Sharif Digital Repository

Test driven software development is one of the most important practices in agile software production. In this practice, the programmer must write appropriate test cases before implementing the desired program. That is, at first, he should know what the function of his desired program is, and then considering them, the test cases are implemented. The problem with this method is that the programmer may not have much experience in this work, and good test cases may not be produced, and at the same time, this work is very time-consuming. As a result, this method may be abandoned.In this thesis, an attempt is made to provide a systematic method to make the production of test cases for the program... 

Oil reservoir simulation serves an important role in forecasting oil production. This forecast, in turn, helps to devise a production scheme for hydrocarbon reservoirs which is one of main objectives of reservoir management team. In this research, using the idea of logarithmic distribution of reservoir fluid pressure around a wellbore, a new method for simulation of naturally fractured reservoir is developed. This method is shown to be more fast and accurate than conventional methods in reservoir simulation. In this method Dual-Porosity formulation is used for description of fluid flow in fractured reservoirs. The governing equations then were discretized by Galerkin Finite element method in... 

From previous years, water injection was considered as one of the most common methods for enhanced oil recovery. But recently much attention has been paid on the use of low salinity water (LSW) as an enhanced oil recovery fluid. The main mechanism that causes improve oil recovery is wettability alteration to a more water wet state. The change observed in recovery factor during LSW flooding induced from changes in relative permeability and capillary pressure when different levels of salinity are used. However, a few researchers tried to evaluate how macroscopic flow functions depend on the salinity of injected water. To this end, a series oil displacements by water performed on sandstone rock... 

Studies show that Pedestrians are at fault in 59% of the vehicle-pedestrian accidents. The traffic crash statistics show the importance of understanding factors of pedestrian errors. If pedestrians terminate their waiting behavior during the red light period and cross the street, they would put themselves in danger. Pedestrians’ red-light violation is a type of highly dangerous behavior occurring at intersections. A total of 1130 pedestrians approaching the intersections during red light periods were observed from the videotapes data collected at 6 intersections in Tehran, Iran. Pedestrian crossing behaviors are classified into immediate crossing behavior and waiting behavior. A logit model... 

Among the xenobiotic compounds, chlorophenols are considered to be as the most dangerous compounds for the environment and living organisms. These compounds are abundantly found in the wastewater of many chemical industry factories. In this research, by using Gaussian software and density functional theory at the level of B3LYP / 6-31G (d, p),the adsorption of molecules such as phenol, 2-chlorophenol, 4-chlorophenol and 2,4-dichlorophenol over graphene, nitrogen and boron doped graphene sheet are studied. The most stable configurations were determined and adsorption energies were calculated. In addition, to understand the adsorption mechanism, electron properties such as state density and... 

Particuale matters, as a criterion for evaluationg the air quality, have been one of the most important air pollutants through the last decade. Considering the adverse health effects of particulate matters, the importance of monitoring pollutant’s concentration is inevitable. While there are monitoring stations for evaluating the air quality, our knowledge is so limtted since there are few stations working, so there is a spatial and temporal gap. On the other hand, chemical transport models and remote sensing provide us a better chance to track the air quality thoroughly. Since chemical transport models are our only way of filling the gaps, they should be rigorous and accurate. In this study... 

Multicore platforms prepare a great opportunity to implement fault-tolerance techniques. Task replication is a well-established technique to obtain high reliability against transient faults. However, replicated executions can increase power consumption more than Thermal Design Power (TDP) constraint. TDP is considered as the highest sustainable power that a chip can dissipate before being forced to exploit a performance throttling mechanism, e.g. Dynamic Thermal Management (DTM). If the chip violates its TDP constraint, it automatically restarts or significantly reduces its performance to prevent a permanent damage. Therefore, due to the unwanted system restarts, DTM techniques may not be...