Loading...
Search for: 65-nm-cmos-technologies
0.008 seconds

    A fully linear 5.2 GHz - 5.8 GHz digitally controlled oscillator in 65-nm CMOS technology

    , Article Microelectronics Journal ; Volume 90 , 2019 , Pages 48-57 ; 00262692 (ISSN) Heydarzadeh, S ; Torkzadeh, P ; Sadughi, S ; Sharif University of Technology
    Elsevier Ltd  2019
    Abstract
    A low-power fully linear integrated CMOS LC-based Digitally Controlled Oscillator is presented. The DCO operates in 5.2 GHz to 5.8 GHz range for using in IEEE 802.11a wireless applications. The system has been designed using 65 nm CMOS technology and 1.2 V supply voltage. By applying a proposed filter in DCO architecture −133.41 dBc/Hz phase noise at 1 MHz offset frequency from the fundamental carrier is achieved. The code generator and digital to analog converter designed to provide the high precision voltage required for fine-tuning. The output frequency swept through 10 control bits with 100 KHz resolution. The measured RMS jitter (∑ [1 KHz – 2 GHz]) from 5.8 GHz carrier is 1.65 fs. The... 

    A 7 bit, 3 GHz bandwidth random-time-interleaved-hybrid DAC using a novel self-healing structure for DCE in 65 nm CMOS technology

    , Article AEU - International Journal of Electronics and Communications ; Volume 134 , 2021 ; 14348411 (ISSN) Sariri, H ; Torkzadeh, P ; Sadughi, S ; Sharif University of Technology
    Elsevier GmbH  2021
    Abstract
    The application of time-interleaved structure leads to new amplitude and time errors while reducing many static and dynamic errors. In this case, both amplitude and time error are decreased by circuit structures integrated into a 7-bit DAC. In the present study, a new structure was proposed based on the randomization of two-interleaved paths in order to reduce the amplitude error, which can be extended to the N-channels-interleaved. In order to reduce the cycle-duty-error, a self-correction structure based on calculating the amplitude of the error before and measuring the time of this error along with the passage of the main signal through the output multiplexer is provided. The advantage of... 

    A 70 pJ/b configurable 64-QAM soft MIMO detector

    , Article Integration ; Volume 63 , 2018 , Pages 74-86 ; 01679260 (ISSN) Shabany, M ; Patel, D ; Milicevic, M ; Mahdavi, M ; Gulak, P. G ; Sharif University of Technology
    Elsevier B.V  2018
    Abstract
    An area and power efficient high-throughput VLSI implementation of a 4 × 4, 64-QAM soft multiple-input-multiple-output (MIMO) detector, that is suitable for high-order constellation schemes is presented. The proposed MIMO detector utilizes information contained in the discarded paths to improve the bit-error-rate (BER) performance, and then reduces computational complexity using three innovative improvement ideas. The proposed design is fabricated and fully tested in a 130 nm CMOS technology. Operating with a 270 MHz clock, the design achieves up to 655 Mbps throughput with 195 mW power dissipation at 1.32 V supply. Synthesis results in 65 nm CMOS technology shows that the proposed...