Sharif Digital Repository

TiO2, transition metal (Cr, Mn, Fe, Co, Ni, Cu, and Zn)- and aluminum-doped TiO2 nanoparticles were prepared by the sol-gel technique. The sulfated catalysts were prepared by the impregnation method with H2SO4 solution. The catalysts were characterised by X-ray diffraction (XRD), BET surface area measurement, diffuse reflectance spectroscopy (DRS), and Fourier transform infrared (FTIR) techniques. The sulfate content of the metal-incorporated samples was considerably higher than for SO4 2-/TiO2. The metal doping brought about a considerable reduction in the extent of sulfate loss from the catalyst surface due to the wide dispersion on the surface. The SO4 2-/TiO2 and SO4 2-/M/TiO2... 

Electric field enhanced approach has been used to synthesize different copper hydroxide morphologies as high-performance supercapacitors electrode materials. Employing this efficient, simple and low cost method, various shapes such as rod, flower and cube with an average grain size of 30nm to 1μm were obtained on the copper substrate. The results revealed that applied electric field considerably accelerates the formation time of nanostructures from several days to close to 1min, where some of the desired nanostructures were obtained even in 1s. The electrochemical properties of different morphologies were compared using cyclic voltammograms and charge/discharge tests and electrochemical... 

Global warming and other adverse environmental effects of fossil fuels have forced humans to consider clean and renewable energy resources. In this context, hydrogen production from water splitting reaction is a key approach. In order to reduce required overpotential for water oxidation reaction, it is necessary to use low cost and earth abundant electrocatalysts like Co, Cu, Fe, Mn, Ni and Zn nanostructures. Herein, cobalt nanostructures on steel-mesh substrate were applied. Electrochemical method was used for growth of Co nanoflakes because of its simplicity and scalability for commercial approach. On the other hand, using carbonaceous support layers including nanomaterials such as... 

In this paper, an approach for topology control has been proposed which make use of distance estimation and angle of arrival (AoA) estimation techniques. Every node in the network tries to keep the number of its neighbors to 4 or 3. These neighbors have been selected from the nearest neighbors of each node and are located in different four quarters of axis. The angular difference between these neighbors is between a minimum and maximum value. This protocol guarantees connectivity on the communication graph with high probability and enforces symmetry on the resulting communication graph, thereby easing the operation of higher level protocols. The performance of the protocol when nodes are... 

Herein, the effect of electrodeposition time on the super-capacitive performance of three-dimensional (3D) MnO2/g-C3N4 heterostructured electrodes was investigated. MnO2 nanoparticles were electrodeposited on the g-C3N4 nanosheets drop-casted on the Ni foam substrate. The microstructural analysis, carried out by FE-SEM and TEM, confirmed the homogeneous distribution of MnO2 nanoparticles on g-C3N4 nano-sheet layers. The electrochemical capacitive performances of the MnO2/g-C3N4 electrodes were evaluated by cyclic voltammetry (CV), galvanostatic charge/discharge tests, and electrochemical impedance spectra (EIS). The obtained results suggested that the supercapacitor (SC) performance of all... 

TiO2 nanoparticles supported on activated carbon (AC) and multiwalled carbon nanotubes (MWCNTs) were prepared by the sol-gel method using ultrasonic irradiation. All the prepared samples were calcined at different temperatures and characterized by X-ray diffraction, nitrogen adsorption/desorption isotherms, scanning electron microscopy, transmission electron microscopy and diffuse reflectance spectroscopy. The effects of size and type of carbon on the morphology and photocatalytic activity of the resulting hybrid materials were investigated. The results showed that a decrease in the size of the carbon led to a decrease in size of TiO2 nanoparticles. Both AC and MWCNTs retarded the... 

Here, SnO2 nanoribbons (NRs) synthetized on the catalyst-free stainless steel (SS) substrate as a possible anode for Li-ion batteries (LIBs) have been reported. SnO2 NRs were synthesized on catalyst-free SS substrate via vapor-solid (VS) growth approach. Morphological and structural characterizations of the SnO2 NRs were confirmed using scanning electron microscopy (SEM), transmission electron microscopy (TEM) microscopes and x-ray diffraction (XRD) respectively. The prepared binder-free electrode demonstrated high initial discharge/charge capacities of 1818/929 mAh g-1 at current density of 300 mA g-1. A reversible capacity of 676 mAh g-1 with a coulombic efficiency of 98.5% has been... 

