Sharif Digital Repository

In this paper, a distributed secondary power sharing approach with low bandwidth communication network is proposed for low voltage direct current (LVDC) microgrids. Conventional droop control causes voltage drop in the grid and also a mismatch on the current of converters in the case of consideration of the line resistances. Proposed control system carry out the current value of the other converters to reach the accurate current sharing and suitable voltage regulation as well. Voltage and current controllers locally regulate the voltage and current of converters as a secondary controller. Secondary controller is realized locally and the communication network is only used to transfer the data... 

In this paper a novel droop approach for power management in low voltage dc MicroGrids (MGs) based on a master-slave concept is presented. A virtual frequency is injected by a master unit, which is proportional to its output power. Other slave units determine their output power according to the corresponding frequency based droop characteristics. Unlike the dc voltage-droop methods, the proposed virtual frequency-droop approach can be smartly applied for proportional power management among the energy units and loads as well as adding zero net energy capability to the MG. Both power flow and energy flow can be performed without utilizing an extra communication system. Simulation results... 

Waves encountering can cause significant ship motions and affect the photovoltaic power generation capacity in All-Electric Ships (AES) during extreme conditions. In this paper, a comprehensive strategy is proposed to examine the impact of modern vessels' movements on the PV system output and the ship power quality during various operating scenarios. The proposed theoretical model-based technique determines ship angles in a wave collision and assesses sun-related angles concerning the vessel motions. Based on the panel angles, the solar irradiance and the PV system power variations can be derived. The developed method can simultaneously evaluate the effect of ship motions on the photovoltaic... 

The increasing use of power electronic equipment and the importance of their continuous and correct operation have attracted remarkable attention to the condition monitoring of power electronic converters. Since capacitors are the leading cause of power electronic converters failure, this paper attempts to attain a solution to monitor the condition of the DC-link capacitor in a three-phase back-to-back converter using the stimulated measurable transients. The proposed method works based on the temporary change of switching logic and the measurement of the DC-link voltage and converter input phase current transients. By processing the measured signals, the capacitance of the capacitor is... 

Voltage unbalance and short circuits in distribution networks adversely affect the performance of grid-tied voltage source inverters (VSIs). Consequently, the dc-link voltage ripple may significantly increase leading to operation of VSI in an unsatisfactory manner. Conventionally in order to maintain the negative sequence current under unbalanced conditions, low-pass/trap filter in the current control loop are required which significantly reduce the controller bandwidth. In order to minimize the dc-link voltage ripple without impairing the controller bandwidth, this paper investigates the design and performance of Proportional-Integral-Resonant (PIR) controller in improving the performance... 

DC-link voltage and output current control loops are two cascaded loops in the control structure of grid-connected inverters. A high DC-link voltage loop bandwidth (DCL-BW) provides more disturbance rejection capability for the control loop and is preferred from control system perspective. However, for stability issues, this BW is limited and must be sufficiently less than that of the current control loop. Among the different control schemes, instantaneous active reactive control (IARC) method provides the highest possible DCL-BW (i.e., 0.02 × switching frequency). Having this degree of freedom in the controller design, a proper methodology should be defined for selection of DCL-BW. In this... 

This paper proposes a new control scheme to eliminate the 3rd harmonic in the output currents of grid-following inverters under unbalanced grid conditions. Unbalanced grids adversely affect the performance of grid-following inverters due to the oscillations appearing on the DC-link voltage with a frequency twice the line frequency. The paper is based on instantaneous active reactive control (IARC) technique due to its advantages over other existing methods. However, the presence of severe asymmetrical 3rd harmonic distortions in the inverter output currents is the main challenge with IARC method, which impairs the power quality requirements. This paper enhances the IARC scheme by proposing a... 

Because of the advances in power electronics, DC-based power systems, have been used in industrial applications such as data centers [. 18], space applications [. 10], aircraft [. 12], offshore wind farms, electric vehicles [. 56], DC home systems [. 5, 20], and high-voltage DC transmission systems. To provide such sensitive loads with more reliability, efficiency, and controllability for future power systems, AC microgrid and more recently DC microgrid and smart-grid technologies have been employed [. 5-9].To obtain stable and optimal operation in DC power systems (microgrids), proper load sharing among different energy units and acceptable voltage regulation across the microgrid is... 

In this paper a novel droop approach for autonomous power management in low voltage dc microgrids based on a master-slave concept is presented. Conventional voltage-based droop approaches suffer from poor power sharing due to line resistance effects on a virtual resistance, which is solved a by introducing a communication system to increase the current sharing accuracy. In this paper, a virtual frequency is superimposed by the master units, and slave units determine their output power according to the corresponding frequency-based droop characteristics. Unlike the voltage-droop methods, the proposed virtual frequency-droop approach can be applied for proportional power management among the... 

