Sharif Digital Repository

Microalgae as a candidate for production of biodiesel, possesses a hard cell wall that prevents intracellular lipids leaving out from the cells. Direct or in situ supercritical transesterification has the potential for destruction of microalgae hard cell wall and conversion of extracted lipids to biodiesel that consequently reduces the total energy consumption. Response surface methodology combined with central composite design was applied to investigate process parameters including: Temperature, Time, Methanol-to-dry algae, Hexane-to-dry algae, and Moisture content. Thirty-two experiments were designed and performed in a batch reactor, and biodiesel efficiency between 0.44% and 99.32% was... 

The analysis of the capture zone of wells is useful to design pumping systems and wellhead protection programs. In this study, an analytical solution for the head distribution of a partially penetrating well, and semi-analytical methods to determine the geometry of the capture surface are presented. The analytical solution is derived based on an infinitesimal radius under a constant pumping rate in a two-zone confined aquifer. Using the developed solution, a sensitivity analysis is performed to study the influence of skin on the drawdown, location of the stagnation point, maximum horizontal and vertical extent of the capture surface. The results show the efficiency of a partially penetrating... 

As a means to relieve traffic congestion, toll pricing has recently received significant attention by transportation planners. Inappropriate use of transportation networks is one of the major causes of network congestion. Toll pricing is a method of traffic management in which traffic flow is guided to proper time and path in order to reduce the total delay in the network. This article investigates a method for solving the minimum toll revenue problem in real and large-scale transportation networks. The objective of this problem is to find link tolls that simultaneously cause users to efficiently use the transportation network and to minimize the total toll revenues to be collected. Although... 

Congestion toll pricing is an inexpensive management way to mitigate the traffic congestion and reduce the delay in the network. One of the models that were proposed for toll pricing is the minimum toll revenue (MinRev) problem. The objective of this model is to find link-tolls that simultaneously cause users to efficiently use the network and to minimize the total toll revenues to be collected. Although it can be written as a linear model, when applied to road networks in practice, this model is difficult to be solved optimally in a reasonable time, due to its large size. This paper proposes a method to approximately estimate the minimal revenue tolls in large-scale roadway networks. The... 

Biofiltration of Triethylamine (TEA) vapor used as a catalyst in casting operations was evaluated in this study The unit consisted of a 6-L three-stage biofilter containing a mixture of compost and wood chips (40:60 v/v) as the filter medium. Seed microbial population from municipal activated sludge was acclimated for a period of three weeks prior to the actual experimental runs. In the startup period, high pH values up to 10 was observed due to alkaline nature of TEA and inadequate formation of biofilm and low overall biodegradation. Steady increase of organic-N concentration along with gradual upward trend of pressure drop indicated sound establishment of microbial population. Operational... 

A probabilistic formulation for semantic image annotation and retrieval is proposed. Annotation and retrieval are posed as classification problems where each class is defined as the group of database images labeled with a common semantic label. It is shown that, by establishing this one-to-one correspondence between semantic labels and semantic classes, a minimum probability of error annotation and retrieval are feasible with algorithms that are 1) conceptually simple and 2) computationally efficient. In this article, a content-based image retrieval and annotation architecture is proposed. Its attitude is decreasing the semantic gap by partitioning the image to its semantic regions and using... 

Fluid flow in porous media is affected by surface characteristics such as roughness and topography. In this work, to simulate the surface of natural porous structures in transparent interconnected media like micromodels, various degrees of roughness have been artificially created on flat glass substrates via different methods of laser ablation, cream etching, combination of laser ablation and cream etching, and hydrofluoric acid (HF) etching. The obtained surfaces by each method were characterized in detail via field emission scanning electron microscopy (FESEM), atomic force microscopy (AFM), energy-dispersive X-ray spectroscopy (EDX/EDS), and surface profilometry. The impact of high... 

Conductive self -electrical stimuli bioactive scaffolds could be used the potential for peripheral nerve regeneration with the maximum efficiency. To produce such conductive self-electrical stimuli bioactive scaffolds, chopped spun piezoelectric nanofibers of polyvinylidene fluoride/mesoporous silica nanoparticle (PVDF/MCM41) are prepared and incorporated in gellan/polyaniline/graphene (gellan/PAG) nanocomposites which have been previously prepared by incorporation of polyaniline/graphene (PAG) nanoparticles in gellan gel at 80 °C. Highly conductive binary doped polyaniline/graphene nanoparticles are prepared by chemical oxidative polymerization of aniline monomer using in-suite... 

In this paper, the tip tracking control problem of a Timoshenko micro-cantilever beam is investigated. The beam is actuated by a piezoelectric layer laminated on one side of the beam. Dynamic equations of the beam and piezoelectric layer are found using the Hamilton principle. By employing the Galerkin projection method, state space representation of the system is derived. Then, a cascade control loop is used for tracking control of the beam's tip. The cascade control structure consists of an inner loop stabilizer and an outer loop proportional-integral-derivative controller. The stabilizer has a linear feedback form whose states are obtained through a linear observer which is based on the... 

