphaltene, the morphology analysis of sandstone core sample using scanning electron microscopic method was studied. Also analyses of the adsorbed material in sandstone core sample by Soxhlet extraction using an azeotrope mixture and with SARA method were performed. The experimental results show that by increasing the flow rate of injected CO2, the amount of asphaltene in retained material... 

    A new model based on multilayer kinetic adsorption mechanism for asphaltenes adsorption in porous media during dynamic condition

    , Article Fluid Phase Equilibria ; Vol. 375, issue , 2014 , Pages 236-245 ; ISSN: 03783812 Jafari Behbahani, T ; Ghotbi, C ; Taghikhani, V ; Shahrabadi, A ; Sharif University of Technology
    Abstract
    In this work, a new model based on multilayer kinetic adsorption mechanism has been proposed to account asphaltene adsorption in porous media under dynamic condition and the model was verified using experimental data obtained in this work and also with those reported in the literature. In the proposed model two steps are considered for asphaltene adsorption. The first step is taken as adsorption of asphaltenes on the surface of the porous media and the second step is taken as adsorption of asphaltenes on the asphaltenes already adsorbed on the porous media. The Crank-Nicholson method, central difference in space and trapezoidal rule in time, giving second order convergence in time was... 

    Investigation on asphaltene deposition mechanisms during CO2 flooding processes in porous media: A novel experimental study and a modified model based on multilayer theory for asphaltene adsorption

    , Article Energy and Fuels ; Volume 26, Issue 8 , 2012 , Pages 5080-5091 ; 08870624 (ISSN) Jafari Behbahani, T ; Ghotbi, C ; Taghikhani, V ; Shahrabadi, A ; Sharif University of Technology
    2012
    Abstract
    In this paper, oil recovery and permeability reduction of a tight sandstone core sample in miscible CO2 flooding processes due to asphaltene deposition were studied using an Iranian bottom hole live oil sample in order to distinguish between the mechanical plugging and adsorption mechanisms of asphaltene involved in the interfacial interaction of the asphaltene/mineral rock system. A novel experimental method was designed and proposed to measure the amount of deposited asphaltene due to different mechanisms using the cyclohexane or toluene reverse flooding and spectrophotometer. In this work, the bottom hole live oil sample was injected first to a long core and then CO 2 injection was... 

    Synthesis and characterization of mixed–metal oxide nanoparticles (cenio3, cezro4, cecao3) and application in adsorption and catalytic oxidation–decomposition of asphaltenes with different chemical structures

    , Article Petroleum Chemistry ; Volume 60, Issue 7 , 2020 , Pages 731-743 Dehghani, F ; Ayatollahi, S ; Bahadorikhalili, S ; Esmaeilpour, M ; Sharif University of Technology
    Pleiades Publishing  2020
    Abstract
    Abstract: This study investigates the catalytic activity of mixed–metal oxide nanoparticles with different surface acidities on asphaltene adsorption followed by catalytic oxidation–decomposition. Three different types of mixed–metal oxide nanoparticles (CeNiO3, CeCaO3 and CeZrO4) were synthesized, and their size, structure, and acid properties were characterized by field–emission scanning electron microscopy (FE–SEM), energy-dispersive X-ray spectroscopy (EDX), the high–resolution transmission electron microscopy (HR-TEM), X-ray powder diffraction (XRD), Brunauer-Emmett-Teller (BET) surface area measurement and ammonia temperature-programmed desorption (NH3–TPD). Asphaltenes were extracted...