We have implemented three approaches to describe the thermodynamic properties of ferrimagnetic (S=52, s=2) spin chains. The application of cumulant expansion has been generalized to the ferrimagnetic chain in the presence of an external magnetic field. Using cumulants, we have obtained the field-dependent effective Hamiltonian in terms of the classical variables up to the second order of quantum corrections. Thermodynamic functions, the internal energy, the specific heat, and the magnetic susceptibility are obtained from the effective Hamiltonian. We have also examined the modified spin-wave theory to derive the same physical properties. Finally, we have studied our model using quantum Monte... 

A new magnetic quaternary photocatalyst, K4Nb6O17/α-Fe2O3/Fe3N/g-C3N4, was synthesized via a simple one-step thermal pyrolysis process. The prepared photocatalyst was well characterized, and its photocatalytic activity was evaluated towards acetamiprid pesticide degradation, CO2 reduction reaction, and U87-MG cell eradication. The coexistence of four different crystalline structures in the prepared photocatalyst could simultaneously facilitate photoelectron transport and suppress charge recombination through their coupled heterogeneous interfaces. Because of the coexistence of various photosensitive compounds, the prepared photocatalyst showed the excellent capability to harvest the visible... 

In this study, the ozonation impact on anaerobic digestion of wasted thickened activated sludge of Tehran wastewater treatment plant has been investigated. Regarding that, the thickened activated sludge, a final solid waste of treatment plants, was subjected to ozonation pretreatment to evaluate its characteristics. Three major sludge characteristics were considered for investigating ozonation effects on anaerobic digestion. A comparison of two different ozone doses, i.e., 0.05 and 0.1 gO3 g−1TS was performed for short-term (10 days) and long-term (30 days) sludge retention times. Furthermore, biogas production, sludge composition, dewaterability, and energy balancing, were studied during... 

The main drawback of lithium-sulfur (Li-S) batteries which leads to a short lifetime, is the shuttle effect during the battery operation. One of the solutions to mitigate the shuttle effect is the utilization of interlayers. Herein, graphene oxide (GO) paper as an interlayer has been implemented between the sulfur cathode fabricated by the vapor deposition process as a binder-free electrode and a separator in a Li-S battery in order to gain a sufficient capacity. The morphological characteristics and electrochemical performance of the fabricated electrode have been investigated. The fabricated battery demonstrates an initial discharge capacity of 1265.46 mAh g-1 at the current density of 100... 

By combination of 1-ethyl-3-methyl immidazolium ethyl sulfate as a typical room temperature ionic liquid (IL) and graphene oxide (GO) nanosheets, a nanocomposite was introduced for improving the direct electrochemistry and electrocatalytic activity of glucose oxidase (GOx). The enzyme on the IL-GO-modified glassy carbon electrode exhibited a quasireversible cyclic voltammogram corresponding to the flavine adenine dinucleotide/FADH2 redox prosthetic group of GOx. At the scan rate of 100 mV s-1, the enzyme showed a peak-to-peak potential separation of 82 mV and the formal potential of -463 mV (vs Ag/AgCl in 0.1 M phosphate buffer solution, pH 7.0). The kinetic parameters of the charge transfer... 

Reduced graphene oxide (RGO) was used to improve the hydrogen sensing properties of Pd and Pt-decorated TiO2 nanoparticles by facile production routes. The TiO2 nanoparticles were synthesized by sol-gel method and coupled on GO sheets via a photoreduction process. The Pd or Pt nanoparticles were decorated on the TiO2/RGO hybrid structures by chemical reduction. X-ray photoelectron spectroscopy demonstrated that GO reduction is done by the TiO2 nanoparticles and Ti-C bonds are formed between the TiO2 and the RGO sheets as well. Gas sensing was studied with different concentrations of hydrogen ranging from 100 to 10,000 ppm at various temperatures. High sensitivity (92%) and fast response time... 