In this paper, the tip tracking control problem of a Timoshenko micro-cantilever beam is investigated. The beam is actuated by a piezoelectric layer laminated on one side of the beam. Dynamic equations of the beam and piezoelectric layer are found using the Hamilton principle. By employing the Galerkin projection method, state space representation of the system is derived. Then, a cascade control loop is used for tracking control of the beam's tip. The cascade control structure consists of an inner loop stabilizer and an outer loop proportional-integral-derivative controller. The stabilizer has a linear feedback form whose states are obtained through a linear observer which is based on the... 

In this study, a laboratory-scale biotrickling filter (BTF) is used to remove Triethylamine (TEA) from gaseous wastes. The BTF is made of stainless steel with a height of 210 cm and an internal diameter of 21 cm packed with lava rocks. TEA elimination pattern was evaluated by changing empty bed residence times (EBRTs). The maximum elimination capacity (EC) has been determined to be 87 g/m3/h. At all EBRTs 52, 31, 20, and 10 s, contaminant transferring from gas phase to liquid was more than the EC. Also, the removal efficiency was 100 % for a mass loading of 100 g/m3/h. While the liquid recirculation velocity of 3.466 m3/m2/h was maintained, the flow rate was adjusted to 60, 100, 156, and 312... 

Acid-oil emulsion and sludge formation are known as two major formation damage mechanisms and the reason for failure of some acid treatments. The published studies in this area focus primarily on core- to well/reservoir-scale and it is fairly unclear how acid-oil interaction at the pore-scale leads to the formation damage observed at the macro- or core-scale. In this paper, dynamic, micro-scale experiments were designed and executed to investigate the acid-induced formation damage using microfluidic approach. In addition, a series of so-called static (microscope) tests were performed in which acid-crude oil compatibility tests were conducted on a glass slide followed by microscopic... 

In this paper, particle swarm optimization (PSO) is applied to synchronize chaotic systems in presence of parameter uncertainties and measurement noise. Particle swarm optimization is an evolutionary algorithm which is introduced by Kennedy and Eberhart. This algorithm is inspired by birds flocking. Optimization algorithms can be applied to control by defining an appropriate cost function that guarantees stability of system. In presence of environment noise and parameter uncertainty, robustness plays a crucial role in succeed of controller. Since PSO needs only rudimentary information about the system, it can be a suitable algorithm for this case. Simulation results confirm that the proposed... 

In this paper, a robust control design strategy is introduced to synchronize two different chaotic systems. The controller is based on particle swarm optimization (PSO). Particle swarm optimization is a well-known evolutionary optimization algorithm inspired by organism behavior of birds flocking and fish schooling. Our control approach is based on defining a suitable cost function in such a way that minimizing it guarantees the control of system. Due to the nature of PSO algorithm, the designed controller is strongly robust. It is shown that the proposed controller can overcome the parameter uncertainty without any extra information about the system. Comparison of proposed method with... 

Conductive self -electrical stimuli bioactive scaffolds could be used the potential for peripheral nerve regeneration with the maximum efficiency. To produce such conductive self-electrical stimuli bioactive scaffolds, chopped spun piezoelectric nanofibers of polyvinylidene fluoride/mesoporous silica nanoparticle (PVDF/MCM41) are prepared and incorporated in gellan/polyaniline/graphene (gellan/PAG) nanocomposites which have been previously prepared by incorporation of polyaniline/graphene (PAG) nanoparticles in gellan gel at 80 °C. Highly conductive binary doped polyaniline/graphene nanoparticles are prepared by chemical oxidative polymerization of aniline monomer using in-suite... 

The aim of the present study was to evaluate the photocatalytic degradation of anthracene using Fe-doped TiO2 nanoparticles in the presence of UV. The structure and morphology of Fe-doped TiO2 nanoparticles were studied by X-ray diffraction, scanning electron microscopy, and energy-dispersive X-ray spectroscopy. The applied nanoparticles were synthesized by the sol–gel method. The effect of influential parameters on the degradation of anthracene, including pH, time, nanopar-ticles dosage, and the concentration of anthracene was studied. Using the UV/Fe-doped TiO2 system, the optimum experimental values were obtained to be as follows: pH = 7, contact time = 60 min, anthracene concentration =... 

Acidizing is widely used to remove near-wellbore damage and enhance the inflow performance of the reservoir to boost the well oil production rate. However, when the injected acid exposes to reservoir oil, either asphaltic sludge or emulsion forms as acid-induced damages. Therefore, laboratory compatibility tests are required before every acidizing job to determine both the acid sensitivity of oil samples and the optimal dosage of chemical inhibitors that should be used to prevent sludge and emulsion formation. The lack of knowledge to predict the risk of asphaltic sludge and emulsion damages for different oil and acid systems necessitates expensive and time-consuming compatibility tests...