Sharif Digital Repository

A new architecture for constant-gm rail-to-rail(R-R) input stages is presented that has less than 5% deviation in gm over the entire range of the input common-mode voltage. Furthermore, a new structure for folded cascode amplifier based on the use of a floating current source is presented. Employing these techniques a low-power operational transconductance amplifier(OTA) with 100MHz unity-gain bandwidth, 106dB gain, 60° phase margin, 2.65V swing, and 6.4nVA/√Hz input-referred noise with R-R input common-mode range is realized in a 0.8μm CMOS technology. This amplifier dissipates 10mW from a 3V power supply  

In this study, a hybrid of silica nanosphere/multiwall carbon nanotube (MWCNT) has been synthesized by wet chemical method at room temperature. The effect of MWCNTs, silica nanospheres and hybrid nanostructures (80% silica nanosphere/20% MWCNT and 50% silica nanosphere/50% MWCNT) on the thermal conductivity of distilled water has been investigated. SDBS was used as the dispersant to stabilize nanomaterials in the aqueous suspension and its concentration was 1.5 times of the concentration of nanomaterials. As results show, by increasing the concentration of nanomaterials, effective thermal conductivity of nanofluids increased. The most and the least enhancement in the effective thermal... 

Forced convective of water in horizontal tubes with conical tube inserts has been studied experimentally. The transient flow regime has been used for the tests. Experimental results are validated with existing well established correlation. The turbulators were placed in two different arrangements: converging conical ring, referred to as CR array and diverging conical ring, DR array. Two correlations for the Nusselt number based on the experiment are introduced for practical use. It is found that the insertion of turbulators has enhanced the Nusselt number for the DR arrangement up to 521%, and for the CR arrangement up to 355%, although using the turbulators cause a significant increase in... 

This study deals with an experimental investigation on the thermal performance of a mechanical wet cooling tower with counter flow arrangement by using multi-walled carbon nanotubes (MWNTs) and nanoporous graphene nanofluids. Stable nanofluids were prepared through two-step procedure by using water with properties taken from a working cooling tower in the South of Iran. Zeta potential revealed suitable stability of MWNTs and nanoporous graphene nanofluids. Thermal and rheological properties of the nanofluids were investigated. It was found that thermal conductivity increases by 20% and 16% at 45°C for MWNTs and nanoporous graphene nanofluids, respectively. The increase in density and... 

Coaxial electrospinning with the ability to use simultaneously two separate solvents provides a promising strategy for drug delivery. Nevertheless, controlled release of hydrophilic and sensitive therapeutics from slow biodegradable polymers is still challenging. To address this gap, we fabricated core-sheath fibers for dual delivery of lysozyme, as a model protein, and phenytoin sodium as a small therapeutic molecule. The sheath was processed by a gelatin solution while the core fibers were fabricated from an aqueous gelatin/PVA solution. Microstructural studies by transmission and scanning electron microscopy reveal the formation of homogeneous core-sheath nanofibers with an outer and... 

In this paper, a fourth-order, 3.5-MHz, low-pass elliptic Gm-C filter employing low-noise, low-voltage transconductance amplifiers is presented. A new technique to enhance the linearity of the Gm-C filter is proposed. Furthermore, the nonlinear behavior of the filter caused by nonlinear behavior of transconductors with determined input amplitude is discussed. HSpice simulation results of the 1.8-V filter in a 0.18μm CMOS process show a THD of less than 44dB for 0.6Vpp input signal and an input-referred noise of less than 45 nV/√Hz in worst case. The current consumption of each OTA is 1.5-mA. © 2006 IEEE  

An ultra-low-voltage low-power high-speed class-AB operational amplifier with a new structure is presented. A new technique called "Slew Boost" is introduced to improve amplifier's large-signal settling behavior, most useful in switched-capacitor circuits such as pipelined ADCs, sigma delta modulators, etc. The proposed op-amp has been designed to be employed in the first stage of a 10bit 150MSamples/sec pipelined analog-to-digital converter. Simulation results of the proposed fully-differential class-AB op-amp using 0.18um CMOS process models, confirm that it has an output swing of 1.5 Vp-p and consumes less than 1mW from a single supply of 1 volt  

An ultra-low-voltage low-power high-speed class-AB operational amplifier with a new structure is presented. A new technique called 'Slew Boost' is introduced to improve amplifier's large-signal settling behavior, most useful in switched-capacitor circuits such as pipelined ADCs, sigma delta modulators, etc. The proposed op-amp has been designed to be employed in the first stage of a 10 bit 150 MSamples/sec pipelined analog-to-digital converter. Simulation results of the proposed fully-differential class-AB op-amp, using 0.18 μm CMOS process models, confirm that it has an output swing of 1.5 Vp-p and consumes less than I mW from a single supply of I volt. © 2003 ACM