In this paper, a novel droop approach for autonomous power management in low voltage DC (LVDC) microgrids based on a master-slave concept is presented. Conventional voltage-based droop approaches suffer from poor power sharing due to line resistance effects on a virtual resistance, which is solved by introducing a communication system to increase the current sharing accuracy. In this paper, a virtual frequency is superimposed by the master units, and slave units determine their output power according to the corresponding frequency-based droop characteristics. Unlike the voltage-droop methods, the proposed virtual frequency-droop approach can be applied for proportional power management among... 

Applying conventional dc-voltage-based droop approaches for hybrid ac/dc microgrids interconnected by a single interlinking converter (IC) can properly manage the power flow among ac and dc subgrids. However, due to the effect of line resistances, these approaches may create a circulating power as well as overstressing the ICs in the case of employing multiple ICs for interconnecting the ac and dc subgrids. This paper proposes an autonomous power sharing approach for hybrid microgrids interconnected through multiple ICs by introducing a superimposed frequency in the dc subgrid. Hence, a suitable droop approach is presented to manage the power among the dc and ac sources as well as ICs. The... 

Conventional droop methods for load sharing control in low-voltage direct current microgrids suffer from poor power sharing and voltage regulation, especially in the case when operating many dc sources with long feeders. Hence, the communication-based approaches are employed to improve the load sharing accuracy and voltage regulation. To avoid using such an infrastructure and the corresponding effects on the reliability and stability, an adaptive droop controller based on a superimposed frequency is proposed in this paper. Load sharing accuracy is improved by adapting the droop gains utilizing an introduced ac power. The secondary controller locally estimates and compensates the voltage drop... 

This article explores the impacts of non-exponentially distributed failures on reliability of microgrids. Failure rate of some components such as power electronic converters is not constant, while they play a major role in microgrids. Consequently, their failure characteristics will affect the microgrid reliability. Hence, the conventional reliability evaluation approaches based on mean time to failure may introduce inaccurate inputs for decision making in planning and operation of microgrids. In this article, different approaches are employed for evaluating the reliability of microgrids with non-constant failure rates. The obtained results indicate that the system reliability remarkably... 

This paper proposes a model-based design approach for microgrids considering the aging of power electronic devices under different operating conditions. The proposed approach takes into account the physics of failure mechanisms in converter components as the failure prone devices in power systems. Furthermore, it considers the impacts of load profile on the aging of converter components and system performance. This approach facilitates accurate and optimized design of power electronic-based microgrids. According to this approach fragile links of power converters for a specified application can be identified. Moreover, the weakest converters based on their function in the microgrid can be... 

Distribution system reconfiguration is an effective solution to reduce the consequences of a disaster through transferring loads to another feeder via automatic switches. Meanwhile, an optimal sequence of damage components repairments provides the operator with the opportunity to utilize components that play a critical role in restoring loads sooner. Motivated by the rise in penetration of renewable distributed generators in modern distribution systems, this paper aims to develop a robust reconfiguration and crew routing co-optimization method to cope with renewable and demand uncertainties while recovering from a disaster. The method optimizes the grid recovery process for the worst... 

Sub-harmonic stability issues due to the interaction between a load-commutated motor drive and a synchronous turbo-generator train in a Liquefied Natural Gas (LNG) station are studied in this paper. The sub-harmonic current injected by motor drives may excite the mechanical torsional modes of turbogenerator train. In this paper, the electro-mechanical interaction phenomenon is investigated and an active damper is proposed to absorb the sub-harmonic currents of motor drives and increase the damping of the electro-mechanical system. Simulations and experiments validate the instability problem and effectiveness of the proposed solution. © 2018 EPE Association  

Power sharing control among grid forming dc sources employing a conventional voltage droop approach meets inaccurate load sharing and unacceptable voltage regulation performance. Thereby, communication-based secondary and supervisory controllers have been presented to overcome the aforementioned issues. Furthermore, with the aim of eliminating communication system, frequency-based droop approaches have been introduced for low-voltage dc grids where the frequency of the superimposed ac signal onto the dc voltage is proportional to the output power. However, in reality, dc grid structures can be applied to medium and high voltage applications with different X/R ratios. This paper generalizes... 

In this paper, we propose a new derivative-free preconditioned conjugate gradient method in order for solving large-scale square and under-determined nonlinear systems of equations. The proposed method is also equipped with a relaxed nonmonotone line search technique. Under some suitable assumptions, the global convergence property is established. Numerical results on some square and under-determined test systems show the efficiency and effectiveness of the new method in practice. An application of the new method for solving nonlinear integro-differential equations is also provided. © 2016 Elsevier Ltd