In this paper, we propose a new trust-region method for solving nonlinear systems of equalities and inequalities. The algorithm combines both standard and adaptive trust-region frameworks to construct the steps of the algorithm. The trust-region subproblem is solved in the first iteration using a given initial radius. Then, in each iteration, the standard trust-region method is followed whenever the current trial step is accepted, otherwise, the subproblem is resolved using an adaptive scheme. The convergence results for the new proposed algorithm are established under some mild and standard assumptions. Numerical results on some least-squares test problems show the efficiency and... 

Today, Li-ion batteries (LIBs) are the most common rechargeable batteries used in electronic devices. SnO2 with theoretical specific capacity of 782 mAh/g is among the best anode materials for LIBs. In this report, Threedimensional SnO2 nanowires (NWs) on carbon nanotube (CNT) thin film (SnO2 / CNT) is fabricated using a combination of vacuum filtration and thermal evaporation techniques. The resulting 3D heterostructure SnO2/CNT was characterized by X-ray diffraction, transmission electron microscopy (TEM) and scanning electron microscopy (SEM). This fabricated SnO2/CNT electrode has been tested as a flexible and binderfree anode for LIB, which exhibits high initial discharge/charge... 

Here, controlled growth of vertically aligned carbon nanotubes (VACNTs) on free-standing porous activated reduced graphene oxide (a-rGO) paper was fabricated using plasma-enhanced chemical vapor deposition method. The electrochemical performance of prepared film was investigated to provide effective electrode for 3D flexible high-performance lithium-ion batteries (LIBs) and supercapacitors. The results revealed that the prepared electrode exhibited a high specific capacitance of 347 F/g at 0.5 A/g in 1 M KOH electrolyte, 60% more than non-activated rGO-paper (218 F/g). The VACNTs on a-rGO have increased the accessible surface area and acted as efficient electrical conducting paths, which... 

The current paper reports the deposition of sulfur micro-particles using sulfur vapor deposition (SVD). Sulfur particles in size of 5 to 45 μm were deposited on a stainless steel substrate to be used as the cathode with porous structure in lithium sulfur (Li-S) batteries. Mass loading of about 0.5 mg cm-2 was obtained from this pure sulfur cathode. The structure of this binder-free cathode was characterized by field emission scanning electron microscopy (FESEM), x-ray spectroscopy (EDS), and x-ray diffraction (XRD). The electrochemical performance of the battery with two different organic liquid ether- and carbonate-based electrolytes was investigated and the results demonstrated that the... 

Solar energy generation is one of the most efficient approach to solve emerging environment and energy challenges. In this context, solar assisted dissociation of water into oxygen and hydrogen utilizing scalable and high performance electrocatalysts plays key role since the produced hydrogen is a clean energy carrier. Here, cobalt based nanoflakes with metallic core and oxidized surface were grown on the designed carbonaceous layer for anodic oxygen evolution reaction (OER) using an electrochemical approach. Carbonaceous layers containing proper amount of carbon nanotubes (CNT) and reduced graphene oxide (rGO) species were used to optimize the system. Although higher weight percent of rGO... 

Lithium-Sulfur (Li-S) batteries are considered as one of the promising candidates for next-generation Li batteries in near future. Although, these batteries are suffering from certain drawbacks such as rapid capacity fading during the charge and discharge process due to the dissolution of polysulfides. In this paper, Sulfur/metal oxide (TiO2 and SiO2) yolk-shell structures have been successfully synthesized and utilized to overcome this problem and improve the electrochemical performance of sulfur cahtode material. Prepared materials have been characterized using Scanning Electron Microscopy(SEM), Transmission Electron Microscopy(TEM) and X-ray diffraction (XRD) techniques. The results show... 

Enzymatic removal of Bisphenol A (BPA), acknowledged as an environmentally friendly approach, is a promising method to deal with hard degradable contaminants. However, the application of “enzymatic treatment” has been limited due to lower operational stability and practical difficulties associated with recovery and recycling. Enzyme immobilization is an innovative approach which circumvents these drawbacks. In this study, laccase from Trametes hirsuta was used for BPA removal. Amino-functionalized magnetic Fe3O4 nanoparticles were synthesized via the co-precipitation method followed by surface modification with (3-aminopropyl)trimethoxysilane (APTMS). The as-prepared nanoparticles were...