Sharif Digital Repository

Activated carbon beds are extensively used in sweetening units of natural gas refineries for the purification of contaminated amine solutions. Correlation of experimental adsorption data using an analytical isotherm equation is need to design an accurate activated carbon bed. In the present study, the adsorption of BTEX from Diethanolamine (DEA) solution by commercial and granular activated carbon (AC) were performed. The Langmuir, Freundlich and Sips isotherm models were used to describe the equilibrium data. The accuracy of the results obtained from the adsorption isotherm models was compared and the values for the regressed parameters were reported. The results show that the Freundlich... 

Supersonic gas separator is proposed for methane purification. One-dimensional analysis is performed to examine the design aspects associated with the converging-diverging nozzle and the liquid separation chamber. The results indicate that at low swirl intensities, the separation chamber length is about 100 times of the nozzle throat. Increasing the swirl intensity would lower this length sharply and it will be less than 10 for swirl intensity of unity which is equivalent to a swirl angle of 45°. In addition, a sensitivity analysis of the separator performance to the inlet conditions like the temperature, pressure, and composition of the mixture is carried out. It is observed that increasing... 

In this work, a novel multi-layer pressure-temperature swing adsorption (PTSA) process was designed for efficient simultaneous water and mercaptans removal from natural gas (NG) to less than 0.1 ppmv and 3 ppmv in a mini liquefied NG unit. The proposed multi-layer PTSA consists of a three-layer fixed bed including activated alumina, molecular sieves 4A and 13X. To gain in-depth insights about the process, a descriptive model considering mass, energy and momentum balances, along with the kinetic and equilibrium equations was developed. After validating the model with the experimental and operational data from the literature, the total energy requirement and long-term operational requirements... 

A new method for fabrication of silver nano-islands on glass fibers using a top-down process is introduced. A thin layer of silver chemically coated on the surface of the glass fibers evolves into silver islands by heat treatment. The effect of the concentration of the initial solution and the temperature were investigated. Segregation was more clearly observed for lower solution concentrations and higher temperatures. The temperature of 500 °C was found optimum where separated islands form. At higher temperatures, the coagulation and burial of silver islands occur. Scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and diffused reflectance spectroscopy (DRS) were... 

H2S and CO2 are the main impurities in raw natural gas, which needs to be purified before use. However, the comprehensive utilization of H2S and CO2 has been ignored. Herein, we proposed a fully resource-based method to convert toxic gas H2S and greenhouse gas CO2 synchronously into CO and elemental S by using a novel electrochemical reactor. The special designs include that, in the anodic chamber, H2S was oxidized rapidly to S based on the I−/I3− cyclic redox system to avoid anode passivation. On the other hand, in the cathodic chamber, CO2 was rapidly and selectively reduced to CO based on a porous carbon gas diffusion electrode (GDE) modified with polytetrafluoroethylene and cobalt...